The vaporized refrigerant vapor from the low temperature and low pressure, suction inlet of the compressor to be compressed, compressed and then discharged into the next cycle.
蒸发后的低温低压冷媒蒸气，从压缩机的吸气口流回，被压缩压缩后排出进入下一循环。
Gas composition, volume flow rate, axial power, pressure and temperature of inlet and discharge gases of the compressor have been evaluated with the international general standard.
采用国际通用标准对压缩机气体组成、容积流量、轴功率、进排气压力和进排气温度等指标进行了测定。
This paper introduces the parameter estimation research for the turbine inlet temperature and compressor exit pressure by using the engine variables measured under the different flight conditions.
本文研究利用不同飞行状态下测量的发动机变量估计涡轮进口温度和压气机出口压力。
Several calculating methods for determining the air-flow rate, the exhaust temperature, the compressor outlet pressure and the turbine inlet pressure are compared.
对四冲程柴油机增压系统的空气流量，排气温度、压气机出口压力和涡轮进口压力的若干种计算方法进行了分析。
A stage - by - stage simulation method is introduced for analysis of inlet total pressure distortion effect on the multistage axial flow compressor characteristics.
介绍了1种分析进口总压畸变对多级轴流压气机特性影响的逐级模拟方法。
It is illustrated that discharge temperature of gas cooler, efficiency of expander and degree of superheat at the inlet of compressor can exert more influence on the optimum high pressure.
结果表明，气体冷却器出口温度、过热度和膨胀机效率对最优高压压力的影响较为明显。
It is illustrated that discharge temperature of gas cooler, efficiency of expander and degree of superheat at the inlet of compressor can exert more influence on the optimum high pressure.
结果表明，气体冷却器出口温度、过热度和膨胀机效率对最优高压压力的影响较为明显。
应用推荐