Results: Successfully construct the 3-d finite element model.
结果:成功地建立了三维有限元模型。
The 3-d finite element model is built for the modal analysis of board-level package.
建立了板级封装的三维有限元模型并进行模态分析。
The 3-d finite element model of bolt is calculated by the method of contact analysis, and the fatigue strength of bolt is checked.
并采用接触分析法对螺栓的应力应变进行了三维有限元计算,对螺栓的疲劳强度进行了校核。
An effective 3-d finite element model was constructed for the field emission array to analyse the field emission current over a single tip.
针对场致发射阵列建立了有效的三维有限元模型来分析单个尖锥的发射电流。
By using the finite element method (FEM) software, the vibration of 3-d finite element model of maxillary central incisor tooth was analyzed.
在三维有限元模型的基础上,利用有限元分析软件对上颌中切牙的振动模态进行了分析。
In this paper, a floater structure's 3-d finite element model of a type of Liquid Floated dynamically Gyroscope was setup based on a reasonable supposition.
本文在对某型液浮动力陀螺的转子结构进行合理简化的基础上,建立了浮子三维有限元模型。
A 2-d finite element model of tire-rubber was established to simulate the crack growth of the sample under simple tension, by using the strain energy density parameter.
建立了二维轮胎橡胶材料的有限元模型,用应变能密度这个参数模拟了试样承受单向拉伸时裂纹的扩展方向。
It is necessary to set up a 3-d finite element model and to convert the external loads acting on the hull into nodal forces of finite element in the direct strength calculation of hull structure.
在船体结构强度直接计算方法中,需要建立三维有限元模型,船体所受到的外载荷也应相应地转化为有限元节点力。
METHODS: A 3-D finite element model of mandibular complete dentures supported by implants was established to analyze the stress status with protrusive or lateral occlusions.
方法:建立种植全口固定义齿和种植全口覆盖义齿的三维有限元模型,然后进行侧方咬合平衡与不平衡、前伸咬合平衡与不平衡模拟加载分析。
CONCLUSION: Combination of 3-d finite-element model with spiral CT-cross technology establishes complex dental models, simulates practical conditions authentically and is good in operation.
结论:螺旋ct断层扫描技术与三维有限元法相结合,可以建立复杂的牙模型,且能真实地模拟实际情况,使用性好。
Objective To discuss the feasibility and method of constructing the 3-dimensional (3-d) finite element model of hipbone using DICOM data, Mimics and CAE software.
目的探讨采用DICOM数据,结合交互式医学影像控制系统及CAE软件快速构建髋骨三维有限元模型的可行性及方法。
Objective To discuss the feasibility and method of constructing the 3-dimensional (3-d) finite element model of hipbone using DICOM data, Mimics and CAE software.
目的探讨采用DICOM数据,结合交互式医学影像控制系统及CAE软件快速构建髋骨三维有限元模型的可行性及方法。
应用推荐