The compensation methods of the dead-time effect are studied.
并对死区效应的补偿策略进行了研究。
Repetitive controller is designed for compensating the affection of dead-time effect.
重复控制作为补偿器，补偿死区效应的影响。
Dead-time is compensated according to the output reference voltage vector and phase currents.
首先判断电流方向，确定死区电压矢量的电平；
A simple and efficient PI controller tuning method for large dead-time processes is presented.
提出一种简单而有效的大滞后过程PI控制器整定方法。
In this paper, the influence of dead-time effect on series power quality compensator (SPQC) is analyzed.
本文分析了死区效应对串联形电能质量补偿器的影响情况。
A kind of cascade control system with state feedback for pure dead-time processes is presented in this paper.
针对纯滞后对象，提出一种串级双环状态反馈控制方式，使这种对象获得较理想的控制品质。
The basic principles of PFC are introduced, and PFC algorithm for first-order plus dead-time system is delivered.
介绍了PF C的基本原理，推导了一阶加纯滞后系统PF C算法。
This compensator can be used for all uncertain processes with large dead-time (UPLDT) which satisfy some stability conditions.
该时滞补偿器可应用于满足一定条件的一大类大时滞不确定过程。
Dead-time compensation and minimum pulse-width limitations lead to losses in the linear modulation region of space vector modulation.
死区补偿和最小脉宽限制减小了空间矢量脉宽调制的线性调制区。
Aimed at the influence on the inverter output voltage caused by the PWM inverter dead-time, one dead time compensation strategy is proposed.
针对PW M电压型变频器死区时间对输出电压的影响，提出了一种死区时间补偿方案。
Dead-time effects can be regarded as a kind of space-vector, which is determined by two factors: sector number and direction of phase current.
死区效应可被视为一种空间矢量，它由两个因素决定：扇区数和相电流方向。
This paper analyzed the influence of the dead-time effect acting on the output voltage of SVPWM inverter, and proposed a solution to dead time compensation.
本文在分析死区效应对空间电压矢量调制输出电压影响的基础上，给出了一种对死区效应进行补偿的方案。
Using the step response behavior of inertia process and the superposition theorem of linear system, this paper puts forward a fuzzy predictive model of dead-time processes.
利用惯性过程的阶跃响应特性和线性系统中的叠加原理，提出了纯滞后过程的模糊预估模型。
By analyzing the basic influence of the "dead-time effect" acting on the output voltage of SVPWM inverter, the concept of the dead-time voltage vector is put forward in this paper.
在分析死区效应对SVPWM输出电压影响的基础上，提出死区电压矢量的概念，给出死区电压矢量的求取方法。
Based on the analysis of traditional compensation methods, a method compensating the dead-time in a synchronous rotating reference frame is proposed, which fits for general-purpose inverters.
在分析了传统死区时间补偿方法的缺点之后，提出了适合于通用变频器的基于旋转坐标变换的死区时间补偿方法。
The relationship between the dead-time voltage sector and the stator current sector is analyzed and a method for compensating the stator voltage sector is proposed based on the reconstructed current.
分析了死区电压矢量和定子电流矢量的关系，由此得到一种根据重构电流矢量来补偿定子电压矢量的方法。
For the first time Candida glabrata is isolated from 3 red-crowned cranes dead of disease.
从3只病死的丹顶鹤中首次分离到光滑念珠菌。
The schottky diode bypasses the gate resistor in the gate discharge path, so that there is no falling edge delay. The delay at the rising edge adds dead time.
为了增加更多的死区时间，补偿功率管的切换瞬间短暂延时，增加了一个肖特基二极管，与栅极电阻。
But in practical measurement, it is very difficult to make no dead time sample due to the counter's dead time.
但实际测量时由于计数器的死区时间，使得无间隙采样十分困难。
Podcasting allows people to make far more effective use of their travel - what might have been dead time becomes valuable reflective time.
播客允许人们可以更有效的利用他们旅途的时间，那些曾经是没用的时间如今变成了有效的反思时间。
The principle of this method is introduced in detail, and a kind of circuit of generating dead time and its timing simulation are given.
详细叙述了该方法的基本原理，并以其中的一个死区时间产生电路为例，介绍了电路的设计要点及时序分析。
Unreasonable selection of dead time can make inverting components to produce higher inrush voltage and current and even damaged.
死区时间选择的不合理会使逆变器件产生过高的浪涌电压和电流甚至损坏。
A modified dead time compensation method was used to obtain better output voltage waveforms.
采用了改进的死区效应补偿方法以获得理想的输出波形。
The errors resulted from the correction to "false count" and "dead time" were estimated.
估计了由于“假计数”、“死时间”漏计数校正引入的误差。
The uncertain object with dead time is taken as a reference model and a kind of adaptive rule is proposed to make parameters of the compensator to approach the object's.
以线性大时滞不确定被控对象为参考模型综合出自适应律，使预估补偿器的参数逐步逼近被控对象的参数直至相等。
The dead time control in SPWM converter increases the harmonic component in voltage output and decreases the voltage utilization and reliability of converters.
SPWM变换器中的死区设置使变换器输出电压谐波含量增加、电压利用率和可靠性降低。
The dead time control in SPWM converter increases the harmonic component in voltage output and decreases the voltage utilization and reliability of converters.
SPWM变换器中的死区设置使变换器输出电压谐波含量增加、电压利用率和可靠性降低。
应用推荐