Under the constant bending times, the biggest bending angle can be obtained with an optimal accumulative line energy value.
在扫描次数一定的情况下，存在一个最优的累积线能量使弯曲角达到最大；
One of end of specimens, another end surface as inside surface as the lateral and bend it repeatedly until it breaks. record record slice bending times.
试片之一端表面作为内侧，另一端表面作为外侧而予以往复弯折，至试片损伤时记录弯折次数。
As Jimmy was bending over caring for the injured Fred, the man shot Jimmy four times, twice in the back.
就在吉米正弯腰照顾受伤的弗雷德时，卡车司机朝吉米开了四枪，两枪击中他的背部。
The end product is six times lighter than steel, five to six times lower in density, two times harder and has13 times higher bending rigidity.
最后，该产品比钢轻6倍，密度低5到6倍，更坚固2倍，抗弯刚度高13倍。
These are testy waters I must say because so many times I've found relationships to be negative influences as far as bending yourself in ways you shouldn't.
这分寸确实很难把握，因为我常常觉得恋爱对我有负面的影响，因为要强迫自己屈从于本不该属于你的关系。
B. in a later chapter, hollow plate the smallest bending radius is 175 times of its thickness, can only cold bending, hot bending.
在后面章节中，中空板的最小弯曲半径是其厚度的175倍，只可以冷弯，不能热弯。
The bending radius of cable: non armoured cable, should not be less than 6 times.
电缆的允许弯曲半径：无铠装电缆，不小于电缆直径的6倍；
The minimal bending radius is 6 times the thickness of electric heating cable.
安装电热带最小弯曲半径为其厚度6倍。
The test results show that the resistance of the sensors is changed little after the bending test and the flexible structure is not broken after 3300 times bending.
试验结果表明：所制作的柔性传感器阵列经多次弯扭循环后，电阻值基本没有变化，柔性传感器在经过弯扭3300次后，传感器本身的柔性材料并没有断。
Analyzed the trimming methods when the thick of plate less than two times bending height, introduced the die structure, design points and its working process.
分析了板材弯曲高度小于两倍料厚时，采用切边方法，并介绍了切边模结构、模具的设计要点及其工作过程。
The structure and stamping technology of glass bracket were elaborated. At the same time, the blanking die, bending die for one time and bending die for two times were also introduced.
叙述了玻璃托的零件结构及成形工艺，介绍了落料压凸模、一次弯曲模和二次弯曲模的模具结构及设计要点。
When detection bending strength of perforation board, it is necessary to based times of theory width of modules on the width of modules.
提出检测穿孔板静曲强度时，要以试件构成单元理论宽度的倍数作为试件宽度的计算依据。
The time needed for fixing the shape of bending stock by RF drying is less than from 120 to 180 times that by the traditional kiln drying, even more, a better quality can be obtained.
与木材蒸煮法软化相比，高频加热软化能提高工效约12倍，弯曲毛料采用高频干燥定型工艺比传统的窑干法干燥定型工艺提高工效120～180倍，并可获得较好的干燥定型质量。
Pressure and impact resisting, with bending strength 4-5 times as high as common glass, and impact-resistance 5 times as high as common glass, capable of withstanding abrupt temperature changes.
耐压抗击，抗弯强度是普通玻璃的4-5倍，抗击强度是普通玻璃的5倍，能承受温度的剧变。
After glass fiber reinforced nylon 6, the performance index such as tensile strength and bending strength has improved several times.
用玻璃纤维增强尼龙6，使其拉伸强度和弯曲强度等性能指标成倍提高。
She lent to me her strength of character. It was her faith in me that kept me going a lot of times when I was tired from bending over a sort of rub board of my own.
她的性格给了我力量，当我弯腰洗我自己衣服感到累的时候，就是凭借她对我的信任我才能够一直干下去的。
She lent to me her strength of character. It was her faith in me that kept me going a lot of times when I was tired from bending over a sort of rub board of my own.
她的性格给了我力量，当我弯腰洗我自己衣服感到累的时候，就是凭借她对我的信任我才能够一直干下去的。
应用推荐