Equipment designers can minimize the effects of these mismatches or "unbalances" through judicious choices of input and output stage circuit topologies and common-mode impedances.
设备设计师能通过审慎地选择输入输出级电路的拓扑和共模阻抗来最小化失配或“非平衡”的效应。
This wide input common-mode range is obtained with standard low voltage op amp supplies.
这种宽输入共模电压范围是用标准低压运算放大器电源实现的。
These error sources include offset voltages, noise and common-mode current, and reversal errors.
这些误差来源包括偏置电压、噪声和共模电流以及反向误差。
When inputs to most JFET op amps exceed the common-mode range for the part, the output may reverse polarity.
当大部分JFET运放的输入超过它的共模范围时,输出可能发生极性翻转。
In this situation, the CMRR (common-mode rejection ratio) of the input differential amplifier was unsatisfactory.
在这种情况下,输入差分放大器的CMRR 不令人满意。
In any balanced circuit, odd harmonics circulate in a differential path, while even harmonics flow in a common-mode path.
在平衡电路中,节点处奇次谐波流过差分路径。偶次谐波流过共模路径。
A new common-mode interference reduction method which USES a group of precision analog switches is presented in the paper.
本文介绍一种利用精密模拟开关组的共模干扰抑制方法。
This type of interference is induced equally into both differential inputs, and therefore appears as a common-mode signal.
这种类型的干扰一并来到两个差分输入端,因而出现一个共模信号。
Again, consider using AMPLIFIERs that exhibit a smooth input bias current transition throughout the applied input common-mode voltage.
再者,所用的放大器也要考虑在加到输入端的整个共模电压(范围内)输入偏置电流转换保持平滑。
The single phase H-bridge inverter can generate common-mode voltage due to the sine pulse width modulation(SPWM)and vector controller.
采用脉宽调制和矢量控制的单相H桥逆变器会产生共模电压,后者会对逆变器、电机及其相关设备产生危害。
With the limitation to the ground capacitance by inverter, it is difficult to suppress the severe common-mode noise by large CM filter.
由于逆变器电源对输出接地电容的限制,对严重的共模电磁干扰难以用大容量的共模滤波器抑制共模噪声。
This article proposed the technology of estimation common-mode noise with the energy of switching cycle and FPGA as the main component.
本文提出了用FPGA作为主要器件、以能量为指标的共模噪声评估技术。
This article proposed the technology of appraising common-mode noise with taking the energy as the datum and FPGA as the main component.
文章提出了用FPGA作为主要器件、以能量为指标的共模噪声评估技术。
In a digital common-mode noise attenuation system for switching power converters, one of the key issues is the estimation of common-mode noise.
在电力电子开关变换器数字化共模噪声抑制系统中,一个重要环节就是共模噪声的评估。
In the system of digitalized attenuation common-mode noise of switching mode converters, one of the keys is how to estimate the common-mode noise.
在电力电子开关变换器数字化共模噪声抑制系统中,一个重要环节就是共模噪声的评估。
VCM, the common-mode voltage between the sensor and the signal ground, results from nearby noise sources resulting from stray capacitive coupling.
传感器和信号地之间的共模电压VCM来自周围杂散电容耦合带来的噪声源。
The essential characteristics of transducer zero-excursion caused by common-mode interference are approached by means of a transducer equivalent circuit.
利用传感器等效电路,分析了共模干扰造成传感器零点变化的实质。
Any common-mode current (ICM) that may be present flows from the voltmeter input lo to instrument chassis common, through earth ground to voltage source ground.
可能出现的共模电流(ICM)从电压表的输入低端流到仪器的机箱公共端,经过大地再流到电压源的地。
Traditional diode-clamped converters have high voltage variation rate, common-mode voltage and harmonics, which make the design of its output filter complicated.
传统二极管箝位变换器的电压变化率和共模电压较高,且波形谐波含量较大,使得输出滤波器的设计变得复杂。
The main contents are made up of the following: common-mode transformer design, hardware design, FPGA function design, and the configuration and debugging of FPGA.
本文的主要内容有:共模变压器的设计,硬件电路的设计,FPGA功能设计,以及FPGA的配置和调试。
Basing on dominant effect theory in EMC, conducted emi and radiated emissions of twisted-pair wires are mostly respectively due to differential-mode currents and common-mode currents.
本文根据电磁兼容优势效应理论,推导出双绞线传导干扰主要由差模电流引起,辐射干扰主要由共模电流引起。
Based on dominant effect theory in EMC, the conducted emi and radiated emissions of twisted-pair wires are mainly due to differential-mode currents and common-mode currents, respectively.
为此根据电磁兼容优势效应理论,推导出双绞线传导干扰主要由差模电流引起,辐射干扰主要由共模电流引起。
The high precision and large current controller are used widely. But in the situation where there is high common-mode voltage, the detection circuit of the output current is very complex.
高精度大电流控制器有着广泛的应用,但在高共模电压情况下输出电流的检测电路比较复杂。
A measurement amplifier circuit is designed, which consists of circuits of differential amplifier, a common-mode rejection, double-end and single-end conversions and programmed gain amplifier.
设计了一个测量放大器电路,它由差动放大电路、共模抑制电路、双端单端转换电路和程控增益放大电路组成。
The problem in the communication between DSP and PC based on RS-485 is presented, and the solution of common-mode disturbance and EMI which are generated by incorrect ground connection is stated.
DSP与PC机的通讯以RS-485为基础,分析了RS-485总线在组网过程中因地线的不正确连接引发的共模干扰和EMI问题,并提出了解决方法。
Electromagnetic interference (EMI) in high-speed digital circuit is mainly generated by Common-mode (CM) noise, and the CM inductance is responsible for CM noise magnitude.
共模噪声是高速数字电路产生电磁干扰的主要原因,而共模电感又是共模噪声大小的决定因素。
If your system boots into text mode (a common configuration for servers to conserve overhead for services), then you are already at a console when you execute a text login.
如果您的系统引导进入文本模式(为了降低服务开销,服务器通常是这样配置的),那么您在以文本形式登录后就已经在控制台中了。
Results. Gel extrusion from the posterior annulus was the most common mode of disc failure.
结果:最常见的椎间盘破坏方式是凝胶剂自纤维环后方挤出。
Objective: To study the relationship between the common mode of HBV immunological marker in serum and the quantity of HBV-DNA.
目的:探讨乙肝病毒免疫标志物常见模式与HBV - DNA量的关系。
These include event TAB support within the property grid for control events, toolbox support within source mode, and a variety of other common asks and improvements.
这些改进包括属性面板中对于控件事件标签的支持,源代码模式下的工具箱支持,以及一些经常被提及的功能改进。
应用推荐