Electrical storage devices known as capacitors charge and discharge very quickly, but because they hold their charge on the surface of metal plates, their storage capacity is limited.
电荷存储元件——电容器，可以快速地充放电，但是因为电荷被存储在电容器金属片的表面，所以电荷容量有限。
With the engine performing at full capacity, the batteries would be drained in the space of 10 minutes -- if they were even chemically capable of withstanding such a rapid discharge.
当发动机的功率耗尽时，电池在10分钟内就会耗竭——如果连续不充电，它们还能靠化学反应支撑的话。
Filter plant, officials say, will work in Germany sunshine battery discharge, the staff should be full of electricity within 24 hours, prevent the battery will affect the storage capacity.
过滤器厂的负责人说，将德国阳光蓄电池放电工作后，工作人员应在24小时内布满电量，防止电池会影响存储容量。
The discharge characteristics of a secondary battery provide important information about the battery's capacity and life.
蓄电池的放电特性提供了关于电池容量和寿命的重要信息。
Germany sunshine battery deep discharge resistance is strong, 100% still can pick up on the load continuously after discharge, dominant charging can restore the revival capacity of 95% in January.
德国阳光蓄电池抗深放电能力强，100%放电后仍可连续接在负载上，在一月支配充电可恢回复复兴容量95%。
Most NiMH batteries can accept discharge rate up to 3 times its capacity. A higher discharge rate will yield lower capacity.
大多数镍氢电池可以接受3倍于自身容量的放电速率。高放电速率会导致释放更少的电量。
Full automatic temperature and pressure relief protection for commercial hot water supply tanks and heaters based on the latest ANSI Z21.22 listing requirements for temperature discharge capacity.
全自动温度压力安全阀，适用于商用热水供应容器和热水器，符合最新版ansi Z 21.22标准关于温度排泄能力的要求。
Fully automatic temperature and pressure relief protection for domestic hot water supply tanks and heaters based on the latest ANSI Z21.22 Listing requirements for temperature discharge capacity.
全自动降温减压安全保护功能，适用于室内热水供应容器和热水器，符合最新版ansi Z 21.22标准对于温度排泄能力的要求。
The experimental results showed that, before practical application, the initial capacity and comprehensive performance of stored battery can be obviously incr eased after some charge-discharge cycles.
结果表明：长期搁置后的蓄电池在使用前进行几次充放电循环，其有效容量和综合性能明显得到提高。
The main cause of discharge capacity decrease was the impedance of metal surface increased due to cell reaction.
电池反应所引起的负极金属表面阻抗的增加，是放电容量减小的主要原因。
In addition, the fading rate of discharge capacity at the upper voltage plateau is also increased by the accelerating trend of electrolyte oxidation.
另外电解质的氧化也呈加速趋势，加快了高电位平台放电容量的衰减速度。
The igniting capacity of electrostatic discharge to space suits is investigated in the condition of pure oxygen and common air.
通过实验研究了在纯氧和普通大气条件下，静电放电对各种航天服的引燃能力。
The results of flood carrying capacity curve and discharge coefficient for camel hump weir and broad crested weir have been obtained by sectional hydraulic model test of Miaozitou sluice.
通过庙子头水电站两种堰型选择水闸断面模型试验研究，获得了宽顶堰与驼峰堰的泄流能力曲线和综合流量系数等试验成果。
The "extension" means an increase of the discharge capacity of an existing outlet.
扩大，是指已有入河排污口排污能力的提高。
Therefore, almost no diminishment of discharge capacity occurs, even after many discharge and charge cycles.
因此，几乎没有放电能力被削弱时，即使经过多次放电和充电周期。
The maximal discharge capacity of alloys is consistent with the results of PCT test.
其最大放电容量与合金PCT实验所得的结果相吻合；
The results shown that the relative small charge current is favorable to improve electrode properties including capacity, circle life and discharge stability.
结果表明：小电流活化有利于提高电池的容量、循环寿命和放电性能的稳定性。
However, when the battery was discharged at high rate, the voltage peak would be in the curve of discharge voltage and the discharge capacity would also be increased.
然而在高倍率放电的条件下，电池的放电电压曲线会出现电压峰，同时电池的放电容量也有所增大。
The effective alloys content decreasing was the reason to explain the discharge capacity of alloys powder reducing after electroless Ni.
有效合金量的减少是合金粉末放电容量降低的一个重要原因。
The results showed that the electroless nickel plating could increase the discharge capacity, 1c discharge properties and cycle stability obviously, and could also improve the activation.
结果表明，镀镍能明显提高低钴贮氢合金的放电容量、1c高倍率放电性能及循环稳定性，对活化性能亦有改善。
In the DISCHARGE mode, the final capacity displayed is also the discharging capacity. However, the battery is not recharged.
在DISCHARGE模式下，最后显示的依然是放电电量。但是电池会在放电结束后不会对电池进行充电。
The performances of battery such as internal resistance, activation time, large current discharge and pulse current discharge capacity, ect.
介绍了在缩短激活时间、降低内阻、提高电池大电流工作能力和脉冲放电能力等方面取得的进展。
The electrochemical tests indicated that the melt-spun alloys showed a good activation property and much better cycling stability, but lower discharge capacity and high-rate dischargeability.
电化学测试表明，快速凝固处理后合金的活化性能不变，循环稳定性得到显著改善，但其放电容量和高倍率放电性能有所降低。
This valve must also have an hourly rated temperature steam BTU discharge capacity not less than the hourly input rating of the water heater.
这种阀门每小时排放高温蒸汽btu的能力必须超过热水器每小时产生热量的能力。
The electrochemical results show that maximum discharge capacity decreases linearly.
电化学性能测试显示，最大放电容量基本呈线性递减；
If the discharge current was increased, the discharge capacity was obviously less than the stabilized value and maximum charge voltage was also changed suddenly.
若放电电流增加，在随后的第一周充放电过程中最高充电电压迅速增加、放电容量显著小于稳定值。
The results show that proper quenching not only increase discharge capacity greatly but also can improve cycle stability and discharge voltage property.
结果表明，合适的快淬速度不仅可以大幅度的提高放电容量，而且明显的改善合金的循环稳定性和放电电压特性。
With the increasing of doping concentration, the discharge specific capacity decrease.
掺杂材料随着掺杂浓度的提高，放电比容量降低；
With the increasing of doping concentration, the discharge specific capacity decrease.
掺杂材料随着掺杂浓度的提高，放电比容量降低；
应用推荐