With the analysis of some typical questions in electronic circuit experiments, the measure error coming from the frequency response of test instruments is discussed.
通过对电子线路实验中存在的几个典型问题的分析，讨论测试仪器频率特性给实验带来的局限性和测量误差，并提出了消除这种测量误差的解决方案。
This paper analyses the common causes for the breakdown in digital circuit experiments and gives measures to the elimination according to experimental teaching practice.
结合数字电路实验教学实践，分析实验常见故障成因并提出排除实验故障的方法。
This paper introduces the functions and characteristics of EWB and the importance of simulated experiments for electric circuit.
本文介绍了EWB的主要功能和特点以及电子技术虚拟实验的重要性。
Experiments showed that the drive circuit had characteristics of reliable performance, powerful drive energy, strong anti-interference ability.
试验表明该驱动控制电路具有性能稳定、驱动能力大、抗干扰能力强等特点。
Experiments upon the linearity and fault detecting capacity of the circuit are performed and the results are analyzed.
并对电路的线性度和故障检测能力进行了实验和分析。
We have investigated artificial neural network models based on an augmented Lagrange method, and accomplished the circuit structure and the simulation experiments.
研究了扩展拉格朗日方法的人工神经网络模型，实现了其电路结构，并进行了仿真实验。
In experiments we must avoid theoretic experiment, testing experiment, changing hardware into software and circuit replaced by program.
在开设实验课时应注意避免实验理论化、实验测试化、硬件软件和电路程序化。
It is confirmed by the experiments that this revised circuit has an accurate trigger point, wider range, higher preciseness of time-phase and better stability.
经实验证实，该电路触发点准确，具有更高的时相精度、宽的触发范围和很好的稳定性。
Using the device, the demonstrating and exploring experiments on logical circuit, which includes AND gate, NOT gate, OR gate, are illustrated.
利用该实验仪做了与门、非门、或门基本逻辑电路的演示实验及探究实验。
This article discusses that it is not suitable to establish virtual electronic experimental platform with circuit simulated software to replace the traditional practical electronic experiments.
本文论述在高等工科院校电工电子实验教学中不适宜用电路仿真软件建立虚拟电工电子实验平台来取代传统实物电工电子实验。
The experiments show that communication error and controlling state changes would occur when the interface circuit is affected by ESD EMP.
实验表明，该接口板在ESDEMP作用下，会出现通讯出错和控制状态改变等现象。
Pyrolysis experiments of waste printed circuit boards(WPCBs) were carried out by means of thermogravimetric analysis(TG) and a bench-scale fixed-bed pyrolysis reactor under low vacuum.
采用热重分析仪和固定床热解反应器对废旧电路板进行了低真空条件下的热分解实验。
Experiments on ISCAS89 benchmark circuit show that the proposed technique can be applied to circuits of reasonable sizes within acceptable time.
实验IS CAS89基准电路显示的可接受的时间内，该算法可以应用到电路的合理尺寸。
In a certain iron mine in Shandong province, the tailings condensing industrial experiments with swirl-classified thickening circuit composed of hydrocyclone and swirl clarifier were carried out.
采用旋流器与旋流澄清器组合的旋流分级浓缩流程在山东某铁矿进行了尾矿工业浓缩试验。
This paper discusses the methods of experiments and the treatment of data in making the flow circuit. Another way of making the flow circuit of characteristics in curve is found.
文章对制流电路的实验方法和数据的处理进行了讨论，得出制流特性曲线的又一制作方法。
It is validated by experiments, simulation and theoretic calculation that the macroscopical circuit model of plasma load of AIP and its relationship with microcosmic parameters of plasma is effective.
通过实验、仿真模拟和理论计算，验证了建立的电弧离子镀等离子体负载的宏观电路模型及其与等离子体微观参数间的关系是有效的。
The design principles and synthesis of frequency response are discussed. Circuit details and experiments results are given.
分析了频率特性，并给出放大器的实验结果。
According to the analyses and experiments, the effect on distributive capacitance is the first of all, and the wave's quality is improved to a certain extant by corrected bus driver circuit.
通过分析并经实验表明，长线的分布电容影响通常居诸因素之首位。改进长线驱动电路，在一定程度上，可改善其传输波形之质量。
The paper describes a typical design of buck circuit on MC34063 and proves that the design method is correct as result of experiments.
本文以降压电路设计为应用典型例子，介绍了MC 34063做为斩波型开关电源的设计计算方法。并经过实验结果证明该设计计算的切实可行性。
The hardware circuit of serial communication, PLC system configuration and the anti jamming measure are also introduced. Experiments show that the system is reliable and can improve production …
还介绍了串行通信的硬件电路、PLC系统设置和系统抗干扰措施等。
It is confirmed by the experiments that this revised circuit has an accurate trigger point, wider range, higher preciseness of time-phase and b...
经实验证实，该电路触发点准确，具有更高的时相精度、宽的触发范围和很好的稳定性。
The transient numeric simulation and relevant experiments of stator winding inter-turn short circuit fault of asynchronous motor are conducted using multi-loop mathematic model.
基于多回路数学模型，对异步电动机定子绕组匝间短路故障瞬变过程做了数字仿真，并完成了相关物理实验。
The application circuit of CMI-X-IS is designed , and exposed in the micro-focus X-ray. Static experiments have been done for material of different densities and sizes.
设计CMI-X-IS 图像传感器的应用电路，并将此应用电路置于微焦点X 射线机的照射下，对不同密度、不同尺寸的材料进行了静态实验。
The experiments show that the design is steady, reliable and low-cost, and achieves the functional demand of the interface circuit.
雷达实验可以证明该设计性能稳定、可靠、成本较低，很好地实现了接口电路的功能要求。
Through experiments, it proves that the circuit is correct and practical.
实验验证了该方法的正确性与实用性。
The formula and the necessary condition for component design in the circuit are given. Finally, the correctness of theoretical analysis is verified through experiments.
给出了电路元件的设计公式和必须满足的条件，最后用实验证实了理论分析的正确。
The remote experiments use the WCS 3 MPU application experimental system as experimental object, whose circuit can be reconstructed remotely.
该系统以南京大学电子系的WCS- 3微处理器实验系统为远程实验对象，可以远程重构实验电路。
The results of experiments show that the circuit can operate stably and reliably in high temperature and high pressure environment, and can satisfy the need of industrial production.
实验结果表明，该电路在井下高温高压恶劣环境中能够稳定可靠地长时间工作，完全满足工业生产作业的需要。
The results of experiments show that the circuit can operate stably and reliably in high temperature and high pressure environment, and can satisfy the need of industrial production.
实验结果表明，该电路在井下高温高压恶劣环境中能够稳定可靠地长时间工作，完全满足工业生产作业的需要。
应用推荐