• But the UF research includes new data and calculation methods.

    但是佛罗里达大学的研究采用了新的数据和计算方法。

    youdao

  • The article describes these models and calculation methods.

    本文概括地介绍了这些计算模型和方法。

    youdao

  • Some calculation methods and some problem considered are unprecedented.

    提出的某些计算方法及所考虑的问题具有创新性;

    youdao

  • The results gained cannot be taken from conventional plane calculation methods.

    取得了一些传统平面计算方法无法获得的结果。

    youdao

  • We shall briefly discuss the calculation methods employed by various researchers.

    我们将扼要讨论各个研究者采用的计算方法。

    youdao

  • Thermal performance of buildings. Heat transfer via the ground. Calculation methods.

    建筑物的热性能。经由地面的热传递。计算方法。

    youdao

  • The calculation methods of its shimmy period in small and large angle are presented.

    介绍了三线摆微角度与大角度摆动周期的计算方法。

    youdao

  • Some calculation methods are given by computer simulation which have practical value.

    通过计算机模拟,得出了有实用价值的计算方法。

    youdao

  • The calculation methods of deformation and contact press force of sealing rings are derived.

    推导了组合型密封环的压缩变形量及接触压力的计算公式。

    youdao

  • This paper simulates the flow field of the slag swirl burner by the numerical calculation methods.

    本文采用数值计算的方法对液排渣粉煤旋风燃烧器内的流场进行了模拟。

    youdao

  • Some practical and approximate calculation methods can be used in designing and installing buildings.

    提出的一些实用近似的计算方法可供房屋设计安装单位参考。

    youdao

  • The calculation methods of stiffening bar deflection analysis on utility boiler are presented in detail.

    详细介绍了大型电站锅炉刚性梁挠度分析的计算方法。

    youdao

  • Expound working principle of extraction check valves and the calculation methods of the cylinder design.

    阐述了抽气止回阀的工作原理及气缸的设计计算方法。

    youdao

  • In this paper, the conception of the part heat balance and calculation methods are brought forward firstly.

    本文首次提出了回转窑内部分段热平衡的概念和计算方法。

    youdao

  • Calculation methods of installation capacitance and group capacitance for shunt capacitor bank are proposed.

    提出了并联电容器组的安装容量和分组容量的计算方法。

    youdao

  • The paper gives a derivation rule of the power exponential function and analyzes some common calculation methods.

    证明了一条幂指函数的求导法则,并总结了幂指函数导数计算的常用方法。

    youdao

  • The stability calculation methods of inversely mounted telescopic hydraulic cylinder in mobile crane are discussed.

    讨论了轮式起重机伸缩臂倒置伸缩液压缸的稳定性的计算方法。

    youdao

  • The paper introduces the calculation methods of extension of prestressed reinforcement combining with project instance.

    本文结合工程实例,介绍预应力钢筋张拉时理论伸长值的计算方法。

    youdao

  • On the basis of above studies, calculation methods for this kind of floor vibration of industrial buildings are discussed.

    在此基础上对关于这类厂房楼面振动问题的现行计算方法进行一些讨论。

    youdao

  • Then it introduced the selection of sacrifice anode materials, application conditions and the protective calculation methods.

    介绍了牺牲阳极材料的选择、使用条件以及牺牲阳极保护的计算方法。

    youdao

  • At last, it is suggested that more than two kinds of the aseismic calculation methods are applied to the complicated buildings.

    最后,提出了运用两种以上的抗震计算方法对较为复杂的建筑物进行计算。

    youdao

  • The result shows that the model and the calculation methods are correct and the calculation result is accorded with the experiment.

    验证表明,本文的计算结果与实验结果有较好的一致性,说明了计算模型和计算方法的正确性。

    youdao

  • Common trap factor calculation methods are suitable for anticlinal trap, but they are not applicable to complicated fault block traps.

    以往所用的取值方法是沿用背斜圈闭的要素统计方法,不能适用于复杂的断块构造圈闭。

    youdao

  • The eleven evaluation factors are included in the four argumentations and calculated by relevant eleven evaluation calculation methods.

    四项因素论证中包含十一个评估因子,并分别由相应的十一个评估计算方法计算。

    youdao

  • Based on the state of Qitaihe mine area, approaches the set rules and calculation methods of water_proof pillar at different conditions.

    根据七台河矿区具体情况,对各种条件下的防水煤岩柱的留设原则及计算方法进行论述。

    youdao

  • Three calculation methods have been used to study waxy oil temperature drop after shutdown for both buried pipeline and overhead pipeline.

    本文用三种计算方法研究了埋地和架空管线中多含蜡原油管道停输后的温降,并与现场实测结果作了初步比较。

    youdao

  • For a typical assembly stress problem, digital simulation is conducted by means of the hybrid method with different numerical calculation methods.

    针对一个典型的装配应力问题,运用不同的数值计算方法,对混合求解法进行了数值模拟。

    youdao

  • For a typical assembly stress problem, digital simulation is conducted by means of the hybrid method with different numerical calculation methods.

    针对一个典型的装配应力问题,运用不同的数值计算方法,对混合求解法进行了数值模拟。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定