The microstructure of the brazed joint was analyzed by means of a scanning electron microscope and an energy spectrum analyzer.
用扫描电镜和能谱分析仪对钎焊接头的显微组织进行了分析。
This paper discusses the effect of brazing time, brazing temperature, brazing gap and diffusion treatment on the remelt temperature of the brazed joint.
文章讨论了钎焊时间、钎焊温度、钎焊间隙及焊后扩散处理对钎焊接头再熔化温度的影响。
Choosing a appropriate thickness filler metal for brazing metal-ceramic can decrease the residual stresses in the brazed joints and improve the joint strength.
同时，选择合适厚度的钎料会降低钎焊接头的残余应力，改善接头连接强度。
So, in order to gain good brazed joint in contact reactive brazing, the orientation of the eutectic liquid must be taken into account during selecting an interlayer.
而在接触反应钎焊的中间层材料选择过程中，考虑接触反应液相产生的方向性是发挥接触反应钎焊优越性的保障。
The forming reason and solving method of stress - corrosion cracking for brazed joint of Band pipe is studied in this paper and compared with copper- copper pipe joint at the same conditions.
本文着重研究了邦迪管钎焊接头应力断裂的形成条件以及解决方法，并比较了铜管-铜管钎焊接头在相同条件下应力断裂情况。
Results show that the brazed joint with good quality can be got by using the reasonable brazing filler metal and proper brazing flux (HL401 + QJ201) and the optimum brazing technological parameters.
研究表明，采用合理的钎料和钎剂组合(HL401 +QJ 201)以及正确的钎焊工艺参数可获得质量良好的钎焊接头。
The strength of soldered joint is less than a joint which is brazed, riveted or welded.
锡焊点的连接力要小于钎焊、铆接或焊接的连接点。
The strength of soldered joint is less than a joint which is brazed, riveted or welded.
锡焊点的连接力要小于钎焊、铆接或焊接的连接点。
应用推荐