Load distribution of axial fan along to the blade and blade height is put forward according to dynamic design method of quintic equation.
提出了轴流通风机沿叶片叶高的载荷分布，按五次方流型设计的方法。
The most affected was secondary flow losses for the energy loss distribution along the blade height, other losses along the distribution was average.
对于能量损失沿叶高分布影响最大的是二次流损失，其他损失沿叶高分布相对比较平均。
Although the electrodes are installed along the whole blade height, the plasma merely reduces the losses in the region above 10% blade height, and the loss reduction is almost the same in this zone.
虽然电极沿整个叶高方向布置，但等离子体仅对约10%叶高以上的损失影响较为明显，同一电压下该范围内各叶高处的损失减小量也基本相同。
The numerical simulation technique is used to investigating the isentropic Mach number distribution on the different swept height blade surfaces of a turbine last stage blades.
采用数值模拟技术详细地研究了不同掠高的某蒸汽轮机末级前掠叶片表面等熵马赫数的分布。
The height of head harmonizable blade or any arbitrary adjustable backer, constitute the versatility of the machine.
刀头高度可调和刀片的任意增减和靠山的任意可调，构成了该机的多功能性。
Tree Height doesn't has significant relationship with blade length, for they are controlled by different genetic factors.
油松的树高与叶片长度并无显著的相关关系，因为油松树高、针叶长分别受到不同的遗传因素的控制。
The method of forward leaning stator blade, which can effectively control the radial second flow and the top separate flow, is applied to the design of the small diameter-height ratio blade.
小径高比的叶片采用静叶片的正倾斜的方法能够有效地控制流道内部的径向二次流和叶栅顶部的分离流动；
The value calculation shows that bending blade may make considerable influence of flow separation in last stage of large steam turbine, in that the relative height of flow separation is reduced.
数值计算表明，在大功率汽轮机末级叶片中采用弯扭叶片后对脱流特性有较大影响，相对脱流高度减少。
Length of shoulder blade and upper arm are equal. Height from elbow to Withers approximately equals height from ground to elbow.
肩胛骨与上臂长度相等，从肘部到马肩隆与从地面到肘部的长度相等。
In the invention, the heavy hammer goes up to the preset height and then fall freely to carry out the striking and tensioning on the circular saw blade.
本发明通过将重锤上升至预定高度，然后让其自由下落来对圆锯片进行击打适张。
By using the same alternate blade cutter, bi-arc spiral bevel gear pair with equal-height tooth can be produced on the Gleason machine.
用同一双面刀盘在格里生机床上成功地切出了等高齿双圆弧弧齿锥齿轮副。
By using the same alternate blade cutter, bi-arc spiral bevel gear pair with equal-height tooth can be produced on the Gleason machine.
用同一双面刀盘在格里生机床上成功地切出了等高齿双圆弧弧齿锥齿轮副。
应用推荐