When casting by section, there shall be no staggered steps between the sections.
分段浇筑时,段与段之间不得有错台。
A casting technique for fine holes in Cu alloy casting by pure Cu tubes as insert bodies is introduced.
介绍了以无缝纯铜管为镶嵌体,用镶嵌法在铸铜件上铸造细孔的方法。
This paper researched the microstructure characters on the cast-chromized layer of the iron casting and the steel casting by SEM and energy spectrum.
通过扫描电镜、能谱分析等方法,对铸铁件和铸钢件表面渗铬层的组织进行了研究。
Problems of falling chip, tool tipping and big noise are happened during cutting off main bearing caps made of gray casting by using combination milling cutters.
采用组合铣刀切断灰口铸铁材质的汽车发动机主轴承盖时,出现工件掉渣、刀具崩刃、噪声大等问题。
Influence of the initial temperature fields and mold hardness on the shrinkage defect of ductile iron casting by EPC process was mainly investigated in this paper.
本文主要讨论了初始温度场和铸型硬度对消失模铸造球墨铸铁件收缩缺陷的影响。
The sprue with square or hexagonal section is superior to the sprue with round section for technological yield of the casting by theoretical analysis and actual verification.
通过理论分析比较并通过生产实践得出,对于铸件工艺出品率,正方形或正六边形截面的直浇道优于圆形截面的直浇道。
Large diameter sleeve of steel casting by horizontal centrifugal casting machine has been introduced with discussion of technological measures of reducing pinhole and crack in sleeve.
本文主要介绍了卧式离心机铸造大直径铸钢套筒方法,讨论了降低套筒气孔和铸造裂纹的工艺措施。
The series of current transformers are resin insulated, fully enclosed and busbar type. The iron core is circular and the secondary winding goes around the core before casting by epoxy.
本型电流互感器的铁心为圆环形,二次绕组匀绕制在铁心圆周上,用环氧树脂混合料浇注成形。
The series of current transformers are resin insulated, fully enclosed and busbar type. The iron core is circular and the secondary winding goes around the core before casting by epoxy.
本型电流互感器的铁心为圆环形,二次绕组匀绕制在铁心圆周上,用环氧树脂混合料浇注成形。
应用推荐