As a comparison, pressures three miles below the ocean surface are less than 7, 000 pounds per square inch.
来一个对比吧。 在海面下3英里的深度，水压也不到7000磅/平方英尺。
For comparison, scientists believe that Pluto's surface only gets down to about -300 degrees Fahrenheit (-184 Celsius).
相比之下，科学家认为冥王星表面的最低温度仅仅为零下184摄氏度。
TrES-2b orbits its star at a distance of just 3 million miles (by comparison, we're about 93 million miles from our sun), which leads to surface temperatures on TrES-2b of more than 1, 800 degrees.
TrES - 2 b距它所环绕的恒星只有3万英里(相比而言，我们距离我们的太阳有93万英里)，这就使得TrES - 2 b表面温度超过1800度。
In this paper accuracy of sensory certification and relative certification of surface, roughens for calliper planes measured using comparison samples was analyzed.
本文分析了卡尺测量面表面粗糙度感官检定和与比较样块比较检定的准确率。
Comparison of a set of measured data to numerical computations of the backscattering coefficients for actual natural rough surface by the classical and new perturbation methods were given.
采用传统微扰法和基于圆柱曲面修正的微扰法，计算了实际粗糙面掠入射时的后向散射系数，并与有关测量值进行了比较。
The species and composition of contamination on the surface of cold rolled steel plates were investigated. Comparison between china made and imported cold rolled steel products was carried out.
研究和分析了国产冷轧低碳钢板试样表面污染物的种类及成分，并且与进口同类钢板进行了比较。
Composition and surface properties of obtained composite sub-micron particles have been studied in comparison with those of ferrite-free PLGA sub-micron particles.
将由此而来的混合亚微粒的组分和表面性质与不含铁氧体的PLGA亚微粒进行了对比研究。
Using scanning electron microscope observation comparison carbonization boride cermet processing surface elastic performance and processing surface deterioration level.
利用扫描电镜观察、比较碳化硼陶瓷加工表面弹性性能及加工表面变质层。
Exact solution of a statistical model for laser beam scattering from diffusing surface has been obtained, the comparison with the approximation of center of gravity has been made.
本文对激光束在漫射表面上散射的一类统计模型给出了严格解，并与“质心近似”所得结果作了比较。
With the introduction and comparison of methods of analysing geology trend surface, the method of neural network is presented to analyse geology trend surface.
本文通过地质趋势面分析不同种方法的介绍和对比，提出采用两种人工神经网络模型相结合的方式对地质趋势面进行分析。
Various complex unsteady states were observed by the comparison of the catalyst surface temperature oscillations with the CO_2 concentration oscillations in products.
通过对比催化剂表面的温度振荡和产物中CO_2的浓度振荡观察到各种复杂的非稳态过程，加深了对产生化学振荡的机理认识。
Meanwhile the open water characteristics of the propeller were predicted by using the lifting surface theory. Comparison with to experimental data showed that calculation errors are acceptable.
应用升力面方法理论计算螺旋桨切割前后的敞水性能，与试验值的比较表明计算值误差在可接受的范围内。
For coating a waterproof layer on the CR surface, comparison and selection have been made among several biocompatible materials.
采用壳聚糖棒材外表面涂覆物理防水层的思路，对各种生物相容的疏水材料进行了选择和比较。
It was also suggested that the comparison of the surface area should be based on per volumetric adsorbent.
提出了对于定容吸附储存，吸附剂比表面大小的比较应以单位体积吸附剂的比表面为基准。
The observations of X-ray surface brightness are also used to derive the radial distribution of gas for comparison.
该三个星系团的X射线面亮度观测结果也被用于构建其气体密度和温度分布以作比较。
A comparison with the drilling result shows the reliability of the depth contour map for the top surface of the granite batholith.
与钻探结果对比表明，该花岗岩基顶面深度图结果可靠。
Effects of the casting technological factors on the size and uniformity of surface grains of turbine blade castings in ni based superalloy were studied by comparison of experimental results.
对比研究了铸造工艺参数对镍基高温合金叶片表面晶粒度和晶粒均匀度的影响。
Surface grain refinement of turbine blades in Ni based superalloy K18 were studied by comparison of experimental results in different alloys and mold surface materials.
选用K 18合金和纯金属镍及不同的面层细化料，通过实验对比研究了镍基高温合金叶片表面晶粒细化机理。
First, because the comparison is conducted between the two surfaces, relative to the original surface, if the shape and position occurred minor differences, the above method could not work.
首先，比较是在两个表面之间进行的，如果一个表面后来的形位相对于原来的形位发生了微小差异，则上述方法对此无能为力。
The emulsification of single emulsifier, physical mixed emulsifier and phospholipids membrane emulsifier were evaluated by the method of surface (interfacial) tension isothermal curve comparison.
采用表(界)面张力等温线比较法评价了单一乳化剂、物理混合乳化剂、混合磷脂膜乳化剂的乳化能力，为乳化剂的选择提供依据。
The characteristics of LST in most land of East Asia and that of sea surface temperature(SST) in the south of Taiwan Strait and the Yellow Sea were also analyzed as comparison.
作为比较，东亚部分陆地的地表温度与台湾海峡南部、黄海的海表温度及其日变化、季节变化一并进行了分析。
The plastic instability behavior of the laser-textured steel sheet with defined surface features is investigated. Comparison is made with the normal sheet taken from the same coil of meatal sheet.
试验研究了具有一定形貌及粗糙度的激光毛面薄钢板及同材质普通薄钢板的失稳行为。
It is shown that the optimal hydraulic section for compound canal has smaller section area and narrower breadth of water surface than trapezoidal canal by calculation and comparison.
并通过算例比较证实，复合断面水力最佳断面的面积和水面宽度比梯形水力最佳断面的小。
Seeking to avoid stopping at the surface of the work, the author puts more focus on comparison of aesthetics and historic meaning behind form and style.
力求避免只停留在对作品表面，而是更加注重在形式、风格背后的美学精神与历史内涵的比较。
In this paper the mechanical properties of the different hybrid modes and UHMWPEF surface modification for CF/UHMWPEF composites are investigated through tests and comparison.
本文对不同铺层方式的碳纤维（CF）和高强聚乙烯纤维（UHMWPEF）混杂复合材料的力学性能进行测试，同时对UHMWPEF表面处理前后的混杂复合材料性能进行了比较。
The influence of disc dimension parameters, velocity, soil properties, tool surface properties on the disc coulter force were analysed by comparison with the experimental results.
结合试验研究结果，分析了圆盘参数、工作速度、土壤特性和表面材料等对圆盘受力的影响规律。
Through comparison testing of the surface of reflowing holes of the external-mix self-sucking pump, the best design is determined.
对外混式自吸泵的回流孔面积进行对比试验，确定最佳设计方案。
All kinds of surface strengthening technique have been introduced with introduction to effect on die service life and comparison among respective application.
在分析各种表面强化工艺优劣的基础上，介绍了这一技术对模具寿命的影响。
Made in this paper is a comparison between the hidden surface algorithm and shading method in generating three dimension vivid graph.
对三维形体真实图形生成中的隐藏面消除算法和可见面明暗处理方法进行了比较研究。
Made in this paper is a comparison between the hidden surface algorithm and shading method in generating three dimension vivid graph.
对三维形体真实图形生成中的隐藏面消除算法和可见面明暗处理方法进行了比较研究。
应用推荐