The Fairchild Model 15 relay, available in several bias range configurations to meet a variety of output requirements, offers excellent sensitivity and high flow capacity in a small volume.
飞兆半导体产品的15中继，在一些偏差范围内配置，能够满足生产要求的品种，提供了极好的灵敏度和在小体积高流量的能力。
Then, the diagnosis algorithms for solving stick-slip, deadzone, jam, bias faults are discussed in detail based on analyzing the command, feedback and flow signals from the model.
通过对模型中指令、反馈和流量信号的分析，得出了执行器在粘滞-滑动、死区、卡死、恒偏差故障下的诊断算法；
The electrolyte is heated and a bias is introduced across said electrolyte and the semiconductor material causing current to flow between the electrolyte and the semiconductor material.
将电解质加热且在该电解质与半导体材料上引入偏压而引起电流在电解质与半导体材料之间流动。
This pneumatic relay provides high output flow at an output pressure that represents the input signal pressure plus a preset bias.
这种气动继电器输出提供了压力，表示输入信号压力加上预设的偏见高输出流量。
The main process parameters include hydrogen content in the gas sources, hydrogen plasma catalyst pretreatment, substrate bias, deposition temperature and plasma flow guiding.
主要之制程参数包括气源中之氢气含量、电浆前处理、材偏压、积温度以及电浆导流板之施加。
Wall filtering is a very important technique in color flow imaging systems. Unfortunately, wall filter usually induces a bias to the estimation of blood parameters.
壁滤波是彩色血流成像系统中一项非常重要的技术，但是任何壁滤波器都会对血流参数的估计引入偏差。
RED can absorb the bursty flow by keeping lower average queue size and weaken the bias against bursty flow.
RED算法能够通过保持较低的平均队长吸收突发流，削减了对突发流的偏见。
The results show that the etching rate depends strongly on plasma composition and the RF bias voltage, but rather weakly on the gas flow rate.
结果表明刻蚀气体的组分和射频偏压对刻蚀速率有较大影响，而气体流量影响不大。
The effects of the flow rate of oxygen and pulse bias voltage on the structure, deposition rate and the surface morphology of thin film were studied.
研究了氧流量和脉冲偏压对薄膜相结构、沉积速率、表面形貌、薄膜硬度的影响。
The influence of treatment time, gas flow rate and bias voltage on the plasticizer leaching was investigated.
研究了处理时间、气体流量和电极偏压对增塑剂渗出量的影响。
The influence of treatment time, gas flow rate and bias voltage on the plasticizer leaching was investigated.
研究了处理时间、气体流量和电极偏压对增塑剂渗出量的影响。
应用推荐