The counter deflection structure is a new-proposed steel structure especially suitable for that mainly subjected to bending load.
反挠结构是一种新近提出的钢结构，它特别适用于主要承受弯矩荷载的结构。
Structure deflection and inner force are analyzed by using the program for concrete shrinkage and creep.
利用该程序分析混凝土收缩徐变对结构变形和内力的影响。
This paper studied the relationship among bending moment, curve, deflection and concrete compression height by design principle for reinforced concrete structure.
从钢筋混凝土结构设计原理出发，分析截面弯矩、曲率、挠度、受压区高度之间的相互关系；
These experiments mainly aim at determining the deflection and stress of beam slab structure before and after reinforcement.
静载试验的内容是测定加固前后梁板结构的混凝土应力和挠度。
An optics method for measurement of beam section deflection of major bridge structure is put forward.
提出了一种大型桥梁结构截面挠度测量的光学方法。
The deflection equations of constrained buckling are derived in buckling of bar structure via point contact and line contact models.
针对受压限制失稳结构，利用点接触、线接触屈曲模型，建立了杆在各种屈曲模态下的挠度曲线方程。
The deflection and stress of the structure are linear with load under effect of live load. The superposition principle can be used.
活载作用下结构挠度、应力与荷载呈线性关系，叠加原理能够适用。
This paper introduces the site measurement for the heavy steel truss including the measurement scheme, pole stress, joints rigidity, structure deflection and other elements concerned.
介绍了该桁架的现场测试工作，包括测试方案、杆件应力、节点刚性、结构挠度等。
The limitations on surface's deflection and deflection rate are addressed to develop the variable structure reconfigurable flight control system.
同时考虑操纵面偏转角度饱和及偏转速率饱和对系统的影响，设计出一种变结构可重构飞行控制系统。
The results show that the deflection direction, maximum center deflection of the membrane and the effective change of the volume all rely on the structure parameters.
通过不同的结构设计可以控制驱动膜片结构的弯曲变形方向。
Based on the SDS-3 E-beam lithography machine, the electrostatic deflection of the folded plate structure was used instead of the electrostatic deflection of the plate.
以SDS - 3电子束曝光机为基础，用折板结构静电偏转替代直板结构静电偏转，探讨了电子束曝光机折板静电偏转场的电子轨迹与电位分布应满足的要求。
The deformation of frame-tube structure under the lateral load is constituted by both shear and bend deflections. The effect of shear lag must be considered for the bend deflection.
框筒结构在水平荷载作用下的变形由剪切变形和弯曲变形两部分组成，弯曲变形必须考虑正、负剪力滞的影响。
The scaled boundary element method is used to calculate the deflection of pavement structure under dynamic loads.
将比例边界元方法引入路面结构的动态响应求解，并与有限元方法进行对比分析。
Field investigation includes traffic volume, axle loads, types, amount, and severity of pavement distress, measurement of deflection of pavement highway structure, and pavement sampling.
路面调查工作包括交通量调查，轴载调查，路面损坏的类型、数量与严重程度的记录，路面结构的弯沉以及路面取样。
Because the reinforcing bar and surroundings concrete can have opposite slip in unbonded prestressed concrete, Lead to stress and deflection differing from bonded prestressed concrete structure.
由于无粘结预应力混凝土构件中预应力钢筋与周围混凝土之间可以相对滑动，导致了构件受力和变形不同于有粘结预应力混凝土构件。
The abnormal deformation or local damage of steel structure can be reflected by the load-deflection curve and the deflection curve of the longitudinal axis.
钢结构的异常变形或局部损坏可通过荷载—挠度曲线以及纵轴线的挠度曲线反映出来。
The finite element method is employed to analyze the structure and work out the status variables required by (optimization) including deflection, stress and frequency.
利用有限元法进行结构分析，求出优化所需的状态变量，挠度、应力和频率。
According to the structure and technical requirements of pin terminator plastic products, the unqualified products such as surface air-bubble and long needle deflection are analyzed and improved.
根据端子产品塑件的结构、技术要求，对生产过程中产生的造成产品不合格的表面气泡和长针歪斜等因素进行了分析和改进。
The deflection of double-pitch hipped-plate grid structure increased significantly after earthquake, and the part of anchor bolts of rubber bearing were cut off.
某双坡折板式网架结构在地震作用下出现结构挠度大幅度增加、部分橡胶支座锚栓被剪断的破坏特征。
As a new pit supporting structure, clutching borehole grouting pile has overcome the deflection of traditional pile which can not prevent water leaking and is gradually used in subway pit engineering.
钻孔咬合灌注桩作为一种新的基坑围护结构，克服了传统桩在基坑围护结构中防水性能差的缺点，在地铁车站基坑围护中得到采用。
The long-term deflection of Long Span Prestressed Concrete Box-girder Bridge(LSPCBB) is getting more and more serious in terms of structure safety.
最后，对桥梁设计计算、桥梁混凝土施工及箱梁下挠的防治技术进行论述，并对开展控制结构长期下挠的研究提出了建议。
By using the pressure deflection diagram, the flow structure for type 4 shock wave interaction pattern is analysed, and we explains why the surface pressure is very high in this case.
借助于激波极曲线，对第4类激波干扰结构进行了分析，解释了干扰引起物面压力增高的原因。
In present paper a new rotating-structure was introduced to detect local residual stress and in-plane deflection in thin cold-rolled sheet of copper alloy.
本文提出了一种转动结构用于铜合金冷轧板带残余应力检测以及面内形变的测量方法。
This paper carries on the three-dimensional static electromagnetic field analysis on the electron beam scanning deflection coil with multi pole shoe structure.
根据不锈钢毛细管板结构的钎焊特点，建立了扫描电子束钎焊温度场三维有限元分析模型。
The displacement sensing method with laser interference is a new method for measurement of vibration and deflection of engineering structure.
利用激光干涉位移传感法测量了结构物的高面位移。
The characters of ore-controlling structure and structure deflection of Hujiajian Silver-Gold Mine in Wannian County are introduced in this article.
介绍了万年县虎家尖银金矿区的控矿构造、构造形变的特征等。
The guiding wheel has the advantages of light structure, material conservation, and stable connection without easily generating deflection, low production cost and long service life.
结构轻巧，节省材料；连接稳定，不易发生偏斜，制造成本低，使用寿命长。
The guiding wheel has the advantages of light structure, material conservation, and stable connection without easily generating deflection, low production cost and long service life.
结构轻巧，节省材料；连接稳定，不易发生偏斜，制造成本低，使用寿命长。
应用推荐