The controller got flows and queues from its detectors to estimate traffic intensity, which was then used to determine whether the current signal phase should be extended or terminated.
控制器通过检测器获得的各车道交通流量和排队长度来判断各个相位的交通强度,进而决定是否延长或终止当前的信号相位。
The converter uses a resistor to sense current signal instead of Hall sensor in addition.
另外,采用电阻替代霍尔传感器检测电流信号。
Current transformer TA1: providing primary current measurement and primary current over-current signal.
电流互感器TA 1:提供一次电流测量和一次电流过流信号。
This paper has presented a new method of measuring ground impedance by generating impulse current signal .
本文提出了利用发出冲击电流信号测量接地阻抗的新方法。
Amperometric immunosensor can detect and identify biological molecules by detecting its output current signal.
安培型免疫传感器通过检测其产生的电流信号,可实现生物分子信息的检测与识别。
Its advanced current sensing circuitry employs sample and hold methods to provide a precise average current signal.
其先进的电流检测电路采用采样和保持方法,以提供精确的平均电流信号。
As with the contact potential, the uncertainty added to a small current signal by the offset current can be calculated.
和接触电势一样,由于偏移电流而引起的小电流信号测量不确定度亦可计算获得。
Using hardware digital synthesis method, the signal source generates three phase sinusoidal voltage and current signal.
该信号源中采用硬件数字合成的办法产生三相电压与三相电流信号正弦波。
The paper concludes by presenting an algebra system which is suitable for current signal representation and operation on currents.
本文最后提出了一个适用于电流信号表示和电流运算的代数系统。
The design, analysis and testing of the welding current signal detecting circuit for spot welding machine are discussed in this paper.
本文主要论述点焊机焊接电流信号检测电路的设计、分析和测试。
This paper introduces signal switchover circuit that transforms voltage signal to current signal in order to improve signal reliability.
介绍一种旨在提高信号传输可靠性而设计的信号转换电路,它将电压信号变换成电流信号进行传输。
The output signals of two-color (MWIR and SWIR) infrared detectors with simultaneous mode are MW current signal and MW-SW current signal.
双色(中短波)同步工作模式的红外探测器,其输出光电流信号为中波信号和中短波混合信号。
This system improves the digital measurement of valve current signal in the test with its high-speed multi-channel parameter gathering technology.
该采集系统实现了多路液体火箭姿控发动机试车阀门电流信号的数字化测量。
At the same time the paper studies the relation between the rotational speed and critical knock intense calculated with ion current signal average energy.
同时还给出了基于离子电流信号的临界爆震强度与转速之间的关系。
The standard source is a power supply device which can provide appointed voltage and current signal, and is used widely in measurement and monitoring field.
标准源是一个可以提供指定电压电流信号的标准电源发生器,在计量、监测领域有着十分广泛的应用。
This paper presents the critical design, researching method and procedure of acquisition system for valve current signal of liquid attitude control rocket engine.
介绍了液体火箭姿控发动机阀门电流信号采集系统的设计要点、研制方法与主要开发过程。
In this paper, a method used to amplify faint direct current signal is put forward, and the circuits of direct current amplifier to realize the method are devised.
本文提出一种放大微弱直流信号的方法,同时设计了实现这一方法的直流放大器电路。
The paper finds out a formula to estimate the inductance value of current following inverter on the basis of tracking instruction current signal by hysteretic comparison.
从采用滞环比较方式跟踪指令电流信号出发,推导出电流跟踪型逆变器中输出电感值的估算公式。
Through measuring the electric current signal, the soft sensing model used for tool wear estimation based on stochastic fuzzy neural network(SFNN) is presented in this paper.
本文通过检测电流信号基于随机模糊神经网络建立了刀具磨损量的软测量模型。
On the basis of digital signal process and nondestructive testing, the effect of welding process on the frequency spectrum of the current signal in AC spot welding is analyzed.
在数字信号处理及无损检测的理论基础上,分析了焊接过程对电流信号频谱的影响。
First the zero sequence transient current signal sampled is enhanced, and then the signal enhanced is decomposed by using wavelet packet analysis to realize faulty line detection.
首先对采样的零序暂态电流信号做增强处理,然后利用小波包分析方法进行故障选线。
Each module is controlled by voltage current two closed loops. The common voltage loop controls system output voltage & frequency, and generates a common reference current signal.
三台航空静止变流器模块均为电压、电流双环控制,通过公用电压调节器稳定并联系统的输出电压及频率,同时产生统一的模块电流给定信号。
Each module is controlled by voltage-current two closed-loops. The common voltage loop controls system output voltage & frequency, and generates a common reference current signal.
每台航空静止变流器模块均为电压、电流双环控制,通过公用电压调节器稳定并联系统的输出电压及频率,同时产生统一的模块电流给定信号。
Putting the three-phase lines and middle line of the electrical circuit through the zero current transformer, the residual current signal will be converted into the voltage signal.
将电气线路的三相线及中线通过零式电流互感器后,零式电流互感器会把剩余电流信号转换为电压信号。
A dither signal generation section 505 outputs a dither signal (dither) which is an alternating current signal and a reversal dither signal (DITHER_N) inverted from the dither signal.
抖动信号生成部分(505)输出作为交流信号的抖动信号(DITHER)和与该抖动信号反相的反转抖动信号(DITHER_N)。
The method of direct modulation is: change the ready information to current signal and then inject the LD or LED to obtain the corresponding light signal, thus the idea is source modulation.
直接调制是把要传送的信息转变为电流信号注入LD或LED,从而获得相应的光信号。
The working principle of the developed monitoring system is to assess comprehensively the insulation status of DC feeder cable through monitoring discharge signal and DC leakage current signal.
监测系统工作原理是通过监测电缆放电信号和直流泄漏电流信号综合评估电缆绝缘状态。
The working principle of the developed monitoring system is to assess comprehensively the insulation status of DC feeder cable through monitoring discharge signal and DC leakage current signal.
监测系统工作原理是通过监测电缆放电信号和直流泄漏电流信号综合评估电缆绝缘状态。
应用推荐