The only special features allowed are stress stiffening and large deflections.
仅仅应力刚化和大变形是被允许的特殊特征。
A close inspection, however, shows that many background galaxies are strangely magnified and distorted into long curving arcs by the gravitational lens deflections of the cluster.
但仔细观察会发现许多背景上的星系都由于该星群的引力透镜的偏斜而被扩大并扭曲成怪异的长条弧状曲线。
The calculated maximum deflections by both methods are equal…
文章最后给出了计算模板最大挠度的实用计算公式。
They observed the deflections of the particles by allowing them to fall on a fluorescent screen.
他们让粒子落在荧光屏上以观察他们的偏移。
The influences of the welding residual deflections and stresses on the plating vibration were discussed.
探讨了焊接残余变形、残余应力对船体板振动频率的影响。
There are deflections in varying degree between the experimental curve and the theoretical calculated curves.
实验曲线与两条理论曲线都有不同程度的偏差。
An increase in resistance to roll deflections may be gained by splitting the single strut into a fork at the top.
采用上部分呈叉状的单支杆可以增强抗滚转变形性能。
AIM: to evaluate the effects of 5 kinds of base materials on the stresses and deflections in amalgam restorations.
目的：观察5种基底材料对银汞合金修复体的应力水平和变形影响。
When the deflection is sufficiently large, its shape of deflection may be quite different from those of small deflections.
当挠度相当大时，其形状将变得与小挠度大相迥异。
Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections.
垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度，来承担足够的荷载。
So the deflections of concrete beams prestressed with bonded FRP tendons are expected to be larger than those of the steel bars cases.
国内外已有试验研究表明，有粘结预应力FRP筋混凝土梁的破坏模式包括界限破坏、受压破坏与受拉破坏三种。
According to P-Y Curves, difference-method is used to calculate the internal forces and deflections of laterally loaded pile in this paper.
本文根据P - Y曲线，应用差分法计算横向荷载桩的内力和位移。
The deflections and settlements of three-connected-arch tunnel tend to be stable and meet the requirements of the construction control values.
三联拱隧道段沉降、变形稳定，满足施工控制值的要求。
The results show that: the model constants and the measured deflections under the changing load are very close to the model theoretical values.
结果表明：模型常数以及在变载作用下的实测挠度值和模型的理论值有较高的拟合度。
This paper presents precise stiffness matrices for space trusses with large deflections, such as tall towers, guyed masts, and latticed columns, .
本文推导了高耸塔架、拉绳塔和缀条柱等空间桁架在大位移下的精确刚度矩阵。
The intact model and all fusion models were stressed with 10.6-Nm flexion and extension moments. The angular deflections were recorded in degrees.
这个多元化模型和所有被测试的腰椎融合模型都被施加10.6Nm大小的伸屈力矩，所偏转的角度以度为单位记录。
Steady response to zigzag motion with various shapes and frequencies, especially the maximum lateral deflections and accelerations, are calculated.
计算了对不同频率和不同波形的蛇行运动的稳态反应，特别是计算了侧向最大挠度和最大加速度。
Experimental results indicate that the cracks weaken the strength of slabs, lower their stiffness, and induce the deflections of slabs beyond limit.
试验结果表明，支座边的裂缝严重削弱了板的承载力，降低了楼板的刚度，导致楼板的挠度过大。
Therefore, the variability of axle deflections and their effects on the dynamic performance in the dynamic meshing of spiral bevel gears was studied.
因此，本文还研究了动态啮合过程中轴变形的变化规律，及其对螺旋锥齿轮动态啮合性能的影响。
This paper deals with different methods for determining the deflections of the vertical and some of its practical applications to engineering surveying.
本文论述了各种测定垂线偏差的方法及其在工程测量中的实际应用。
The effects of some parameters, such as the plate thickness, radius of the filled foundation, on the maximum deflections and stress, are also investigated.
最后研究了盖层厚度、填充半径对位移、应力的影响规律。
Force and PIV local flow measurements were conducted in a low speed wind tunnel to study the effectiveness of serrated Gurney flap at different deflections.
用低速风洞测力试验和襟翼处绕流的PIV测量试验研究锯齿形格尼襟翼在不同偏角下的增升效益。
This paper presents a new perturbation method of analysis to solve large deflections problems of plates and shells-Free-Parameter perturbation method (FPPM).
本文的主要目的是介绍一种求解轴对称板壳大挠度问题的新的正则摄动方法——自由参数摄动法。
The pace analyzes the current pre-arched calculation and installation method based on the relative deflections, and proposes a new absolute deflection method.
本文在对现行的基于相对挠度的预拱度计算设置方法进行分析后，进而提出了新的绝对挠度法。
Experimental results indicate that the cracks weaken the strength of slabs considerably, lower their stiffness and induce the deflections of slabs beyond limit.
试验结果表明，支座边的裂缝严重削弱了板的承载力，降低了楼板的刚度，导致楼板的挠度过大。
This paper gives a skill calculating deflections of frame beams by the method of combining written calculation with zooming and discusses some related problems.
本文提出了一个手、电算结合计算框架梁挠度的技巧，分析了采用这一方法的必要性及相关问题。
In this paper, a new method to measure meshing composite deflections of loaded cylindrical involute helical gear by using high precision clinometer is presented.
提出利用高精度测角仪测量齿轮副在啮合过程中不同啮合位置时轮齿受载综合变形的新方法。
In this paper, a new method to measure meshing composite deflections of loaded cylindrical involute helical gear by using high precision clinometer is presented.
提出利用高精度测角仪测量齿轮副在啮合过程中不同啮合位置时轮齿受载综合变形的新方法。
应用推荐