Boiler gross efficiency is obtained after corrections of environment temperature, feedwater temperature and coal quality to boiler test efficiency.
对锅炉测试效率进行了环境温度、给水温度及煤种修正，得到锅炉毛效率。
After this test we can calculate: It takes 40 minutes to braise a chook by a normal boiler, but it only needs 15 minutes by the flameout reboiler.
通过这个实验我们来算一算：采用普通锅炖鸡需要花费40分钟，而熄火再煮锅只需15分钟。
Automatic controller test for auxiliary boiler.
辅锅炉自动控制装置试验。
Water line demarcation test should be carried out when starting up and adjusting the subcritical drum boiler, to certify the zero benchmark of the local water gauge.
亚临界压力的汽包锅炉在启动调试时应进行水位标定试验，以确定就地水位表的基准零位。
Test results show that the reconstruction counteracts the impact of poor coal quality to some extent and is conducive to the economic operation of the boiler.
试验表明，上述改造措施能在一定程度上降低煤质差带来的负面影响，有利于锅炉的经济运行。
Present the basic similarity simulation principle followed in cold simulation of power plant boiler dynamic field, way of calculating test control parameters and associated measuring techniques.
介绍了电站锅炉空气动力场的冷态模化的基本相似模化原理、试验控制参数的计算方法及相关的测量技术。
In various regions, different test gases are usually necessary to insure the quality, safety device and thermal characteristics of wall hung gas boiler.
为保证壁挂锅炉的质量，检测其安全装置和热工性能是否达到要求，需要根据不同地区的气源进行配气。
In this paper, fuzzy recognition technology is applied by means of fuzzy set theory to present an on-line fuzzy recognition method for boiler energy-loss pattern, and simulation test was made.
本文应用模糊识别技术，借助模糊集理论提出了一种锅炉能损模式的在线模糊识别方法，并进行了仿真测试。
Based on test and analysis of the parameter of the thermal efficiency of steam injecting boiler, the sensitive factors leading to low thermal efficiency are found.
通过对河南油田分公司第二采油厂稠油开采用注汽锅炉系统热效率参数的测试和分析，找出了造成热效率低的敏感因素。
The differences between chinese and Japanese boiler standards from the aspects of design, strength calculation and hydrostatic test are compared.
从设计、强度计算及水压试验等方面比较了中日锅炉标准的差异。
Based on reliability theory, the specification of accelerate life test for friction welded joints in boiler snake pipe was worked out.
以可靠性理论为基础，制定了电站锅炉蛇形管焊接接头的加速寿命试验规范。
Safety valve adjusting and accumulating test for auxiliary boiler.
辅锅炉安全阀检验及蓄压试验。
Safety valve adjusting and also accumulating test for auxiliary skin boiler.
辅锅炉安全阀检验及蓄压测验。
This paper introduces the operation and the performance test results of the opposed firing supercritical boiler of HBC, and gives the analyses and evaluations to the result.
介绍了哈锅超临界对冲燃烧锅炉实际运行情况和性能考核试验结果，并对结果进行分析和评价。
The synthetic process of sludge fuel, and results of thermodynamic test and environmental pollution monitoring of its combustion in an ordinary industrial boiler are discussed.
介绍了污泥燃料的合成及其在普通工业锅炉中燃用的热工测试、环保测试、跟踪试验的情况。
The principle and test method of using adsorptive stripping voltammetry to determine the mass concentration of trace iron in boiler water of thermal power generating units are described in this paper.
介绍了用吸附溶出伏安法测定火力发电机组锅炉用水中微量铁质量浓度的原理和试验方法，并对多组试验数据进行了分析和讨论，从而得出测试参数的最佳选取值。
In this paper an analysis is given of the structural design, test results and performance characteristics of the SZL4-13 boiler.
本文分析了SZL4 - 13型锅炉的结构设计、测试结果和性能特点。
The paper describes the test results of improvement effects on a licensed 300mw set's boiler and its reheater for the purpose of diminishing reheater's mass flow and temperature deviations.
该文介绍引进型300MW机组锅炉、再热器系统经改进，减少再热蒸汽流量偏差和温度偏差的实炉试验结果。
Through test and adjustment, the operation of boiler is stable, enhancing the economic indices.
经试验调整，锅炉运行稳定，经济指标提高。
The test shows that size distribution of feeding coal, volatile content and its release as well as the total air rate and primary air ratio will influence the post combustion in CFB boiler.
测试结果表明，影响后燃现象的主要因素是给煤的粒度分布、煤挥发分含量及挥发分析出规律，同时与炉膛内总风量、一二次风量的配比有关。
The speciality ranges from machine building, boiler, welding, electronics, automation, biochemistry, to physics and chemistry test .
专业分布为机械制造、锅炉制造、焊接、电子、自动化仪表、生物化学、无损检测及理化试验等。
The essay introduces the theory of reuse of dust-removing wastewater of coal based boiler and its applied technique which has been test-running in Changde Cigarettes Factory for one year.
本文介绍燃煤锅炉除尘废水的循环利用原理、应用技术及其在常德卷烟厂进行生产性试验一年来的结果。
In situ test data show the deposition on the inter-surface of boiler equipment can be removed and can get a clean inter-surface of boiler by online cleaning way.
通过现场试验数据分析，在线清洗可以去除锅炉设备内表面的沉积物，达到清洁锅炉的目的。
We take a combustion characteristic test of the coal fired on the CFB boiler in India to fit the project demand.
根据印度项目需要，对印度CF B锅炉燃用煤种进行燃烧特性的试验研究。
The test results show that the boiler has some good qualities, such as intensified diathermancy, cleaning combustion, high efficiency, energy saving, low pollution and long lifespan etc.
实测及运行经验表明，此系列燃气锅炉具有强化传热、洁净燃烧、高效节能、低排放、经久耐用等优点。
This study made a localized full-condition simulation test and safety estimation for site repairing welding of a damaged boiler vessel tube.
本文对某电厂锅炉汽包损坏短管的现场修复焊接工艺以局部试样全条件模拟方法进行了焊接试验分析及其安全性论证。
The response curve gained by the test in a boiler pipe is accordant with the real situation of vapor-water ratio of the steam transportation.
装置在锅炉输汽管道中的实测响应曲线反映了输汽过程中汽液比的真实变化。
Through the cold-state model test of a high-capacity boiler obtained is the flow field distribution within the boiler and at the furnace outlet horizontal gas pass.
通过大型电站锅炉的冷态模拟试验获得了炉内和炉膛出口水平烟道流场的分布规律。
In cold test of boiler, resistance performance experiments of empty bed and different thickness were conducted, and the boiler's critical fluidized flow was determined.
在锅炉冷态试验中，进行了锅炉空床和不同料层厚度下的床层阻力特性试验，确定了锅炉的临界流化风量。
Metal material bending test is an important item when raw materials come to factory in boiler and pressure vessel manufacturing trade.
金属材料的弯曲试验是锅炉压力容器制造行业进行原材料入厂检验的一项主要检查项目。
应用推荐