The body system of constraint application which include constraint analysis, constraint expression, constraint solution is put forward.
提出了包括“约束分析”、“约束表达”、“约束求解”的约束应用体系。
The Constraint Elicitation TAB, shown in Figure 2, displays a view in which the analysis results (a listing of the anti-patterns detected) are presented in a table.
ConstraintElicitation选项卡，如图2所示，显示了在表格中展示分析结果(一列检测到的反模式)的视图。
This constraint disqualifies the use of this analysis for polymorphic viruses.
由于有此约束，图中的分析不能用于多态病毒。
All these measure along with propagation analysis of constraints established the theory and quick solution of geometric constraint engine.
通过约束传播分析，为几何约束求解引擎的实现提供了理论依据和快速算法。
Finite element analysis for constraint model was conducted on the gear box casing of 7ypj agricultural tricar using modal analytic theory according to its structural characteristics.
针对7ypj型农用三轮汽车齿轮箱体的结构特点，应用模态分析理论对其进行了约束模态的有限元分析。
A constraint satisfaction scheduling model for the initial scheduling problem and a greedy algorithm for it are given based on the constraints analysis and some basic hypothesis.
在调度约束条件分析和一些基本假设的基础上，本文建立了多卫星初始调度约束模型，并给出了模型求解的贪婪算法。
Such a pattern of global tectonics and motion can be used as the surface boundary constraint for analysis of mantle movement and dynamics.
此全球构造格局和运动，可作为启发和约束地幔运动和动力学分析的表层边界条件。
The IBIS model is used to help get exact information in the integrity constraint design of system board level or multiple board level signals for analysis and calculation.
IBIS模型可以帮助设计者在系统板级或多板信号完整性约束的设计中获取准确的信息，以进行分析和计算。
Considering the integration order and the effect of constraint condition to the model shape, comparing model shape with experimental data, the analysis about theory is right.
计算考虑了积分阶次和约束条件对振型的影响，并与实验数值进行了比较，验证了理论分析的正确性。
The above analysis is flawed for it omits the constraint of property rights.
传统分析有缺陷，因其忽略了产权的限制。
Based on a systematic analysis of the movement of the flap valve, a mathematical model with constraint conditions and objective functions is established.
文中通过对拍门运动的系统分析，建立了带有约束条件和目标函数的数学模型。
Confirmation of objective functions, variables analysis and constraint conditions during modeling were studied.
对建模过程中有关目标函数确定、变量分析、约束条件等进行了讨论。
The paper once again deals with the mobility analysis methodology of mechanisms based on constraint screw principle.
再次论述基于约束螺旋原理的机构的自由度分析方法。
To implement the constraint equations for the special design feature in log hauling trucks, a procedure is developed allowing the use of the code for general-purpose dynamic analysis of the trucks.
采用一般卡车通用动力学分析程序，只需补充描述原木拖车特殊设计特征的约束方程，上述算法即可实现。
For the stochastic system of the dynamic equation and the kinematic constraint, the upper and lower bounds on its information matrix are given, via eigenvalue analysis.
针对运动约束与运动方程构成的系统，利用特征值分析方法给出了其信息矩阵的上下界限。
Second, Simulating experiment condition, putting constraint on boundary of model, changing entity model to finite element model and using buckled analysis to calculate the CD critical load.
第二步，模拟实验条件，对模型施加边界约束，把实体模型转换为有限元的数学模型，并利用屈曲分析，对瓦楞纸板竖向边压的临界载荷进行计算。
In Chapter two, we give an analysis of the incentive and constraint of executive by means of the theory of principal and agent.
第二章运用委托——代理理论对企业家的激励与约束进行理论分析。
Objective: to discuss the rational boundary constraint design in finite element analysis of the whole edentulous maxillary and cranial skeleton.
目的：探讨上颌骨三维有限元分析中较合理的边界约束条件的设定。
Through the optimization analysis, the acceptable, reasonable and practical personal dose constraint value has been suggested.
通过最优化分析，提出了可接受与合理达到、切合我国铀矿冶实际状况的个人剂量约束值。
The analysis also shows that the nonlinear terms in the dynamic system equations cause the stochastic state to jump so that the circuit state can reach compatibility with the constraint equations.
同时发现动力学系统中的非线性函数项（或非线性元件）能够发生跳跃随机性和产生跳跃随机曲线，以使电路的状态轨迹达到与约束方程相容的状态。
Presented is an analysis of the motion transmitting characteristics of constant velocity joint (CVJ) and Cardan joint when the axes of the joints move arbitrarily in the constraint permitted space.
研究并基本解决了轴线相交且做允许的任意空间运动时等速万向节和十字轴式不等速万向节的运动传递特性的分析问题。
The geometric constraint is processed by the driven-tree analysis.
提出了利用驱动树分析几何约束的方法；
Next, We made mathematic description of credit risk and liquidity risk control constraint conditions based on the analysis in foregoing sections.
其次，在前面分析的基础上，我们对商业银行信贷风险和流动性风险控制的约束条件做了数学描述。
For suboptimal method based on optimal threshold analysis, a recursive form of threshold selection using Newton iteration is developed with false alarm probability constraint.
次优门限算法以最优门限分析为基础，在虚警概率约束下使用牛顿迭代给出求解门限的递推算法。
The general formula which could be applied to compute the constraint reaction to statically indeterminate structures with elastic bearings is obtained by analysis of a computing result.
通过对含有弹性支承的结构约束反力计算结果分析，得出含弹性支承约束反力的统一计算公式。
This paper first made a systematic analysis of the correlation features between the redundant events, including attack class constraint, spacial constraint, timing constraint.
本文首先对冗余事件的关联特征进行系统的分析，包括攻击类型关联特征、空间关联特征、时间关联特征。
Constraint equation was established according to mechanical model, utilizing the analysis, solving the forward and inverse position solution, and drawing the mechanical assembling sketch.
针对机构模型建立了约束方程，利用解析法求解机构的位置正反解，并绘制出机构装配简图。
In this paper we analyze the transaction rules with time constraint that can always be found in the process of business sales analysis.
本文分析了在商业销售分析中常见的具有时间约束的交易规则。
Fuzzy constraint functions are set up according to static analysis, dynamic analysis and properties analysis of belt conveyor.
通过对输送机进行静动态分析和性能分析，建立了模糊约束函数。
Fuzzy constraint functions are set up according to static analysis, dynamic analysis and properties analysis of belt conveyor.
通过对输送机进行静动态分析和性能分析，建立了模糊约束函数。
应用推荐