The quantization of a general mesoscopic RLC circuit with source by series-mounting is studied by using a new canonical transformation satisfied condition.
通过正则化变换 ，研究了耗散介观电容耦合电路的量子化 ，并讨论了系统中电荷和广义电流的量子涨落 。
With any power source, make sure you use a good robot power regulation circuit to help control power to your robot.
使用任何的电源，都要确保使用一个好的机器人功率调节电路去帮助你控制你的电源。
This simple circuit made up of a source, a load and two wires is seldom, if ever, met with in practice.
这种由一个电源、一个负载和两根导线组成的简单电路，在实际中即使能碰见也是很少的。
In fact, the rectified circuit with filter condenser in the direct current side is also the serious pollution source of the harmonics.
而实际上，直流侧含滤波电容的整流电路也是污染严重的谐波源。
The circuit equations were used to describe the winding connections to support voltage source with arbitrary waveform.
电路方程用于描述定子绕组连接及转子导条和端环连接，电压源可以是任意电压波形。
The paper introduces an approach of serial communication of PIC16F877 single chip computers with PC and provides a hardware interface circuit and a communication source program.
介绍了PIC16F877单片机与PC机实现串行通信的一种方法，并给出了硬件接口电路及通信源程序。
The principle of main parameter of the with the change of source frequency were given on the base of analyzing the equivalent circuit of induction motor.
在感应电动机等效电路的基础上，分析了当电源频率发生改变时，等值电路中主要参数的变化规律。
The evolution of quantum state with time in the time-dependent mesoscopic LC circuit containing source is studied in this paper.
研究了介观LC电路在外加电源作用下，系统量子态随时间的演化，分析了实现压缩态的动力学过程。
Since there is not the referenced voltage circuit, we have read a lot of information and designed a kind of bandgap source integrated with AD7520.
由于AD 7520中没有基准电路，所以在查阅了大量资料的基础上，正向设计了一款带隙基准源，并与AD 7520集成在一起。
With quantization scheme of canonical transformation and gauge transformation, Hamiltonian operator and wave function of a quantized RLC circuit with external source are obtained.
采用正则变换量子化以及规范变换方案，得到有源rl C电路量子化哈密顿算符及其波函数。
Based on the V-I characteristics of the mutual inductance branch, the loop equations of the mutual inductance circuit with the branch consisted of ideal current source along are derived.
本文从互感支路的伏安关系出发，导出了多线圈耦合网络具有理想电流源支路时的回路方程。
It provides the main system hardware circuit diagram and software flow frame and the main programme source code written with C51 language.
文章给出了主要的系统硬件电路图和软件流程框图，及用c 51语言编写的主程序源代码。
With its application of the electrical source design for the portable instrumentation, this paper introduces its characteristics and functions, and presents the practical designed circuit as well.
文中介绍了它的特性与功能，结合其在便携式仪器电源设计中的应用，给出了实用电路。
The PGA consists of the differential amplifier with variable source degeneration resistor and the DC-offset correction circuit.
该可编程增益放大器采用源极反馈电阻可变的差分放大器结构，且带有直流漂移校正电路。
The output characteristics of the bridge circuit which supplied with constant voltage source are analysed.
分析了恒压源供电下的桥路输出特性以及影响电桥电压灵敏度的各种因素。
A low power CMOS bandgap voltage reference source with a start-up circuit is presented based on the bandgap voltage theory.
运用带隙基准的原理，提出了一种带启动电路的低功耗带隙基准电压源电路。
The SPICE2(simulation program with integrated circuit emphasis)polynomial controlled source can be used to realize a number of nonlinear mathematical functions.
利用SPICE（集成电路通用模拟程序）的多项式受控源可以实现多种复杂的非线性数学方程。
It can be obtained the trace to the source of large direct current with self-balancing DC comparator through self-calibration circuit, addition circuit, compare circuit and multiplication circuit etc.
介绍了用自平衡比较仪通过自校、加法、比较和乘法等校准线路实现直流大电流量值的绝对溯源。
For the use of off-line switching mode power supply IC, an internal power supply circuit combining with a high voltage startup current source is proposed.
结合高压启动恒流源设计了一种用于离线式开关电源的内部电源电路。
The ideas of constructing of the control circuit of full-function controlled power source for arc welding are suggested in this paper, with their features analyzed.
提出了全功能弧焊电源控制电路的各类设计方案，分析了它们的特点；并提出了一种电源控制系统的电路设计方案；分析其基本工作原理和获得的各类电源输出外特性。
Cross Talk between parallel Microstrip lines due to Electric Field coupling for different R-C values Compared with weak coupling and zero source resistance assumption in the culprit circuit.
弱耦合及干扰源为零电源电阻与其他情况下平行微带线间电场耦合之串音比较。
The adaptive inverse control theory has been applied in the design of a constant current source with high precision, which can be made easily as simple circuit structure.
将自适应逆控制理论应用于高精度恒流源的设计，系统结构简单，易于实现。
Then it introduces the rotor earth fault monitoring based on the method of resistance bridge with source, and the interturn short circuit fault monitoring in generator rotor based on stator coil.
随后介绍采用基于有源电阻电桥进行转子接地短路故障监测与采用微分探测法进行转子匝间短路故障信号。
The signal processing circuit comprises a power source circuit, an amplification regulation circuit and a judge circuit connected with the amplification regulation circuit.
信号处理电路包含，一电源电路、一放大整型电路，以及与放大整型电路连接的判决电路。
The new-developed lamp with new lighting source and circuit system can be maintained with electricity.
采用新型光源与电路系统，并在结构上可实现带电维修。
Secondly, the control circuit of hot wire TIG welding with single power source was introduced in detail.
然后详细介绍了单电源脉冲热丝TIG焊机的控制电路。
In a definite temperature, the system will be in a mixed state, further, we obtain the quantum fluctuations in mesoscopic LC circuit with a power source in a finite temperature.
在确定的温度下，系统将处在混合态，进一步得到有限温度下含源介观LC电路的量子涨落。
The electric tool is also provided with a power source indicating device which is formed to the second circuit.
所述电动工具还设有电源指示装置，所述电源指示装置形成第二电路。
The electric tool is also provided with a power source indicating device which is formed to the second circuit.
所述电动工具还设有电源指示装置，所述电源指示装置形成第二电路。
应用推荐