An exhaust port (20) allows dried air out of the compression chamber.
一排气口(20)让干燥空气的压缩会议厅。
Otherwise slight rotation would take place with that mechanism and orbiting scroll, resulting in asymmetric pressure within compression chamber pair and radial leakage.
在无径向柔性机构的情况下，防自转机构和涡旋盘会产生微自转，可导致压缩腔对压力不对称和产生径向泄漏。
Compression process: with the rotor rotation, compression chamber volume decreases, the gas compressed with the compression chamber until the exhaust port to the forefront.
压缩过程：随着转子旋转，压缩腔容积不断减小，气体随压缩直至压缩腔前沿转至排气口。
Thus, the oxygen concentration in air compression chamber is controlled below 23% and the reformed head cover is applicable to air compression chamber for hyperbaric oxygen treatment.
改造后的输氧头罩适用于空气加压舱内治疗时使用，能大大提高安全性和治疗的有效性。
Besides establishment of a thermodynamic model, oil movement and distribution within the compression chamber is analyzed, and a model quantifying the influence of oil injection is built up.
以准确量化喷油的影响为重点对喷油螺杆压缩机工作过程进行了研究。
Methods 18 rats were divided into 3 groups randomly. They were placed into compression chamber to study by compression and decompression in lucid state so that the decompression injury was formed.
方法大鼠18只，随机分为3组，清醒状态置于加压舱内，进行加、减压实验，造成急性减压损伤。
This paper presents a newly designed compression ignition divided chamber combustion system of the natural gas engine.
本文介绍了压缩着火天然气发动机的一个新的燃烧系统，这个燃烧系统具有分隔式燃烧室。
Effects of different compression ratios (13 ~ 19) and designed combustion chamber shapes on combustion and HC emissions were studied.
设计了不同参数的燃烧室，研究了不同压缩比(13 ~19)和燃烧室形状对柴油机燃烧及HC排放的影响。
Theoretical calculations are made of the effect of the jet hole on gas motion inside the TJ-jet combustion chamber of 492qs gasoline engine during compression and combustion processes.
通过理论计算研究了492QS汽油机射流孔对射流燃烧室内气体运动的影响。
So we improve the old truck gasoline engine with side valve by raising its compression ratio to 7.2: 1 by using partial spherical chamber. The intake system is also improved.
为此，对一部分解放牌侧置气门汽油机的燃烧室改造为球形，提高压缩比到7.2：1，并改进进气系统，从而使功率、扭矩和燃油经济性都有所提高。
Another application of stage-by-stage model is to investigate the post-stall behavior in the compression system which consists of one compressor and one combustion chamber.
逐级模型的另一种用途是用来研究压缩系统的过失速行为，本文研究了由压气机和主燃烧室组成的压缩系统。
This paper presents a finite-volume method for flow characteristics simulation in a combustion chamber with a flat-topped piston during the compression stroke.
本文提出压缩冲程期间计算平顶活塞燃烧室流动特性摸拟的有限容积法。
The three-dimensional digital model of compression equipment and chamber are obtained based on UG package.
利用UG软件建立了压缩装置的三维实体模型。
The shape of the suction chamber decides the inlet velocity distribution of the compression grade in the multiphase pump, and affects the performance of the multiphase pump to a degree.
吸入室的形状决定了混输泵的压缩级进口的速度分布，对混输泵的性能有一定的影响。
The equipment includes the upper compression bar (3), the lower compression bar (4), the heater coil (6) and a working chamber (12), etc.
设备包括上压杆(3)、下压杆(4)、加热线圈(6)、工作腔体(12)等。
The equipment includes the upper compression bar (3), the lower compression bar (4), the heater coil (6) and a working chamber (12), etc.
设备包括上压杆(3)、下压杆(4)、加热线圈(6)、工作腔体(12)等。
应用推荐