This paper presents a new design scheme of program controlled generator for coding waveform based on HDPLD.
本文提出了一种基于HDPL D的可程控多位任意组合编码波形发生器设计新方案。
The torque of IPMSG is suitably controlled according to a generator speed by maximum power point tracking.
通过使用最大功率点跟踪控制技术，根据发电机转矩适当地控制发电机的速度。
A current impulse generator is introduced with the data and waveshape controlled by computer on slice and process controller.
介绍了一种单片微机、工业控制计算机进行数据和波形管理的冲击电流发生器。
Using PC or programmable devices instead of the signal generator, a high voltage solid state switch controlled by programmes will come into true.
用PC或者可编程器件取代信号发生器提供控制信号，可以实现高压固体开关的程控功能。
A new method of microsecond timing generator controlled by microprocessor is introduced in this article.
介绍了一种用单片机控制的微秒级多路时序信号发生器的实现方法。
A simple and high - Performance brushless DC generator consisting of a controlled rectifying circuit and permanent magnet square wave motor is Presented.
提出了一种可控整流电路，它与永磁方波电机联合构成一种简单、高性能的无刷直流发电机。
The generator is connected with the tap and its power switch is controlled by turning on and off the tap.
该发生器与水龙头连接，以开关水龙头控制发生器电源开关。
The step adjustment of the generator output frequency and amplitude is controlled by a single chip microcomputer in order to realize the digital display.
文章就采用中大规模集成电路设计一个新型的多波形发生器，并由单片机系统控制其输出频率和幅度的步进调节，实现数码显示等展开了讨。
The above mentioned results may provide the basis for the design of an electrical stimulus information generator for a myoelectrically controlled force sensory feedback artifrcial hand.
上述研究，是开发智能假手的基础研究，为研制具有力感的假手的握力电刺激反馈信号发生器提供设计依据。
Generating and welding dual use set consists of generator, welding inverter, automatic control system, and internal-combustion engine controlled by speed regulator.
采用具有全程调速器的内燃发动机、发电机、逆变弧焊电源，以及二次控制系统构成发电电焊两用机。
The generator was controlled to capture maximum power from the changing wind with maximum efficiency under different load conditions.
控制发电机在不同负载条件下从随机变化的风中最有效地获得输出功率。
A digital pulse generator for a silicon controlled rectifier and digital PID algorithm for some industrial process control are realized by the microcontroller.
实现了数字化可控硅变流器的脉冲控制及一般工业控制过程的PID数字算法。
A new digital automatic voltage regulator (DAVR) of harmonic excited generator controlled by 51 single chip computer is presented.
介绍了采用5 1系列单片机控制的谐波励磁发电机数字电压调节器。
Considering the number limit of signal transmit channels, the selection of line which is measured and generator which is controlled goes along following these steps in this paper.
考虑实际系统中信号传输通道的数量限制，本文中确定了以下步骤进行被测线路和被控发电机的选择。
The acceleration mechanism can be used in acceleration of clock-controlled sequence generator and key preset of stream cipher generator.
此加速机制可应用于钟控序列发生器和序列密码发生器的密钥预置。
The discharging capacity is controlled by a rotary flow generator and the barrage size, the influence of the barrage aperture on discharge is obvious, but the effect o.
泄流能力由起旋器与阻塞共同控制，阻塞孔径对泄流量影响较大，但阻塞位置对流量影响不明显。
This DDS program-controlled sine signal generator system is based upon computer's serial interface.
本dds程控正弦信号发生器系统基于计算机串行接口。
A wide-frequency and program-controlled waveform generator based on MAX038 is introduced.
介绍了一种基于MAX038的宽频程控波形发生器。
Base on power electronic, a newly micro energy controlled pulse generator for MWEDM was developed.
在现代电力电子技术基础上，开发出新型微能可控的微细电火花线切割加工脉冲电源。
Pulse power generator, controlled by an embedded MCU, can produce high voltage or low voltage discharge pulse waveform.
电火花脉冲电源由单片机控制，用于产生高压放电脉冲、低压放电脉冲、间隙状态检测等功能。
Fundamental principles and control strategies of pitch-controlled wind induction generator system with rotor current controller (RCC) were presented.
介绍了带有转子电流控制器(RCC)的变桨距调节异步风力发电机系统的基本原理及其控制策略。
Including the principles and the source design, a method of digitally-controlled sound impulse generator is introduced.
研究了一种可控脉冲声生成技术，介绍了声源设计方案以及脉冲声工作生成的主要原理。
This project controlled the main parameters of inverting EDM pulse generator: used the special PWM generator UC3825A to realize voltage adaptive controlling;
在控制效果上实现了对脉冲电源主要参数的控制：采用专用的PWM波发生器UC3825A实现加工电压的自适应控制；
And it also contains a motor side-generator, the rotor connecting with crank outlet of the motor and the driving element of the electrically-controlled clutch simultaneously.
此外还包括一发动机侧电机，其转子同时与发动机的曲轴输出端和电控离合器的主动元件相联。
Sweep sweep signal generator with automatic, manual, program-controlled and well-controlled manner, and so on.
扫频信号发生器有自动扫频、手控、程控和远控等工作方式。
A square-wave AC high-frequency welding power source is composed of the square-wave AC high-frequency generator and DC welding machine controlled by thyristor.
将晶闸管直流焊机与方波交流高频发生装置组合，构成方波交流高频焊接电源。
And it contains a gear-box side-generator, which connects with the inlet shaft of the gear box and the driven shaft element of the electrically-controlled clutch simultaneously.
一变速箱侧电机，其同时与变速箱的输入轴和电控离合器的从动轴元件相联。
And it contains a gear-box side-generator, which connects with the inlet shaft of the gear box and the driven shaft element of the electrically-controlled clutch simultaneously.
一变速箱侧电机，其同时与变速箱的输入轴和电控离合器的从动轴元件相联。
应用推荐