The imaginary inputs satisfying all the compatibility equations are the true kinetostatics parameters.
满足所有相容性方程的虚拟赋值变量的值即为其真实值。
By using the generalized characteristics method, the compatibility equations on the characteristics are obtained. And the wave propagation of the finite length cylindrical shell is analyzed.
应用广义特征线理论得到了沿特征线上的相容方程，并采用数值积分方法分析了有限长圆柱壳的波传问题。
On the basis of classical lamination theory and large deflection hypotheses of plate, the equilibrium and compatibility equations of simply supported composite laminated plates were obtained.
基于经典的层合板理论及板的大挠度基本假设，得到四边简支层合板的非线性运动方程及变形协调方程；
Taking a proper asymptotic sequence and perturbation technique, the control equations, the continuity, equilibrium and compatibility conditions of the first order and second order are derived.
采用小参数摄动法，导出了系统的一阶和二阶控制方程，边界条件，连续条件，平衡条件及相容条件。
In this paper, the mathematical model of compatibility check of flight test date is set up based on the kinematic equations with six freedom of aircraft.
本文采用飞行器六自由度运动方程组，建立了飞行试验数据相容性检验的数学模型。
Applying the characteristics theory to the equations, the characteristic compatibility relations are obtained, and the boundary conditions are established.
将特征线理论用于这些方程，得出了特征相容关系，并由此确定了定常流动中的边界条件。
The characteristic velocities and the compatibility relations along characteristics are derived from the system of equations for the motion of thin magnetic flux tubes.
从细磁通量管运动方程组导出了特征速度、特征线及其相容关系。
Exact solutions to the resulting equations are constructed via the compatibility of the generalized conditional symmetry and the considered equation.
并且依据广义条件对称和所考虑方程的相容性求得了相应方程的群不变解。
The analysis also shows that the nonlinear terms in the dynamic system equations cause the stochastic state to jump so that the circuit state can reach compatibility with the constraint equations.
同时发现动力学系统中的非线性函数项（或非线性元件）能够发生跳跃随机性和产生跳跃随机曲线，以使电路的状态轨迹达到与约束方程相容的状态。
The basic principle of load distribution method is that the equations of distribution coefficients of loads are set up according to the compatibility conditions of deformation at nodals.
荷载分配法的基本原理是根据节点的变形谐调条件列荷载分配系数方程。
And then the governing equations of the block dynamic system are deduced on the basis of the virtual work principle, the deformation compatibility condition and the constitutive relations.
随后，基于虚功原理、变形协调条件和本构关系，推导了块体动力系统的控制方程组。
No matter how complex the edge conditions are, it is not difficult to set up the equations of compatibility of deformation, therefore the internal forces of oblique …
由于不论如何复杂的边界条件，列变形谐调方程都不困难，所以用荷载分配法可解各类支承条件斜放类交叉梁系的内力。
No matter how complex the edge conditions are, it is not difficult to set up the equations of compatibility of deformation, therefore the internal forces of oblique …
由于不论如何复杂的边界条件，列变形谐调方程都不困难，所以用荷载分配法可解各类支承条件斜放类交叉梁系的内力。
应用推荐