The calculated flame length agrees reasonablly well with that observed in experiments.
计算的火焰形状与长度与实验中所观察的相符。
Under a practical pulverized coal flame condition, the comparable energy distribution coefficient was calculated and compared with the value used in the traditional single film (SF-CO) model.
在一实际煤粉火焰条件下，计算了可在单膜(SF)模型中直接应用的可比能量分配系数，并与传统SF模型的取用值进行了比较。
In this paper temperature of adiabatic flame and emission of pollutants are calculated.
本文用该方法计算了有关绝热火焰温度和污染物排放问题。
The variation of combustion velocity, fired gas temperature and flame propagation speed, when the press, excess air ratio and ignition timing changed, was calculated by this quasi-dimensional model.
此模型能根据实测的燃烧压力曲线计算出层流燃烧速度、已燃气火焰温度及火焰传播速度等参数随压力、当量比、发动机转速、点火提前角的变化规律。
The pipe blank dimensions and the necking force were calculated. The structure of necking die for the flame pipe was introduced.
确定了缩口次数并计算了管坯尺寸和缩口力。
Jet flame of the ignition that is usually used in the work is calculated by the difference. And the analysis on the flame stability is given.
用差分法计算了工程上最常用的点火器的射流火焰，并给出火焰稳定性的分析。
The combustion gas flow was analyzed, the velocity and temperature distributions were calculated according to this model, the results fitted well with the actual flame.
在此基础上进行了喷枪内外燃气流场分析，结果表明，燃气温度分布、速度分布与实际焰流有较好的一致性。
Based on those assumptions, the size of particles is simulated, and the effects of flame temperature and the flow rates of oxygen on the sizes of particles and aggregates have been calculated.
在这些假设基础上对颗粒尺寸进行了预测，模拟结果显示该模型对颗粒尺寸的预测与实验数据相差不大。文中还分析了火焰温度，氧化剂流量等对生成颗粒尺寸的影响。
In the test, the measured flame thickness and the range of variation are both larger than that calculated by static flame model. The results obtained are of great advantage for fu...
在本实验条件下所测得的实际火焰厚度较厚，而且变化范围较大，其厚度比按传统的静态火焰模型计算出的结果大得多。
In the test, the measured flame thickness and the range of variation are both larger than that calculated by static flame model. The results obtained are of great advantage for fu...
在本实验条件下所测得的实际火焰厚度较厚，而且变化范围较大，其厚度比按传统的静态火焰模型计算出的结果大得多。
应用推荐