Most types of top contact shoes simply hang from a beam suspended between the axleboxes of the bogie.
多数类型的上触式集电靴被在转向架的轴套之间的一个悬挂杆吊着。
An accurate account of the contact problem of an elastic indenter and a laminated beam is given by using the mixed finite element method for solving elastic contact problems.
本文采用处理弹性接触问题的有限元混合法研究了弹性压头与复合材料层合梁间的弹性接触问题。
The elastic impact procedure of a beam under lateral impact of ball was simulated by using numerical method in which the contact deformation was considered.
使用数值方法模拟考虑接触变形的梁受到球横向弹性碰撞的全过程。
Because of the tooth thickness of the dedendum is larger than that of the common involute gear and the Pitchs do not contact each other, the beam strength and surface strength of tooth are increased.
由于该齿轮的齿根厚度比普通渐开线齿轮的齿根厚，并且节点附近不相接触，因此，其轮齿弯曲强度和接触强度都提高。
Based on the new contact model, finite element analysis scheme of drill rods in contact with curved boreholes is given using Bernoulli spatial curved beam elements.
利用新的接触模型，采用忽略横向剪切变形的三维空间曲梁单元对三维曲井内钻柱的接触非线性进行了有限元分析，给出了一套计算方法。
The width of the tip-tab increases gradually from the front end of the load beam up to the contact part, and decreases gradually after the contact part.
尖端-搭片的宽度从承载梁的前端到接触部逐渐增加且在接触部之后逐渐减小。
Take the curve negotiating vehicle and curve continuous beam bridge as two vibration subsystems connected by nonlinear contact force between wheel and track.
将曲线通过车辆和曲线连续梁桥分为两个由非线性轮轨接触力联系的振动子系统。
Will laser beam optical fiber laser coupling will enter. Focusing at implementation of workpiece on welding. By using optical fiber transmission non-contact welding, Have more flexibility.
将激光束耦合进入光纤，聚焦于工件上实施焊接，采用光纤传输非接触焊接，具有更大的灵活性。
A DC-contact series radio frequency(RF) micro electromechanical system(MEMS) switch with slanting beams was developed to eliminate warping of the cantilever beam due to residue stresses.
为解决悬臂梁结构的射频微机电系统开关在残余应力的作用下会发生翘曲的问题，提出在悬臂梁的顶端引入斜拉梁的方法。
When a Beam of light falls on the edge of an object, it is Bent slightly by the contact and causes a Blur at the edge of the shadow of the object.
当一束光照到某物体的边缘时，光不再继续沿直线前进，而要在边缘处少许弯曲，致使物体阴影的边缘变得模糊。
When a Beam of light falls on the edge of an object, it is Bent slightly by the contact and causes a Blur at the edge of the shadow of the object.
当一束光照到某物体的边缘时，光不再继续沿直线前进，而要在边缘处少许弯曲，致使物体阴影的边缘变得模糊。
应用推荐