Install upper barrel, fixed by break flange and bolt nut.
安装上体，用断开法兰和螺栓螺母固定。
Install new lower barrel, place new snap ring and new flange on the new lower barrel, fixed by bolt nut.
安装新埋管，把新卡环和新法兰套进新埋管里，用螺栓螺母与法兰固定。
A bigger bolt nut must match the larger, which means that larger diameter bolts need to create conditions on the tight nut.
而更大的螺栓就要匹配更大的螺母，这就意味着需要直径更大的螺栓为上紧螺母创造条件。
Contact problems between concrete base surface and column base, bolt nut and neighborhood plate, bolt shank and bolt hole are simulated really.
有限元分析中模拟了底板与基础面之间、锚栓垫片与底板之间、以及锚栓与混凝土之间的接触作用。
Have you ever used a hammer and screwdriver to loosen a nut from a bolt?
您是否曾经用过锤子和螺丝刀从螺栓上拧下螺母？
Otherwise, you might feel as if you are using a socket wrench as a hammer hitting the handle of a screw driver to loosen a nut and bolt.
否则，您可能感觉到像用锤子一样使用一个套筒扳手来敲击螺丝刀手柄而拧开螺栓的螺母。
Remove the upper suspension arm nut and bolt at the axle bracket.
从车轴支架上拆去上端悬吊臂螺帽和螺栓。
And the more big bolt will match more nut, which means more need for the bolt diameter to tighten the nut create conditions.
而更大的螺栓就要匹配更大的螺母，这就意味著需要直径更大的螺栓为上紧螺母创造条件。
Wrenches (spanners) must not be used if its jaws are sprung, worn or cracked. They may slip off a bolt or nut when you least expect it.
如果扳手(扳钳)的钳夹出现变形、磨损或裂纹，则不宜再使用。它们可能会在您始料未及之时导致螺栓或螺帽滑脱。
These tokens can be "bolt," "nut," "screw," etc.
这些令牌可以是“bolt”、“nut”、“screw”等。
It is simply a piece of plastic with a large nut and bolt at each end.
这只不过是一块塑料大螺母和螺栓在每个结束。
Using pliers or a pipe wrench to tighten a bolt or nut. This may scar the bolt head or nut creating a sharp edge.
使用钳子或管扳手拧紧螺栓或螺帽。这样可能会刮伤螺栓头或螺帽，从而形成尖锐的边缘。
Does the bolt fit the nut we prefer welding to riveting.
螺栓与螺母不配。我们认为焊接比铆接好。
Therefore, we should regularly inspect the bolt and nut fastening and implemented in order to reduce unnecessary costs.
因此，应定期对螺栓和螺母进行检查并实施紧固，以减少不必要的费用。
The design calculation of the large O ring rubber self energized seal (without bolt and nut )used for the vacuum equipment and its application results are introduced.
介绍真空设备法兰采用大直径O形环橡胶自紧式密封（不用螺栓和螺母）的设计计算及其应用效果。
Make sure check the bolt and nut before testing run. and if they become less crowded, fastening again.
试车前务必检查所有螺栓、螺母是否有松动，若有松动的螺栓、螺母必须重新紧固。
Screws; nut; rivets; expansion screws; bolt; sales.
螺钉；螺母；铆钉；膨胀螺丝；螺栓；销。
The force and deformation of bolt connection with elastic cell fixed under a nut are analyzed.
现有文献称“在螺母下面安装弹性元件，起到了柔性螺栓的效果”。
I used a long bolt as a shaft, and the end of the spool is held on with a nut.
我用很长的螺栓作为骨干，并在年底举行的阀芯是一个螺母。
Through the failure analysis of connecting bolt of down rod, it points out that it is not correct to put the thinner nut outer side if the double nut anti-loose method is adopted.
通过对游梁式抽油机对接式连杆下接头连接螺栓的失效分析，指出了采用双螺母防松时，将薄型螺母放置在外侧是不恰当的。
But after technicians managed to attach a large separation system bolt on the lower right side of the shuttle's belly, an internal nut slipped out of position and fell off.
但在技术人员将一个大的分离系统的螺栓连接到机腹右下侧位置时，一个内螺母滑脱掉落了。
Germany skilled, advanced manufacturing processes and technologies, focus on the large nut fastening bolt, disassembly of hydraulic technology and practical application of driving force.
以德国精湛、先进的制造工艺和技术为依托，专注于大型螺栓螺母紧固、拆装科技及液压实用动力的运用。
Check the bolt and nut and filling press cover, it it become flexible during the transport or store, screw down it.
内腔进行去湿处理并检查各连接部位的螺栓、螺母和填料压盖等是否在运输和存放过程中产生松动，如发现应均匀拧紧。
Remove the lower suspension arm nut and bolt from the axle bracket.
从车轴支架上拆去上端悬吊臂螺帽和螺栓。
My company mainly manages the bolt, the nut, the spring nut, the bolt, the gasket, the tooth stick, the expansion of metal screw, the heterogeneous pressing part, non-tender, hardware tool and so on.
本公司主要经营螺钉，螺母，弹簧螺母，螺栓，垫圈，牙棒，金属膨胀螺丝，异型冲压件，非标件，五金工具等。
Bolt: Mechanical fastener, usually used with a nut, for connecting two or more parts.
螺栓：通常与螺母一起用于连接两个或更多零件的机械紧固件。
When installing the foot bolt, the outside of the foot bolt top can not be bigger than the thickness of the nut.
安装地脚螺栓时其外露螺栓顶面的高度不的大于螺母的厚度。
The design of a new pre-tensional structure (FROMOpreload nut) applied in the large size of screw thread was introduced, the pre-load bolt is only beared with the pure tensile stress.
介绍了一种应用于大规格螺纹预紧的新型结构FROMO预紧螺母的结构设计，该结构螺栓只承受纯拉应力。
The minimum across flats dimension of the hex bolt or hex nut being used to test the loose washer must not be greater than 1.5 times the basic thread size.
用于试验非组合用垫圈的六角螺栓或六角螺母的最小对边宽度不能大于垫圈内径所对应的螺纹公径直径的1.5倍。
The minimum across flats dimension of the hex bolt or hex nut being used to test the loose washer must not be greater than 1.5 times the basic thread size.
用于试验非组合用垫圈的六角螺栓或六角螺母的最小对边宽度不能大于垫圈内径所对应的螺纹公径直径的1.5倍。
应用推荐