Clamp 4 is 4-wire signal output; as long as signal connection is correct, it may be connected to other clamp directly to measure battery.
夹具4是四线法信号的输出，只要信号连接正确，则可以直接与其它夹具连接对电池进行测试。
The output of the part was large so that the requirement for identical dimension was high. Through analysis of clamp structure, forming process was determined.
该零件产量较大，对尺寸的一致性要求高，通过对该夹簧零件结构和成形工艺的分析，确定该零件成形过程。
Because the clamp effect of DC voltage source, AC side output the rectangular wave voltage waveform, and it has nothing to do with the load impedance Angle.
由于直流电压源的钳位作用，交流侧输出电压波形为矩形波，并且与负载阻抗角无关。
Meanwhile, the clamp circuit will limit the output voltage or current at a fixed value when they are abnormal that caused by a DUT short circuit or other fault in order to protect the device.
当被测dut发生短路或其他异常导致电流或电压过高时，钳位电路会将输出电压或电流限制在一个固定值上，以保护器件不被损坏。
The input and output voltage ratings, VI and vo, may be exceeded if the input and output maximum clamp-current ratings, IIK and IOK, are observed.
如果观察输入和输出最大箝压电流额定值IIK和IOK，会发现输入和输出电压额定值VI和VO已经可能超过。
By using an active clamp circuit, the power transformer core is symmetrically reset. Zero voltage switching conditions are achieved over a broad input voltage and output current range.
利用有源钳位电路实现主变压器铁心对称复位，功率开关在宽输入电压和宽负载电流范围内零电压开关。
First confirmation of welding cable clamp and copper ears have reliable connectivity, will bolt copper ears, and welder polarity "-" reliable output link.
先确认电缆与焊钳和铜线耳已可靠连接，用螺栓将铜线耳和焊机极性为“-”的输出端可靠地连接在一起。
A clamp is used in some data sets to hold receiver output constant and avoid troublesome noise interference when no data signals are being received.
钳位电路用于某些数据设备可使接收器输出为常量，并且可在没有收到数据信号时避免噪音干扰。
A clamp is used in some data sets to hold receiver output constant and avoid troublesome noise interference when no data signals are being received.
钳位电路用于某些数据设备可使接收器输出为常量，并且可在没有收到数据信号时避免噪音干扰。
应用推荐