The dynamic contact force method is a relatively accurate method for solving dynamic contact problems in viscoelastic media.
动接触力算法是求解粘弹性动接触问题的精度较高的方法之一。
The contact force during impact process was measured by force sensor and data signal processing system in real time.
冲击过程中的接触载荷由压力传感器及数字信号处理系统实时测量。
Finally, the distributing and evolving features of contact force network in dense granular systems are investigated.
最后,分析了密集颗粒系统内接触力网的分布及演化特征。
The contact method with low contact force on Al electrodes is required for test probing of LSI for the next generation.
下一代的大规模集成电路的测试探头要求使用在铝电极上的低接触力的联接方法。
The contact force network may provide a micro-mechanism for revealing the static, dynamic features in granular systems.
对系统内接触力网的分析统计有助于从机理上揭示颗粒系统的许多静、动态性质。
Driving wheels, guiding wheels, track rack will have contact force with crawler boards while the walking device running.
在运行时行走装置的驱动轮、导向轮、履带架与履带板都会产生接触力作用。
The relationships between dynamic contact force and indentation are derived in the case of longitudinal wave propagation.
在仅考虑纵波传播的情况下,寻出了撞击力-压入位移关系。
The hypotheses are categorized into two groups: the contact force entrainment hypothesis and the non-contact force hypothesis.
进一步将风沙起动假说归纳为以接触力为主的起动学说和以非接触力(气力)为主的起动说两大类。
We also set up an impedance model of the environment during the contact, and propose the calculating method of virtual contact force.
建立了环境在稳定接触过程中的阻抗模型,提出了虚拟力的计算方法。
This means that any subsequent deflection of the contact will be smaller, and the corresponding contact force will be reduced as well.
这意味着该触点任何后续的变形都将会很小,且相应的触点压力也会降低。
When the force can not contact drill string with one side of the borehole wall, the stiffness of drill string can influence the contact force.
当外力不足以使钻柱紧贴于井壁的一侧时,钻柱的刚度对钻柱与井壁之间的接触力有影响。
The catenary's shape influenced by gravity is curve, and the pantograph-catenary contact force changes regularly with pattern during one span.
在重力作用下的接触网是悬链形,弓网接触力在一个跨距内呈现规律的起伏变化。
Based on the achieved contact force data, the relation of the contact force and deformation depth of specimens can be obtained by calculation.
根据接触载荷数据,可计算得到接触载荷与样品表面变形的关系。
To avoid reduction of critical time step size due to the penalty parameter for contact force calculation, a local density factor is introduced.
为避免用于计算接触力的罚函数法中的罚因子影响显式仿真算法的稳定性 ,采用了局部质量密度因子来抵消罚因子的负面影响。
Coupled with circuit equations, the opening time of movable contact also can be calculated using iteration with the restriction of contact force.
通过耦合电路方程,并以动触头上的预压力为约束,经迭代运算,确定动触头的打开时间。
The method can calculate the contact force and its change range between the pin gear and the cycloid during the whole transmission more precisely.
该方法可以比较精确地计算在整个传递过程中针齿和摆线轮齿面接触力的大小和变化范围。
In the thesis, the contact stress, bending stress on the root and the contact force on the tooth have been calculated by Finite Element Method (FEM).
文章采用有限元接触计算方法,计算了螺旋锥齿面接触应力和齿根弯曲应力以及齿面接触合力。
The tangency point of Bottom Hole Assembly is located at where the drill string just touches the wall of the borehole, and the contact force is zero here.
在计算底部钻具组合的受力和变形时,以前一般都是按弯矩为零的条件来确定其上切点的位置。
Take the curve negotiating vehicle and curve continuous beam bridge as two vibration subsystems connected by nonlinear contact force between wheel and track.
将曲线通过车辆和曲线连续梁桥分为两个由非线性轮轨接触力联系的振动子系统。
The contact force algorithm proposed in this paper is compatible with the explicit integration scheme, and the contact constraint conditions are well satisfied.
本文给出的接触力算法既与显式时间积分格式相容,又能充分满足接触约束条件。
In the paper a new structure of the developed vacuum circuit breaker with the on-line dynamic contact force compensation by means of the contact current is presented.
本论文提出了一种新型的真空断路器结构,该结构可以利用触点电流在线动态补偿触点压力。
The displacement frequency responses of the tires excited by, respectively, radial contact force, tangential contact force and lateral contact force are calculated using FEM.
在有限元模型中,分别计算了轮胎在受径向接触面力、切向接触面力和侧向接触面力时的位移频率响应。
To research wear fault dynamic response for slider-crank of membrane pump, the wear fault dynamic model was built which based on the contact-separation state contact force model.
采用接触—分离二状态接触力模型,建立了隔膜泵曲柄滑块机构磨损故障动力学模型。
Conclusion the variation of the disc height, facet-joint Angle and the lordosis Angle of the intervertebral disc had a manifest influence on the isthmic stress and facet contact force.
结论:椎间盘高度、腰椎小关节角、椎间盘前凸角等形态结构变化对腰椎节段有限元模型的峡部、小关节应力及小关节接触力有明显的影响。
Uses dynamic contact FEM to analyze impact and collision of hammer to foundation soil in the dynamic compaction, establishes the contact relation between dynamic contact force and speed.
采用动力接触有限元法分析强夯中夯锤对地基土的冲击碰撞过程,建立动接触力与速度之间的接触关系式。
Simulation research results showed the front wheel had the biggest contact force during the surmounting process, the vehicle could surmount obstacle with height over the radius of wheel.
仿真研究结果表明,作业车能够越过高度不小于车轮半径的垂直障碍,越障时前轮所受碰撞力最大。
The numerical results indicate that the contact stress and strain, and the residual stress and strain increase as either of the switch gap, switch contact force, or electric current loads increase.
分析结果显示,在本文分析之范围内,微继电器开关之接触弯曲应力、应变以及残留应力、应变均会随著开关间隙、接触力以及电流负载之增加而增加。
The numerical results indicate that the contact stress and strain, and the residual stress and strain increase as either of the switch gap, switch contact force, or electric current loads increase.
分析结果显示,在本文分析之范围内,微继电器开关之接触弯曲应力、应变以及残留应力、应变均会随著开关间隙、接触力以及电流负载之增加而增加。
应用推荐