It shows that the content of photoinitiator, dilution and photosensitizer affects the curing velocity a lot.
研究表明，光引发剂种类、稀释剂含量对固化速度都有影响且它们的含量有最佳值。
The results showed that the structure of anion part in diphenyliodonium could affect the laser curing velocity of epoxy resin greatly.
结果表明，碘盐阴离子部分的结构对环氧树脂的光固化速度有很大影响；
The dispersant accelerates gluten's dissolving in water, but it impairs the viscosity, curing velocity and water-resistant ability of the adhesive.
结果表明，分散剂对谷朊粉在水中的分散起到了极其重要的作用，但会降低标签胶的黏度、耐冰水能力，延长固化时间。
The effect of microwave curing on the curing velocity, mechanical and thermal properties of epoxy and epoxy matrix composites were discussed emphatically and in detail.
但环氧树脂传统的热固化方法由于存在着传热速度慢、温度梯度大、固化不均匀和固化速率低等问题，严重影响了环氧树脂基复合材料的固化质量。
The causes that residual catalysts affect the curing velocity and cured strength of used sand bonded with furan resin and reclaimed furan sand were studied and discussed deeply.
就残留催化剂和其分解物影响呋喃树脂旧砂及其再生砂的固化速度和固化强度的原因作了较深层次的研究和探讨。
The increase velocity of the UCS decreased gradually with the increasing of curing period, but increased with the increasing of cement ratio.
水泥土无侧限抗压强度的增大速率随龄期的增大而逐渐减小，随着水泥掺入比的增加而增大；
The experimental results indicate that steam curing condition increases early hydration velocity of cement-fly ash composite binders and improves compressive strength of hardened pastes.
试验结果表明：蒸汽养护条件提高了水泥-粉煤灰复合胶凝材料的早期水化速度，并且提高了硬化浆体抗压强度。
The change of imidization velocity during thermally staged curing was explained from molecular activity.
用热环化过程中分子活动性的变化解释了酰亚胺化反应过程中环化速率的变化。
The change of imidization velocity during thermally staged curing was explained from molecular activity.
用热环化过程中分子活动性的变化解释了酰亚胺化反应过程中环化速率的变化。
应用推荐