It is difficult to have good performance for chain boiler combustion control system due to large delay time, varying coal's quality and steam load.
大纯时延、煤种多变和蒸汽负荷频繁变化是链条炉难以进行良好燃烧控制的原因。
To move its load through the water, it boasts the largest combustion engine ever built-generating horse power equivalent to 1, 000 family-sized cars.
从水中卸载货物，它有最大的燃机-产生的马达功率相当于1000个家庭轿车的功率。
The experimental results show that the above methods are effective in controlling HCCI combustion and enlarging engine load range.
实验表明以上方法可以有效控制HCC I燃烧，拓宽HCC I发动机运转范围。
The experimental results on S195 diesel engine have showed that the engine with new structure of main combustion chamber has better performance obviously in full load and overload.
并给出了在S195柴油机上的试验结果。试验表明，新型结构设计能明显改善高负荷及超负荷时的经济性。
The result shows that the rate of pressure rise and the heat release are the main dynamic load factor that affects the combustion noise.
研究结果表明：气体动力载荷因素中，压力升高率和放热率是影响燃烧噪声的重要因素。
Based on practical situations, the article introduces the influence of different type fan to gas instantaneous water heater combustion thermal efficiency when heat load changes.
文章从实际情况出发，介绍了燃气快速热水器在热负荷变化时使用不同类型的风机对燃烧热效率的影响。
The maximum steam load produced by the bark was determined by the bark fixed combustion temperature and the capacity of attemperator system when the basic steam load was given.
在一定的基本蒸汽负荷下，燃树皮产汽负荷的上限值可根据流化床中树皮的稳定燃烧温度和减温系统的工作能力来确定。
The upper limit of operating load of the fluidized bed is determined by the basic load, stable combustion temperature of barks and the ability of the attemperation system.
流化床实际运行负荷的上限值可根据基本蒸汽负荷、流化床中树皮的稳定燃烧温度和减温系统的工作能力来确定。
The parameters such as POS concentration, POS heating temperature, fuel load and oxygen content have high influence on combustion efficiency.
石油焦渣油浆的浓度、油焦浆的加热温度、负荷和氧量对其燃烧效率有很大影响。
The results prove that the movable heat insulate layer has obvious effects on improving the temperature profile in furnace and combustion efficiency of coal fired boiler at low load.
试验表明：可调卫燃带对改善锅炉低负荷时炉内温度分布及提高燃烧效率具有十分明显的效果。
Using gray system theory, the influence of swirl inlet on the combustion process of TBD620V12 diesel engine under low load condition is studied.
应用灰色系统理论研究了低负荷下进气涡流对TBD620 V 12柴油机燃烧过程的影响。
The design method was put up according to the base steam load when the character of the combined combustion boiler was taken into account of bark CFB and pulverized coal firing.
针对树皮流化床-煤粉复合燃烧锅炉的特点，提出了流化床按基本蒸汽负荷设计的思路。
The existence of overmuch residual exhaust gas together with its over mixing with fresh charge is one of the main causes of unstable combustion at low load.
缸内残余废气过多以及废气与新鲜空气的过度混合是小负荷时燃烧不稳定的一个主要原因。
The cyclic variation of the combustion pressure in the cylinder of a four-valve gasoline engine was analyzed at low speed and light load with the CB-466 combustion analyzer on the engine test-bed.
在发动机试验台上，用CB-466燃烧分析仪对四气门汽油机低速低负荷燃烧压力循环变动进行了试验研究。
It is found that mild combustion is of wide fuel flexibility and load flexibility, which reflects the feasibility of mild combustion of gas turbine combustor application.
研究还发现柔和燃烧具有较高的燃料适应性和变负荷性能，验证了柔和燃烧应用于燃气轮机燃烧室的可行性。
There are many kinds of burners for stable combustion at low load in the markets, but all these burners have some defects.
目前市场上用于低负荷稳燃的燃烧器种类很多，但都存在着一些缺陷。
Besides, the excess air or excess load will cause flame lift, combustion exacerbation and flame off, and that needs auxiliary flame and flame retention by inactive substance.
这就需要优化燃烧器的结构尺寸，再者，当空气量过多或超负荷下，发生离焰，导致燃烧恶化、火焰熄灭，需要有辅助火焰和钝体稳焰。
The stable combustion over a wide load range is one of the key issues for HCCI combustion. In this paper, the diesel-fueled HCCI combustion was achieved.
实现宽广负荷范围内的稳定燃烧是目前HCCI燃烧研究的热点之一，而HCCI燃烧在高、低负荷时的工作不稳定性是影响HCCI燃烧实用性的重要问题之一。
The combustion performance of the engine was obtained for an equivalence load with different oxygen concentrations of combustion air.
利用燃烧分析仪对相同负荷状态下不同氧气浓度富氧燃烧时发动机的燃烧特性进行分析。
This paper introduces the application and energy saving result after unit 2 of Zhangjiakou Power Plant adopted less oil ignition and low load stable combustion technology.
介绍张家口发电厂2号机组采用少油冷炉点火和低负荷稳燃技术后的使用情况和节能效果。
Through the operating data analysis of a 600MW load generating set, the major factors of steam temperature fluctuation was from the combustion disturbance.
通过对一台600MW机组运行数据进行分析发现，汽温波动的主要因素来自于燃烧扰动。
Adjust the proportion of combustion need to automatically adjust according to load and display the power of the size of fire-power, intelligent heating more comfortable.
比例调节燃烧，根据负荷需要自动调节燃烧功率并显示功率大小，智能化的供暖更加舒适。
Has the coal to plant the compatibility broadly, the load control characteristic good, the combustion efficiency high, the environmental pollution is small and so on the merit.
具有煤种适应性广、负荷调节性能好、燃烧效率高、环境污染小等优点。
In this paper, the necessity of stability combustion technique of boiler under low load as well as its current status and prospect is discussed firstly.
本文首先论述了锅炉低负荷稳燃技术现状和发展趋势及研究的必要性。
A lean mixture combustion system is presented in this paper. And the test effect of fuel injection time, fuel adjustment, miximum load speed and emission characteristics are analysed.
介绍了一种汽油机的快速稀燃系统，并对该系统的喷油时刻，燃油调整特性，外特性及排气性能等进行了试验分析。
After the burners were retrofitted, the goal of stable combustion is achieved and the minimum load without oil can lower to 65%.
燃烧器改造后，锅炉的稳燃能力提高，不投油最低负荷达到了65%。
The transformations of tiny-oil ignition and stable combustion technology were started for meet low load stable combustion on Shaoguan Power Plant Unit 10 "W"-type boiler.
为了满足韶关电厂10号机组“W”型锅炉低负荷稳燃，开展了微油点火及稳燃技术改造。
It is difficult to have good performances for chain boiler combustion control system due to much no-load time and variation of coals quality and steam load.
大量延时空载、煤种多变、蒸汽负荷频繁变化是链条锅炉难以进行良好燃烧控制的原因。
After the improvement, the stable combustion test load without firing oil is as low as 45% of rated load, which greatly enhanced the ability of in depth peak load cycling.
改造后其不投油稳燃试验负荷达到了45%，大大提高了锅炉的深度调峰能力。
In the oil combustion, using top gun, the upper wind at a heat load of boiler blower gathered, part of the furnace temperature is high, reaching the ash melting point, resulting in boiler coking.
在投油稳燃时，运用上层油枪，使得上层一次风处热负荷会集，锅炉鼓风机部分炉温高，到达灰熔点，致使锅炉结焦。
应用推荐