The physical nature of humidity effects on engine corrected speed is that thermophysical characteristics of air entering engine varies with humidity.
大气湿度对发动机换算转速影响的物理本质是随着湿度的变化使进入发动机的空气热物理性质也发生了变化。
If he should make a small mistake it would get corrected automatically, and might even speed up the approach to the final result.
假使他犯了一个小错，它会自动纠正，甚至还可能加速达到最终结果的步骤。
This not only results in a reduction in the problems listed above, which are normally corrected by the use of negative feedback, but also improves phase linearity and speed.
这不仅导致在上面列出的问题，这些问题通常由负反馈的使用更正减少，而且还提高阶段的线性度和速度。
The feed speed of programming must be corrected for realizing high-efficiency machining, and the calculation method of speed was given.
为了实现高效率加工，需要对编程进给速度进行必要的修正，并给出了速度修正的计算方法。
The generated energy is corrected by velocity weighting factor to conduct dynamic regulation while the response speed is reached.
利用速度权重因子修正发电量，在满足响应速度的同时实施动态优化调节。
Vignetting and distortion are both corrected excellently for a lens of this speed.
渐晕和变形都纠正了这种速度镜头出色。
The trial speed shall be corrected for wind speed and shallow water effect. The correction method of the speed shall be specified in the Specifications.
试航速度应根据风速及浅水效进行修正。速度修正的方法应按说明书中的规定。
Under the condition of high dynamic angular motion or vibration environment, confirmed and corrected the sculling error is important to calculated the speed of strap-down inertial navigation system.
划船效应误差的确定与补偿是影响高动态、恶劣振动环境下捷联惯性导航系统速度计算的重要问题。
The corrected heat transfer coefficient is large in the high-speed heating process due to the local an uneven furnace atmosphere distribution, and is small in the preheating and holding period.
在高速升温段，由于局部炉气分布不均匀，修正换热系数较大；而在预热和保温段，计算所得的修正换热系数较小。
The measured output and speed result shall be corrected to no-wind, no-current by the builder's standard method as per specifications. The speed at C.
测量的输出和速度结果应根据说明书要求修正至无风、无流状态。
Three sorts of valves were online debugged on the high-speed dispensing control system, during which hardware and software mistakes were corrected.
分别对三种点胶阀在已开发的高速点胶控制系统上进行了联机调试，修正了调试中出现的硬件和软件问题。
Three sorts of valves were online debugged on the high-speed dispensing control system, during which hardware and software mistakes were corrected.
分别对三种点胶阀在已开发的高速点胶控制系统上进行了联机调试，修正了调试中出现的硬件和软件问题。
应用推荐