On the upside, agriculture can also dispose of heat-trapping gases, by increasing the carbon content of soils.
从好的方面讲,农业可增加土地有机炭的含量,从而将温室气体固定下来。
And California has adopted a low-carbon fuel standard that will require oil companies to cut the carbon content of their petrol.
而且加州已经通过了低碳燃料标准,要求石油公司降低他们汽油中的含碳量。
Accurate prediction of the end-point temperature and carbon content of BOF molten steel is of great significance to raising the hitting rate of the end-point.
准确预报转炉冶炼终点的钢水温度与碳含量对提高转炉终点命中率具有重要意义。
The regional organic-carbon content is 0.36% on an average.
次为二叠系碳酸盐岩,全区有机碳平均含量为0.36%。
The higher the carbon content, the slower this rate must be.
含碳量越高,冷却的速率必须越慢。
The carbon content of macerals increases with increasing temperature.
煤岩组分中的碳含量随温度升高而增加。
We modified asphalt with a high carbon content mineral in this paper.
对高含碳矿物改性路用沥青进行了研究。
The optimal middle annealing temperature increases with the increase of the carbon content.
合金的最佳中间退火温度随碳含量的增加而升高。
The influence of new brightener dosage on the carbon content of zinc deposit was discussed.
讨论了新型镀锌光亮剂的用量对锌镀层含碳量的影响。
Imports would have to be certified as to their carbon content, and would be taxed accordingly.
进口货物的含碳量将被检验并相应地征收税款。
The key to increase boiler efficiency is real - time and precise monitoring carbon content of fly ash.
提高锅炉运行效率的关键问题之一是实时、精确地监测锅炉飞灰中的含碳量。
A dense, shiny coal that has a high carbon content and little volatile matter and burns with a clean flame.
无烟煤一种很亮的高密度煤,含炭量高,挥发性物质少,燃料时火焰纯净。
As the carbon content in steel increases up to around 0.60%, the possible hardness obtainable also increases.
随着钢的含碳量增加到大约0.60%,可能得到的硬度也增加。
The end carbon content and temperature were controlled, and the chromium yield was increased by using the model.
通过该模型可控制终点碳和温度以及提高铬的回收率。
If we want to obtain extruding cemented carbide whose properties is stable, we need to control its carbon content.
为了得到性能稳定的挤压硬质合金,需要控制挤压硬质合金的碳含量。
The hardness obtained from a given treatment depends on the quenching rate, the carbon content, and the work size.
通过给定的热处理所得到的硬度取决于淬火速率、含碳量和工件尺寸。
Thee hardness obtained from a given treatment depends on the quenching rate, the carbon content, and the work size.
通过给定的热处理所得到的硬度取决于淬火速率、含碳量和工件尺寸。
When the carbon content in carburized layer ranges from1.08% to 1.45%, the wearability increases with carbon content.
在渗层含碳量为1.08 ~ 1.45%的范围内,耐磨性随含碳量的增加而提高。
With the carbon content of dry ash-free basis increasing, ignition activation energy increases and reaction rate falls.
干燥无灰基固定碳含量增加,着火活化能增加,反应速率减小。
A steel with varying carbon content and, consequently, different critical temperatures requires a special heat treatment.
含碳量变化的钢具有不同的临界温度,因此需要特殊的热处理。
The method to solve furnace bottom rising and the factor affecting carbon content in FeSiAl alloy are emphatically expounded.
着重阐述了解决炉底上涨的方法和影响硅铝铁中碳含量的因素。
Identification of effective source rocks usually depends on geochemical parameters of well site such as organic carbon content.
有效烃源岩的识别往往依据井点的地化参数,如有机碳含量等。
It was figured out that the soil water content and plant biomass were the key factors to affect the soil organic carbon content.
可以认为土壤含水量和植物生物量是影响土壤有机碳含量的重要因素。
The carbon content being high, this kind of welding rod is not fit for welding machine parts that have to withstand high stress.
由于含碳量高,所以这种焊条不宜焊接必须承受高应力的机器部件。
The error sources of carbon content measurement by using burning gas volume method is analysed, and the uncertainty is evaluated.
分析了燃烧气体容量法测定碳量的误差来源,对测定过程中的测量不确定度进行评定。
Since the carbon content of these steels is so high, parts made from high carbon steel are normally difficult to machine and weld.
由于碳在这类钢中的含量很高,用高碳钢制作的零件通常很难被加工和焊接。
A viable technical solution of optimal value of unburned carbon content in the fly ash was developed by hybrid intelligence technique.
为了降低飞灰含碳量,提高锅炉运行水平,运用混合智能技术建立了飞灰含碳量目标值模型。
The results show that only vanadium carbides form at the low carbon content, and Cr and Mo element mainly dissolves into vanadium carbides.
结果表明:碳含量较低时,仅形成钒的碳化物,铬、钼元素主要固溶于钒的碳化物中。
The results show that only vanadium carbides form at the low carbon content, and Cr and Mo element mainly dissolves into vanadium carbides.
结果表明:碳含量较低时,仅形成钒的碳化物,铬、钼元素主要固溶于钒的碳化物中。
应用推荐