The model is an effective method, which can be used for pressure drop of oil gas water three phase vertical upwards slug flow in which the continuous liquid phase is water phase.
本模型是计算垂直油-气-水三相弹状流中液相的连续相为水相时的压力降的有效方法。
That which running daily in a refinery belongs to the procession of continuous production. Its job control program should be listed in the flow control model.
炼油厂生产属于连续性生产，生产作业控制一般采用流量控制模式。
A new model of flow in a twin rotor continuous mixer was analyzed with the finite element software ANSYS.
文中利用有限元软件ANSYS对S形转子连续混炼机的流场进行了模拟分析。
Using incompressible MHD equations and zero equation turbulent model, the paper calculated the flow field in two dimension thin slab continuous casting mould with the electromagnetic brake(EMBR).
本文采用不可压缩MHD方程及零方程湍流模式，数值计算了加电磁制动器的二维薄板坯连铸结晶器中的流场。
The Spalart-Allmaras turbulence model was applied to simulate the continuous phase flow field. The gas flow field characteristics were obtained.
首先采用S-A湍流模型对连续相流场进行数值模拟，得到了气相流场的特性；
To describe the phenomena of stopwave in the continuous traffic flow, a stopwave model was built based on kinematic equation by analyzing kinematic characteristics of stopwave spread.
为描述连续交通流中的停车波现象，分析了停车波传播的运动学特性，基于运动学方程建立了停车波模型。
A dual-flow continuous culture system provides a relatively ideal model for simulating rumen fermentation, including physiology, biochemistry and microbiology.
双外流连续培养系统是目前研究反刍动物瘤胃生理学、发酵生物化学和微生物学的较为理想的模型。
The minimal amount of fluid carrying of gas well bore model and the continuous flow condition is acquired to limit minimal test production.
⑷采用最小携液量和低速非达西流连续流动条件限定最小测试流量；
The effective thermal conductivity model and coupled model were developed for simulating the influences of fluid flow on heat transfer and solidification in continuous casting process.
综述了在连铸数值模拟过程中，为评估流体流动对铸坯热量传递和凝固过程影响所开发的有效导热模型和耦合模型。
Using flow field software PHOENICS and water model, this paper describes the flow field of molten steel in continuous casting billet mold.
应用流场计算软件PHOENICS及水力模型，模拟了方坯连铸结晶器内钢液的流场和流动分布。
A new model for describing mass transfer performance in the supercritical fluid ext raction columns by continuous counter current flow was derived.
建立了描述连续逆流超临界流体萃取塔传质性能的数学模型。
The vortex flow and mold flux entrapment in the thin slab continuous casting mold was investigated using a 1/4 scale water model.
利用1/4水模型对薄板坯连铸结晶器内的涡流及卷渣行为进行观察研究。
The fluid flow in a wide slab continuous caster mold was simulated by a three-dimensional model set up using the commercial software PHOENICS.
以某钢厂宽板坯连铸结晶器为研究对象，利用商业软件PHOENI CS建立一个三维有限差分模型，模拟宽板坯连铸结晶器内钢液的流动分布。
This paper developed a new mathematical model for calculating the thermal stability of the continuous-flow stirred tank reactor (CSTR) operating under steady state.
提出了一个新的研究CSTR(连续搅拌釜式反应器)热稳定性问题的定态法。
To discuss water flow law, authors think of the mining stratum as continuous medium to meet the necessities of Darcy's law, and established a mathematical model to describe the flow of mining strat…
将采动地层视为连续介质和符合达西定律的流体，建立了描述采动地层水系流动的数学模型，对数学模型的适用条件进行探讨。
A unsteady large eddy simulation was used to model molten steel flow in a continuous casting mold to analyze the vortex flow.
为了研究结晶器内钢液涡流现象的形成机理，采用大涡模拟方法对此涡流现象进行模拟。
The Model SPC/L372J is a flow-through viscometer that is installed in laboratory and process fluids to provide continuous temperature and viscosity tracking.
L 372J探头是一种流过型粘度计，可以安装在实验室和生产过程中，用来不间断提供流体的温度和粘度追踪。
The experiment of water model has been conducted to study the effect of pouring technical parameters on the surface flow and vortex in the mold of continuous casting of slab.
利用水模拟实验研究连铸浇注操作工艺(参数)对板坯结晶器内液面涡流的影响规律。
The experiment of water model has been conducted to study the effect of pouring technical parameters on the surface flow and vortex in the mold of continuous casting of slab.
利用水模拟实验研究连铸浇注操作工艺(参数)对板坯结晶器内液面涡流的影响规律。
应用推荐