The students can use BJT and FET appropriately when they understand their characteristic.
认识三端元件的特性之后， 未来能正确的使用这个元件。
To BJT/HBT device, the arithmetic, at its low frequency range and high frequency range respectively, are put forward.
对于BJT／HBT器件，分别提出了高频段和低频段的参数提取算法。
Power amplifier Modules were designed using Push-Pull BJT power amplifiers that were combined using 3db Quadrature couplers.
功率放大器模组设计，使用负载牵引特性原理功率放大器被合并使用三分贝正交耦合器。
A new design of BJT analog switch using high speed unit such as emitter follower, current mirror and unsaturated current switch is presented.
本文采用射极跟随器、电流镜、非饱和电流开关等高速单元电路设计了一种新颖的BJT模拟开关。
After introduction of the tranlinear loop principal, the BJT current controlled conveyor has been designed by using mixed tranlinear loop voltage follower.
在引入了跨导线性原理后，利用混合跨导线性回路完成了对电压跟随器的设计，进而得到了双极管型电流控制传送器。
The simulation results show that the emitter injection is easier to burnout the BJT than the collector injection, and the base injection is relatively difficult.
发射极注入最容易导致烧毁，集电极注入次之，基极注入相对不易导致烧毁；
Figure 2-1 (a) shows the physical representation of the BJT in its common-emitter orientation, and also shows typical voltage polarities and magnitudes for the case of a silicon device.
图2 - 1 (a)给出了共发射极取向的晶体管的物理特性，同时也给出了硅器件的电压极性和大小。
SADI algorithm was executed successfully in the BJT area with near-, middle-, and far-stack dataset, and amplitude dataset was finally converted to attributes dataset describing lithology and fluid.
利用平湖八角亭工区的近中远角道集数据体，成功应用了同时反演算法（SADI），最终将地震振幅数据体转化为描述岩石岩性和流体的属性数据体。
SADI algorithm was executed successfully in the BJT area with near-, middle-, and far-stack dataset, and amplitude dataset was finally converted to attributes dataset describing lithology and fluid.
利用平湖八角亭工区的近中远角道集数据体，成功应用了同时反演算法（SADI），最终将地震振幅数据体转化为描述岩石岩性和流体的属性数据体。
应用推荐