It is configurable but by default it shows the status of test execution by test plan within your project.
它是可配置的,但默认显示项目中基于测试计划的测试执行的状态。
The T129 P1 prototype was flown by test pilots from AgustaWestland and Turkish Aerospace Industries (TAI).
该T 129小样机的试飞员来自韦斯特兰公司和土耳其航空航天工业公司(TAI)。
The logic calls a downstream JAX-WS web service in four different invocation styles, as indicated by test cases 2 through 5.
这个逻辑以4种不同的调用风格调用一个下游JAX - WSweb服务,如测试案例2到5所示。
Configuration management controls the builds as well as the environments that are tracked by test management for test execution.
配置管理为测试执行控制着由测试管理跟踪的工作版本和环境。
Test-taking strategies, the consciously selected processes and procedures by test-takers, have become necessary evidence for test validation.
考试策略是受试在考试过程中有意识地选择的解题步骤和程序,是效度验证的必要证据。
The models are validated by test results.
通过试验,验证了系统模型。
The optimum conditions were determined by test.
通过实验确定了最佳工艺条件。
Analyze the suitability of model verified by test results.
通过试验成果验证,分析模型的适用性。
These measures are verified by test on IBM-PC microcomputer.
并通过在IBM - PC微机上的测试验证了这些方法。
The traits of in situ PB and the possible reasons were studied by test.
通过试验来研究原位共混型聚丁二烯橡胶的特点,同时分析其可能的原因。
Precision forming of automobile half-axle tubes is investigated by test.
对汽车半轴套管的精密成形进行了试验研究。
The physico-mechanical parameters of every stratum have been ascertained by test.
应用试验结果确定各类土层的物理力学参数;
At last, effect of the "suspending" measurement is verified by test in laboratory.
最后通过实验验证了“浮空”测量法的效果。
Validity and reliability of the system are demonstrated by test-run of a prototype.
原型机的试运行证实该系统的实用性和可靠性。
The optimal parameters of type DJ4 locomotive axle heat treatment are explored by test.
通过系统的实验,探索出了DJ4型机车车轴的最佳热处理工艺参数。
A model for occupant restraint system in frontal crash is developed and validated by test.
建立了正面碰撞乘员约束系统的模型并经试验验证。
The model has been implemented and the algorithm's efficiency is verified by test results.
该模型已实现,算法的有效性在实践中得到了检验。
The view of heat and mass auto-feedback equilibrium has been found, explained and verified by test.
同时,提出和分析了制冷系统中热、质自动反馈平衡的观点,并以试验做了验证。
The filtration characteristics of the four suspensions were discussed by test and theoretical analysis.
通过试验分析与理论推导,探讨了典型物料在恒压过滤过程中的过滤特性。
This article describes a rapid method for edible oil acid value analysis by test strip colorimetry mean.
论述了一种利用试纸比色法快速检测食用油酸价的方法。
Characteristics of ct (Current Transformer) in extreme saturation is illustrated by test and theoretical analysis.
通过实际试验和理论分析,阐明了电流互感器严重饱和时的特性。
In this paper, engine block dynamic characteristic is analyzed with finite element model and verified by test result.
本文利用所建立的机体动态分析有限元模型,分析计算了机体的动态特性,并得到了试验的验证。
The feasibility of a glued double-plated grip method and dense corrugated steel bar grip manner is demonstrated by test.
采用双钢板粘贴式传力方式以及密集植筋传力方式等两种试件端部处理方法,以论证两者在轴拉试验中的可行性。
According to empirical formula, relaxation ratio for 1000 hours can be calculated by test data of relaxation ratio for 80 hours.
根据经验公式可在80小时松弛率试验数据的基础上推算出1000小时的松弛率。
The best formulation was selected by test analysis of film forming materials, fire-retardant, additives and film forming process.
通过对成膜物质、阻燃剂、助剂及成膜过程的试验分析,筛选出最佳工艺配方。
As indicated by test the soil property surrounding the pile is the main factor affecting the horizontal bearing capacity of pile.
试验结果表明:桩周土的性质是影响单桩水平承载力和性状的主要因素。
Useful conversion coefficient is obtained by test, and therefore axial distribution of cobalt target specific activity is calculated.
通过试验,获得了实用转换系数,据此,可以求出每节钴靶的比活度。
Its CCT curve was determined by test. The influence of quenching and tempering temperature on the mechanical properties was also studied.
试验测定了该钢的CCT曲线,探讨了淬火和回火加热温度对该钢力学性能的影响。
The optimal technological parameters of the formulation were obtained by test, and the factors influencing polishing effects were analysed.
通过试验,得出了该配方的最佳工艺参数,并对影响抛光效果的因素进行了分析。
The optimal technological parameters of the formulation were obtained by test, and the factors influencing polishing effects were analysed.
通过试验,得出了该配方的最佳工艺参数,并对影响抛光效果的因素进行了分析。
应用推荐