Gallons of sea water had rushed into the cabin and were now swilling about in the bilges.
大量海水冲入了船舱，正在船底中来回晃荡。
Bilges, wet voids and drainage pipes.
舱底、湿空舱和排水管。
Shippedmuch seawater over deck, and pay attention to sounding of tanks and bilges.
甲板上大量海水，注意检测水舱及污水沟。
Mainly used in steam pipe above, the compensation steam pipe for heat bilges cold shrink from the displacement.
主要用在蒸汽管道上面，补偿蒸汽管道因热胀冷缩产生的位移。
So research aspic bilges below strength effect the character getting power of picket radical is having very important sense.
所以探究冻胀力功能下的桩基的受力特性有着很重要的意义。
In construction process, because the PC sheet strong rigidity, heat bilges cold shrink coefficient is big, so the contrast brief equipment.
在施工过程中，因为PC板材刚度强、热胀冷缩的系数大，因此对比简略设备。
But checked Chad engineering core column is fixed with aluminum alloy column, so will lose freedom scale effect, when heat bilges cold shrink large internal stress.
但是被检查的工程芯柱都与铝合金立柱固定，这样就会失去自由伸缩作用，当热胀冷缩时产生较大的内应力。
In addition, there are dizziness, head bilges, headache, chest tightness, fatigue, nausea, loss of appetite and other systemic symptom and eye, nose, pharynx and irritation.
此外，尚有头昏、头胀，头痛、胸闷、乏力、恶心、食欲不振等全身症状和眼、鼻、咽部的刺激症状。
The size of the hole away from the plate edge should be not less than 40 mm, all the hole diameter should be greater than the bolt diameter, heat bilges cold shrink to fit the board.
孔离板材边缘的尺寸应不少于40mm，所有钻孔直径应大于螺栓直径，以适应板的热胀冷缩。
Heat bilges cold everybody understands the reason that shrink, the pore of water Wen Huiling of overheat piece very big, come down for a long time to be able to cause pore instead bulky.
热胀冷缩的道理谁都懂得，过热的水温会令毛孔张得很大，长久下来反而会造成毛孔粗大。
Because the waterproof apron will be affected by temperature gap and accelerating aging and cause water table appeared in water and heat bilges cold shrink, serious will make parts damage.
因为防水胶圈受温度影响会热胀冷缩出现空隙并加速老化从而引起进水和表内出现水凝结物，严重的将使机件损坏。
Because the waterproof apron will be affected by temperature gap and accelerating aging and cause water table appeared in water and heat bilges cold shrink, serious will make parts damage.
因为防水胶圈受温度影响会热胀冷缩出现空隙并加速老化从而引起进水和表内出现水凝结物，严重的将使机件损坏。
应用推荐