But only for the exchange of thyristor output load, and the transistor output can only be used for DC load.
但晶闸管输出只能用于交流负载，而晶体管输出只能用于直流负载。
The estimate method of DC load and AC load based on the bus in microcomputer application system is introduced. The load driver and the balance of single direction…
介绍了总线直流负载和交流负载的估算办法，也为解决单向总线和双向总线的负载驱动及平衡问题提出了具体的解决方案。
This paper is concerned with the simplified steady state conditions of the system based on DC load-flow, which implies the reliability indices calculated are the measures about static loss of load.
本文涉及系统的静态约束条件，所计算的可靠性指标反映静态失负荷水平。
The estimate method of DC load and AC load based on the bus in microcomputer application system is introduced. The load driver and the balance of single direction and dual direction bus are focused.
介绍了总线直流负载和交流负载的估算办法，也为解决单向总线和双向总线的负载驱动及平衡问题提出了具体的解决方案。
It has a simple structure and a high performance-to-price ratio, and at the same time it can be applied to other small power DC speed governing systems of the same load types.
该装置结构简单、性价比高，也可应用于其他具有同类负载特征的小功率直流调速系统。
Purpose: it can be used as shunt and load resistor in DC or ac circuit of electric facility and electron instrument widely.
用途：可广泛用于各种电气设备和电子仪器的直流或交流电路中作分流或负载电阻等。
The cause that transition current of DC-load in rectifier unit without balance reactor exceeds the range of permission is discussed.
分析了导致不带平衡电抗器的整流机组直流负载拐点电流超出许可范围的成因；
Due to the problem of reactive power compensation and harmonic pollution becoming serious in mine system, TCR reactive compensation system for load of mine DC elevator was designed.
由于煤矿系统无功补偿和谐波污染问题日趋严重，设计了以矿井直流提升机为负载的TCR无功补偿系统。
The DC side active power filter (APF) is shunted at the DC side of rectifier bridge, which has great technical advantages in harmonic suppressing for rectifier load.
直流侧有源电力滤波器并联在整流桥的直流侧，对整流类负载进行谐波治理有很大的技术优势。
A new equipment for simulated the performance of propeller load is introduced in this paper, it's an all digital DC torque servo system using torque closed loop and current closed loop control.
介绍一种新型的螺旋桨特性负载模拟装置，它是全数字控制的直流转矩伺服系统，采用转矩电流双闭环控制方式。
Because the clamp effect of DC voltage source, AC side output the rectangular wave voltage waveform, and it has nothing to do with the load impedance Angle.
由于直流电压源的钳位作用，交流侧输出电压波形为矩形波，并且与负载阻抗角无关。
A new segment solution for solving load margin of AC/DC power system is proposed in this paper based on continuation method and interior point algorithm.
基于连续潮流法和原始一对偶内点法，提出了一种新的分段求解交直流系统负荷裕度方法。
The new control way can realize linear control for DC-bus voltage and get the fundamental component of the load current synchronously with a little of calculation.
该方法以电网电压为同步信号，在电网电压信号的过零点采样直流侧电容电压，并通过周期离散控制可以获得负荷电流有功分量。
Thereby, it is necessary to study the DC-side equivalent model of the inverters and consequently reveal the load characters relative to their front converter systems.
因此，有必要对其直流侧等效模型进行研究，从而揭示其作为前端变流系统的负载特性。
In some cases, the need to use a variety of load voltage, but also used for DC-DC inverter, 24vdc power if converted to 5vdc power (note, not a simple step-down).
在某些场合，需要使用多种电压的负载时，也要用到DC - DC逆变器，如将24vdc的电能转换成5vdc的电能(注意，不是简单的降压)。
The influences of load models on transient stability of a multi-infeed DC and AC system are analyzed at length.
分析负荷模型对多馈入交直流系统功角稳定性的影响。
By adding damp load at DC-side of the converter, redundant energy at DC-side during grid faults will be consumed, therefore the operating of wind turbine will not be influenced by grid voltage sags.
为增强直驱型变速恒频风电系统的低电压穿越能力，采取了变流器直流侧增加卸荷负载以在故障时消耗掉直流侧多余的能量，使风电机组的正常运行基本不受电压跌落影响的应对措施。
A method is proposed to enhance the stability of a system with a direct current (DC) generator driving constant power load (CPL) based on damping compensation.
提出了一种提高基于阻尼补偿的直流(DC)发电机带恒功率负载(CPL)系统稳定性的方法。
Verify that the DC side load converter dynamic stability characteristics under short-circuit fault conditions.
验证短路故障条件下，直流侧的负载转换器的动态稳定的特点。
Its software is designed to calculate the running parameters of the AC drive system, including transformer, quadrant rectifier, DC circuit, inverter, AC motor and train load.
系统采用软件方式实时计算交流传动系统的运行参数，包括变压器、四象限整流器、直流中间回路、逆变器、电机及负载。
Feedforward signal includes the information of both grid voltage and DC side load. Power balance between the input and output can be maintained by adjusting AC side currents.
前馈信号同时包含了电网电压和负载的信息，通过快速调节交流侧进线电流，使得系统功率平衡得以维持。
The simulation demonstrates that the load current feed-forward term can be removed to cut the cost because of the fast DC-link voltage regulation.
从模拟结果可知，由于电压外回路的快速直流链稳压控制，使得负载电流回授电路可予以去除来降低成本。
This text introduces a relay solution of reliably switching high-voltage DC motor load for Hybrid Electric Vehicle.
介绍了一种能够可靠切换混合动力汽车高电压、直流电机负载的继电器解决方案。
The platform verified that the proposed variable load DC Motor Speed Control System with nonlinear state space model and parameter identification method is effectiveness.
利用该平台验证了提出的变负载直流电机双闭环调速系统的非线性状态空间模型及其参数辨识方法的有效性。
An adaptive speed control scheme for DC drive system, which combines an adaptive PID controller based on single neuron with a load observer, is presented.
针对直流调速系统，将单神经元自适应PID控制器与负载观测器有机结合，提出了一种基于单神经元的自适应速度控制方法。
An adaptive speed control scheme for DC drive system, which combines an adaptive PID controller based on single neuron with a load observer, is presented.
针对直流调速系统，将单神经元自适应PID控制器与负载观测器有机结合，提出了一种基于单神经元的自适应速度控制方法。
应用推荐