Interchangeable inductor comprising the coil made from specially shaped copper section featuring Higher Strength and Higher Conductivity.
可互换的电感，成员包括具有特殊形状的铜较高的强度和较高的导电部分所作的线圈。
The ever-increasing copper price in the past several years has led to a significant increase of the cost of copper cables, and the economic section has hence decreased.
在过去几年中，铜价上升的幅度很大，导致铜芯电缆成本成倍增长，经济截面有减小的趋势，因此以前确定的经济截面是否仍满足载流量要求有待验证。
Copper wire color (dark red or white) : continuous annealing in the work period of the line burn soft and pass cooling section after cooling can achieve lead not hot, without water.
铜线变色(暗红或发白)：连续退火在工作段把线烧软，还要经过冷却段冷却后才能达到引出线不烫、不带水。
All standard coils are mechanically expanded copper pipes plus aluminum fins. The surface cooling section is equipped with a pitched discharge coil to ensure complete discharge of condensed water.
盘管的标准型式均为铜管串铝翅片结构，采用机械胀管。表冷段设计有倾斜式排水盘，保证彻底排尽水盘中的凝水。
After proving experiments of such process by using various materials of copper, aluminum and steel sheets, on the section profile of the fine stamping 100% smooth zone has been obtained.
用铜、铝、钢等材料对该方法进行了实验验证，得到了剪切断面上100%光亮带的精冲件。
The area of section of copper core for all the concerned wires is required to be not less than 0.5 square mm.
该地区的部分铜核心的所有有关的电线须不小于0.5平方毫米。
Sublevel caving method without sill pillar is adopted in the south section of Fengshan Copper Mine.
丰山铜矿南缘采区应用无底柱分段崩落法采矿。
Ammonia corrosion of condenser copper tubes in the air removal section cannot be avoided as a result of ammonia collection and existence under super cooling condition.
由于氨的聚集与氧的存在，在凝汽器空冷区出现过冷度的情况下，铜管的氨腐蚀是不可避免的。
After annealing copper red: continuous annealing three sections: preheating section, the work piece, cooling section.
铜线退火后发红：连续退火分三个段：预热段，工作段、冷却段。
The electrodepositing composite copper coating with liquid microcapsule had been confirmed by surface and section micrograph and composition analysis.
通过对这种镀层的表面、断面形貌和表面成分分析，这种含有液体微胶囊的复合镀铜层得到了证实和确认。
Its lengthways section from from the top down are non-magnetizer material board, winding covered by copper film and non - magnetizer basis material covered by copper film.
其纵向截面自下而上依次是非导磁材料板、覆铜箔线圈、覆铜箔板非导磁基材。
This phenomenon is important for analysing the magnetic-thermal stability and designing cross section and selecting copper for multi-filamentary superconducting composites.
弄清尺寸对电阻率的影响，对于分析复合导体的磁-热稳定性，设计复合导体的截面构型和判定、合理选用稳定化用铜是有重要意义的。
Work period of current is big, copper wire high temperature (550 degrees), if the working section has air exist, copper and oxygen in heating conditions produce copper oxide.
工作段电流大，铜线温度高(550度左右)，如果工作段内有空气存在，铜和氧气在加热的条件下就产生氧化铜。
Preheating section for line length is longer, the temperature is not more than 250 degrees, and not let the discoloration of copper wire.
预热段因线的长度比较长，温度不会超过250度，不至于让铜线变色的。
See Section 21. 9.2 revised June 11, 2008 9.3 An identified grounding contact, or grounding-conductor path through a device shall be of plated or unplated copper or copper-based alloy. Exception No.
第9.2节于2008年6月11日修订9.3一个通过一器件的确定的接地接触件或接地导线通路应该用电镀的或不电镀的铜或铜合金制成。
Copper, nickel or cobalt mattes produced by any process of smelting (Section).
通过熔炼所产生的铜锍、镍锍或钴锍(第十五类)。
Copper, nickel or cobalt mattes produced by any process of smelting (Section).
通过熔炼所产生的铜锍、镍锍或钴锍(第十五类)。
应用推荐