Recommended Bolt torque requirement are shown below.
建议的所需螺栓力矩如下表所示。
The function principle, structure and material performance of fixed torque bolt are studied in the way of Reverse Engineer in this thesis.
本论文对定扭矩螺栓的功能原理、结构以及材料性能等进行了反求分析。
Sensor bolt to be used to ensure a certain degree of tightening torque, prolonged use will not become loose.
传感器要采用螺栓固定，保证一定的紧固力矩，长时间使用不会松动。
This article studies the influence of the bolt tightening torque on the fretting damage of LY12CZ aluminium alloy double shear lap bolted joint by experimental and conumerical analysis.
从试验和数值分析两个方面研究了螺栓预紧力矩对LY12CZ铝合金双盖板对接螺纹联接件微动损伤的影响。
The torque coefficient and antislide coefficient is important evaluation parameter of the performance class of high strength bolt.
扭矩系数是高强度螺栓扭矩法施工的关键参数。
The value of tightening torque is relative not only to the nominal diameter and quality class of the bolt, but also to the security of the threaded fastener.
指出螺栓联接的扭紧力矩值不仅与螺栓的公称直径及性能等级有关，还与能否保证联接可靠工作有关。
The paper analyzed the bolt pre-stress affected to the mine roadway support effect and the relevant relationship between the bolt pre-tightening torque and the pre-tension.
分析了锚杆预应力对巷道支护效果的影响，锚杆预紧扭矩与预紧力对应关系。
The following table gives you some recommended bolt fastening torque.
参考以下表格中螺栓的扭矩力。
The compressed air powered wrench is capable of providing revert-torque to retrievable bolt end and sustain drag force.
该锚杆回收扳手由压气驱动，在给可回收锚杆的尾部提供反扭矩的同时，还可以承受拉力。
Fasteners, the bolt tightening torque of 65 n. M, shall not be destroyed.
采用的扣件，在螺栓拧紧扭力矩达65n.m时，不得发生破坏。
Fasteners, the bolt tightening torque of 65 n. M, shall not be destroyed.
采用的扣件，在螺栓拧紧扭力矩达65n.m时，不得发生破坏。
应用推荐