The finish cutter location data were computed using the equidistant offset surface method, and the machining row distances were acquired by the control of the residual height.
应用等距偏移曲面法计算出曲面数控精加工刀位数据，并通过控制切削残留高度的方法求得切削行距。
The paper approached a new method, in which the reservoir early productivity could be estimated or computed with geochemical logging analysis data.
利用地化录井分析数据对储集层早期产能进行估算，该文探讨了这种新方法。
The computed results using synthesis data and real data demonstrate that the method is an effective and practical method.
合成数据及实际数据计算结果表明，此方法是一种有效的实用方法。
Computed results of anisotropic microstrip line and rectangular dielectric waveguide agree well with data given in the literature, the effectiveness of this method is thus justified.
文中给出了各向异性微带线及矩形介质波导的计算结果，与文献值吻合得较好，证实了本文方法的正确性。
Kalman filtering method is widely used in data adjustment of dynamic surveying system, whose unit variance is usually computed with innovation vector of parameters and residual vector of observations.
卡尔曼滤波方法已广泛应用于动态测量数据的处理，其单位权方差通常按新息向量和观测值的残差向量进行计算，增加了观测值残差向量的计算。
The aerodynamic coefficients such as the normal force, axial force, and the pitching moment of the ve-hide computed by the local method are in good agreement with the experimental data.
由此计算出飞行器的法向力、轴向力和俯仰力矩系数，计算结果与实验数据相符。
Finally, a output cavity loaded with a filter is computed and the computed result is analyzed and compared with cold test data in order to conform the reliability of this simulated computation method.
最后通过滤波器加载输出腔的模拟计算结果与冷测结果的比较和分析，进一步验证该方法的可靠性。
At last, the RCS value of conductor objects under beaming of steady-state electromagnetic wave computed by FDTD method are coincided relatively with the data of method of Moments (MOM).
最后，用FDTD法计算了在稳态电磁波照射下导体目标的RCS值，结果与矩量法比较吻合。
Computed test shows that the numerical method for 3-d flow over spillway is successful, and a good agreement between the computation results and experiment data can be achieved.
算例表明，该三维过坝水流的计算方法是成功的，计算结果与试验值吻合较好。
In the light of available data, the reservoir inflow floods are computed by typical years method and compared with various analysis methods.
入库洪水根据资料情况采用典型年法，并用多种方案分析比较。
Objective: To establish the measurement method of the normal orbital by X-ray computed tomography (CT) scan, which provided the anatomic data for the surgery of the orbital reconstruction.
目的：建立正常人眼眶骨性径线CT测量的方法，为眼眶重建提供形态学依据。
In the range of high tip-speed ratio the results calculated by this method are closer to experimental data than that computed by momentum theory.
在高尖速比范围内，本方法给出的结果比动量理论给出的更加接加接近实验数据。
In the range of high tip-speed ratio the results calculated by this method are closer to experimental data than that computed by momentum theory.
在高尖速比范围内，本方法给出的结果比动量理论给出的更加接加接近实验数据。
应用推荐