It is mainly studied the testing methods of stability of axial compression steel members.
对轴心受压钢构件进行了稳定性检测方法研究。
Compression steel plate structure PC beam, is to place steel plate in bending area of bygone PC beam.
压缩钢板构造的PC梁，就是在以往的简支pc梁弯压区内配置钢板。
Objective: To study the therapeutic effects of "t" compression steel plate in the treatment of comminuted fracture of surgical neck of humerus.
目的：研究应用“T”型加压钢板治疗肱骨外科颈粉碎性骨折的治疗效果。
Can give the steel ability of the more deformation and compression, can process more and better standard parts, such as steps screws or other screws with large deformations, etc.
可使钢材承受更大的变形及压缩，可以加工更多更好地标准件，如台阶螺丝或变形量较大的螺丝等。
The microstructure evolution of Q235 plain carbon steel in multi-pass hot deformation was investigated by means of hot compression simulation.
利用热模拟压缩变形实验研究了Q 235碳素钢多道次热变形及后续处理过程的组织演变规律。
Large main compartment with steel wire mesh compression system and two large inside lid zip mesh compartments.
大型主舱与钢丝网压缩系统和两个大型拉链网车厢内盖。
Adverse condition of concrete in tension and steel joist in compression occurs at inner support regions of continuous composite steel concrete beams.
连续组合梁在内支座处的负弯矩区段会出现混凝土板受拉、钢梁受压的不利局面。
When stainless steel is bent, the metal towards the outside of the bend is in tension and the metal towards the inside is in compression.
当不锈钢弯曲时，朝向弯曲外面的不锈钢被拉紧，朝向弯曲内面的不锈钢被压缩。
Electrical connections are made using flat aluminum braids, held in compression to the cold end circumference by stainless steel spring clamps.
电路依靠喷铝部连接起来，用不锈钢弹簧夹子固定在冷端部的周围。
The steel fiber concrete with fly ash and slag of different ages by ultrasonic detection and compression strength were tested.
对一批不同龄期的掺粉煤灰或矿渣的钢纤维混凝土试件进行了超声波检测及抗压强度试验。
Steel-concrete composite bridge is a new type structure in which the steel and the concrete are integrated by connectors to take advantage of the respective properties of tension and compression.
钢—混凝土组合梁利用了钢材受拉性能好、混凝土受压性能好的特点，将两种材料通过连接件组合成整体而共同受力的一种新型结构。
The superplasticity research was carried out under constant temperature compression deformation for salt-bath cyclic quenched and high frequency hardened T10A steel.
采用盐浴加热循环淬火和高频感应加热淬火对T10A钢进行组织超细化预处理，然后在恒温压缩变形条件下进行超塑性研究。
A shock wave generated by an underground explosion was used to perform the shock compression measurement for the 2169 steel sample.
利用地下爆炸产生的冲击放进行2169钢冲击压缩测量。
Based on axial compression tests of 18 lightweight aggregate concrete-filled steel tube (LACFST) long columns, the behavior of LACFST long columns was studied and compared with that of normal CFST.
对18根不同长细比和含钢率的钢管轻集料混凝土长柱进行轴压试验，研究了钢管轻集料混凝土长柱在轴心压力下的受力性能，并与钢管普通混凝土进行了对比。
As structural component, square hollow steel sections have favorable properties for resisting compression, bending and torsion.
方管作为结构构件，在压、弯、扭方面具有优越的性能。
As steel fiber is added to high shength concrete, the value of ductility coefficient increases 41. 3 %, and the ultimate compression stain increases 30.6%.
在各项条件基本相同的情况下，由于钢纤维的作用对延性系数的提高幅度达41．3％，对极限压应变的提高幅度达30．6％。
The boron-doping technology and metallurgical micro-structure of die steel are discussed from the angle of its resistance to repeated shock compression.
结果指出：模具钢渗硼层在多次冲击压缩载荷下发生一定的塑性变形。
According to researches on SRC column with steel circle pipe, the calculation methods of the axial compression ratio and load bearing capability of normal section are put forward.
根据对配有圆钢管的钢骨混凝土柱的研究结果，介绍了配有圆钢管的钢骨混凝土柱的轴压比、正截面承载力的设计计算方法，并给出了工程应用的实例。
Present gun barrels are made up of high-strength steel. This type of material possess the differential strength in tension and compression.
现代火炮身管多用高强度钢制造，这类材料在拉伸和压缩时的力学性能存在明显差异。
Ultimate compression strain of Concrete-filled steel tube (CFT) is one of important parameters for seismic design of CFT structures.
钢管混凝土极限压应变是钢管混凝土结构抗震设计的重要参数之一。
The microstructure evolution of Q235 plain carbon steel in multi-pass hot deformation was investigated by means of hot compression simulation.
利用背散射电子衍射取向成像技术分析了在热模拟单向压缩条件下Q235碳素钢应变强化相变中铁素体晶粒的取向（差）变化特点。
The texture evolution of ferrite during warm compression of Q235 low carbon steel was determined quantitatively by means of orientation mapping based on the EBSD technique.
利用背散射电子衍射取向成像技术定量分析了热模拟单向压缩条件下Q235碳素钢热变形时铁素体的织构形成规律。
So the unified computational method for the whole stability coefficient of axially loaded compression members of steel structure are discussed and presented in this paper.
本文就钢结构轴心受压构件整体稳定系数计算的方法进行了探讨，提出了统一计算的方法。
Glass based ceramic lined steel pipe without compression crack was made by a SHS centrifugal process.
用自蔓延离心法制备了无压裂纹的玻璃基陶瓷内衬钢管。
Then, a kind of model suitable for both high strength and average strength concrete filled steel tubular axial compression members is put forward.
最后，提出一种适合于钢管普通混凝土和钢管高强混凝土轴压构件数值分析中的混凝土本构关系模型。
Trial method of shaped steel axial compression members is analyzed in this paper.
分析了型钢轴压构件在试算法中的运用。
An axial compression test was carried out on a steel-high performance concrete composite bridge tower segment in order to study the mechanical behavior of composite bridge towers.
通过对钢-高性能混凝土组合桥塔节段进行轴压承载力试验，研究了组合桥塔的受力特性。
Through the limits applied on concrete compression strain and steel tensile strain, the deformation limits on RC beams and columns are developed.
通过混凝土受压应变和钢筋受拉应变的限值得到钢筋混凝土梁、柱的变形限值。
Through the limits applied on concrete compression strain and steel tensile strain, the deformation limits on RC beams and columns are developed.
通过混凝土受压应变和钢筋受拉应变的限值得到钢筋混凝土梁、柱的变形限值。
应用推荐