The dynamic distortion data of a engine compressor inlet flow are studied with inlet shield.
对某型发动机压气机进口档板动态畸变流场数据进行了研究。
In order to recover these valuable gases, they are now exhausted to civil LPG system or the gas compressor inlet of FCC unit.
为了回收利用这些有价值的气体，将上述气体改排入民用液化石油气系统或催化裂化装置气压机入口。
SSL is the description of the surge points locus and, in the current practice, it's assumed to be invariant with centrifugal compressor inlet conditions.
SSL描述了喘振点的轨迹。在目前的实践工作中，一般假定认为它不随离心压缩机的入口条件变化而改变。
This paper discusses the effect of compressor inlet temperature on its performance, thereby puts forward some measures to keep the inlet temperature constant.
本文分析了压气机性能试验中压气机进口温度变化对性能的影响，提出了保持进口恒温的一些措施。
The filter meshwork of the compressor inlet was cleaned out without shutdown of CCR plant. The method, that the plant was run in longer workup period, was found in it.
介绍在装置不停工状态下，进行压缩机入口过滤网的清洗工作，并从中找到使装置长周期运行的方法。
INLET GUIDE VANES, a fixed set of blades in front of an engine compressor for directing airflow to the compressor.
进口导向叶片，发动机压气机前的一组固定叶片，用以引导气流进人压气机。
The vaporized refrigerant vapor from the low temperature and low pressure, suction inlet of the compressor to be compressed, compressed and then discharged into the next cycle.
蒸发后的低温低压冷媒蒸气，从压缩机的吸气口流回，被压缩压缩后排出进入下一循环。
Several calculating methods for determining the air-flow rate, the exhaust temperature, the compressor outlet pressure and the turbine inlet pressure are compared.
对四冲程柴油机增压系统的空气流量，排气温度、压气机出口压力和涡轮进口压力的若干种计算方法进行了分析。
This paper introduces the parameter estimation research for the turbine inlet temperature and compressor exit pressure by using the engine variables measured under the different flight conditions.
本文研究利用不同飞行状态下测量的发动机变量估计涡轮进口温度和压气机出口压力。
Gas composition, volume flow rate, axial power, pressure and temperature of inlet and discharge gases of the compressor have been evaluated with the international general standard.
采用国际通用标准对压缩机气体组成、容积流量、轴功率、进排气压力和进排气温度等指标进行了测定。
Results show that the frequency and rotating direction of inlet distortion are most important factors affecting stability of axial compressor.
在低速大尺寸单级压气机实验器上，实验研究了动态进气畸变对压气机稳定边界的影响。
Experimental tests have been carried out to investigate the influence of inlet distortion on compressor stability margin in a low speed single stage research compressor.
在低速大尺寸单级压气机实验器上，实验研究了动态进气畸变对压气机稳定边界的影响。
Based on experimental properties of compressor under inlet distortion, the performance of twin-spool turbojet engines is studied in this paper by means of numerical simulation.
基于畸变进气下压气机实验特性，数值模拟了畸变进气下双轴涡喷发动机的总体性能。
Hot gas Bypass Valve designed to allow only gas no liquid - to inlet of refrigerant compressor.
热气旁路阀设计，只允许任何液态气体-以进口制冷剂的压缩机。
A first order lagging equation is used to acount for dynamic effects. This model can simulate the compressor response to inlet temperature transients and find the critical stage.
该模型可以模拟进口温度（或压力）瞬变下压气机的逐级响应，寻找首先失速的关键级。
A stage - by - stage simulation method is introduced for analysis of inlet total pressure distortion effect on the multistage axial flow compressor characteristics.
介绍了1种分析进口总压畸变对多级轴流压气机特性影响的逐级模拟方法。
Poor sealing effects of temperature probe of scroll of bearing box at air inlet side of the air compressor results in oil contamination of following pipeline of air compressor.
由于空压机进气侧轴承箱蜗壳温度探头密封效果不好，使空压机及其后续管道受到油污染。
Unloading inlet valves at partial stroke is one means of capacity regulating for reciprocating compressor, and it possesses economic, full-range and easy-using character.
往复压缩机部分行程压开吸气阀调节是一种调节范围大、操作简单且经济实用的排气量调节方法。
Vapor-liquid heat exchangers are often used to superheat the suction vapor of compressor and to subcool the inlet liquid of throttle valves in refrigerating system.
制冷循环中往往采用回热器，使压缩机吸气过热和膨胀阀入口液体过冷。
Pressing-off inlet valve is one of the methods of air-regulating for reciprocating compressor, and it possesses economic , safe and well-fixing character.
顶开进气阀进行气量调节是活塞式压缩机气量调节方法中的一种，它具有经济、可靠、结构简单及安装方便等特点。
Air regulating for reciprocating compressor with pressing off inlet valve was analysed particularly and the late research on such a system was introduced.
详细分析了活塞式压缩机顶开吸气阀排气量调节技术，并对新近研究工作做了介绍。
The disadvantages of a compressor muffler are analyzed, and a new scheme is proposed based on the measured noise spectrum at the suction inlet of the compressor.
分析某型号压缩机吸气消声器存在的不足，在测试压缩机吸气通道噪声源频谱的基础上提出消声器改进方案。
The fatigue rupture failure cause of the executing fork was analyzed for press off inlet valve of a piston compressor.
针对大型活塞式压缩机部分行程顶开进气阀调节装置，分析施力压叉产生疲劳断裂失效的原因。
It is illustrated that discharge temperature of gas cooler, efficiency of expander and degree of superheat at the inlet of compressor can exert more influence on the optimum high pressure.
结果表明，气体冷却器出口温度、过热度和膨胀机效率对最优高压压力的影响较为明显。
It is illustrated that discharge temperature of gas cooler, efficiency of expander and degree of superheat at the inlet of compressor can exert more influence on the optimum high pressure.
结果表明，气体冷却器出口温度、过热度和膨胀机效率对最优高压压力的影响较为明显。
应用推荐