According to the material, machining, assembly and the actual operating environment, a reasonable range for thermal contact coefficient is obtained.
根据空间相机的材料、加工、装配及其特殊运行环境，得到一个合理的接触系数范围。
The meshing process is analyzed using line graph method firstly, calculation methods of the contact ration, multi-point contact coefficient and multi-pair contact coefficient are established;
首次采用线图法分析了其啮合过程，建立了双圆弧齿廓弧齿锥齿轮重合度、多点接触系数和多对齿接触系数计算方法；
In the default model the friction coefficient is defined as afunction of the equivalent slip rate and contact pressure.
在默认模型里，定义摩擦系数为等效滑移率和接触压力的函数。
Aimed at a straddle blade root, the influence of the interface friction coefficient and initial clearance on the contact force distribution, load distribution and the maximum stress is analyzed.
文中以一菌型叶根为对象，分析了界面摩擦系数和初始间隙对接触力分布、载荷分配及最大应力的影响。
The total adhesive friction coefficient is expressed as a combination of adhesive friction coefficients in elastic and plastic contact regime.
总的粘着摩擦系数被表示为弹性接触区与塑性接触区的粘着摩擦系数的组合。
The purpose of this article is to study the relation of the interface heat transfer coefficient with initial temperature of specimen and pressure as two non-isothermal cylinders contact each other.
研究了两个不同温度的圆柱体在相互热压时，其间的接触热传导系数与热工件的初始温度及压力之间的关系。
The environment coefficient usually relates to some external environment factors, such as the distance to genetic sag and the contact degree to frontal sand body of delta.
环境系数通常与距离生油凹陷的远近及与三角洲前缘砂体的接触程度等外部环境因素有关。
The model tests were carried out on RPC under contact explosion, the coefficient of explosion cavity radius of the material is obtained by above experiments and theory study.
并对钢纤维RPC抗接触爆炸性能进行了初步的模型试验研究，根据试验数据及理论研究得到了它的爆炸压缩半径系数。
The coefficient of friction for static contact is higher than for dynamic contact, so static contact provides better traction.
此时因为静摩擦系数比动摩擦系数高，所以静摩擦的附着力较大。
The affection of the driving ratio and position-changing coefficient on the side contact macula of the gears was analysed and calculated.
本文分析计算了传动比和变位系数对齿轮副接触斑点的影响；
The calculated results for steam filmwise condensation indicate that the heat transfer coefficient increases with the contact angle increasing when the contact angle ranged within a certain degree.
计算结果表明，接触角在一定范围内，膜状冷凝传热系数随着接触角的增大而增大；
Based on Reynolds equation, the analytical formula of gas-film damping inside two parallel plates has been obtained, which analyses gas-film damping coefficient changes with contact distance.
基于雷诺方程，得到两平行板内部气膜阻尼的解析公式，分析了气膜阻尼系数随接触距离的变化情况。
A zero friction coefficient means that no shear forces will develop and the contact surfaces are free to slide.
零摩擦系数意味着没有剪力发生，且接触面自由滑动。
Test researches on slip coefficient of high-strength bolted joints with certain rust inhibiting coatings on contact surfaces are reported.
介绍了连接接触面涂醇酸铁红或聚氨酯富锌漆的高强度螺栓连接抗滑移系数试验研究。
Heat transfer characteristic of ice storage tank of direct contact ice slurry system was studied, the influence factor of volumetric heat transfer coefficient in the ice slurry tank was analyzed.
对直接接触式二元冰蓄冷系统制冰罐内的传热特性进行了研究，对影响制冰罐内容积换热系数的各种影响因素进行了分析，最后对容积换热系数对制冰速率的影响进行了讨论。
When under the same axle load, if the wheel rolling speed gets higher, the adhesion coefficient declines as the ratio of the mean asperities contact pressure to the total pressure becomes smaller.
研究发现：相同轴重下，滚动速度越大，粗糙峰接触压力与总压力的比值越小，导致轮轨之间的粘着系数下降；
When under the same speed, if the axle load gets weighter, the adhesion coefficient increases as the ratio of the mean asperities contact pressure to the total pressure becomes bigger.
相同速度下，轴重较大，粗糙峰接触压力占总压力的比值也越大，此时粘着系数也较大。
The influences of many contact parameters such as initial normal force, contact angle, contact stiffness and coefficient of friction were obtained.
获得了凸肩接触面初始正压力、接触角度、接触刚度、摩擦系数等多种参数对叶片非线性响应的影响规律。
Compared to bevel gear, hypoid gear has larger overlap coefficient, lower gear contact stress, more smooth transmission, lower impact and noise, higher load bearing capacity, longer life and so on.
准双曲面齿轮与普通圆锥齿轮相比，具有重合度大、齿面接触应力低、传动平稳、冲击和噪音小、承载能力高和寿命长等优点。
The method to measure the derailment coefficient with the non-contact type displacement sensor in place of the force measurement wheel-set is described.
介绍了采用非接触式位移传感器代替测力轮对，测试脱轨系数的方法。
The simulation results indicated that heat transfer coefficient increased with increasing surface free energy difference and decreasing contact Angle hysteresis.
模型计算结果表明液固表面自由能差越大、接触角滞后越小则越有利于冷凝传热。
The formula shows that the more the dielectric coefficient, the smaller the maximum electric field strength within cover contact.
公式表明触头盒的介电常数愈大，盒内触头最大电场强度愈小。
The formula shows that the more the dielectric coefficient, the smaller the maximum electric field strength within cover contact.
公式表明触头盒的介电常数愈大，盒内触头最大电场强度愈小。
应用推荐