One dimensional constant specific heat model was taken to analyze the influence of the related parameters on the combustion mode transition and the combustor performance.
在计算中用一维、定比热容方法分析了相关参数对燃烧室模态转变、性能的影响和隔离段与燃烧室的相互作用。
The error analysis indicates that DSC method is effective and can be used to measure the specific heat capacity at constant pressure of other crystals.
有关误差分析表明，该测试方法是有效的，并可用于其它晶体的恒压比热容的测量。
The test data show that for loess with constant water content, if the density is increased, the coefficient of thermal conductivity and specific volume heat both are increased.
实验结果揭示出，在含水量一定的情况下，导热系数和比热容随密度增大而增大；在密度相同的情况下，导热系数和比热容亦随含水量的增大而增大。
In harmonic approximation, the specific heat obeys T3 law at low temperature, keeps a constant at high temperature.
在谐和近似下，低温比热符合T3定律，高温比热趋于常数。
Several linear regression equations of the specific heat at constant volume for ideal gas based on MATLAB were proposed and proved by mathematical statistics, with maximum relative error less than 5%.
利用MATLAB的数值回归分析功能，得到了几种常见理想气体定容比热容与温度的线性回归公式，数理统计分析的结果证明了这些回归公式的合理性，回归公式的最大相对误差低于5%。
The results show that the specific heat capacity at constant volume in a fractal medium is always less than that in a homogenous medium.
结果表明，同一材料的分形介质定容比热恒小于均匀介质的定容比热。
Experimental results show that apparent specific heat of sand mold materials is considered as a constant in low temperature range, but it is...
实验结果表明，砂型材料的表观比热在低温范围内可视为常数，但在高温范围内，砂型材料的表观比热是温度的幂次多项式函数。
Experimental results show that apparent specific heat of sand mold materials is considered as a constant in low temperature range, but it is...
实验结果表明，砂型材料的表观比热在低温范围内可视为常数，但在高温范围内，砂型材料的表观比热是温度的幂次多项式函数。
应用推荐