• Charged particles called ions travel along the nanowire, causing it to stretch out in length and also bend and wiggle.

    被称为离子带电粒子沿着纳米线移动导致伸长弯曲摆动

    youdao

  • Players use the cursor to grab, bend, pull, and wiggle the chain of amino acids anywhere along its length, folding the protein into its optimum shape.

    玩家们光标沿着方向在任意位置上抓取弯曲拉伸摆动氨基酸链,把蛋白质折叠合适的形状。

    youdao

  • Between violet and red are indigo, blue, green, yellow, and orange. Rays of these colors differ both in length and amount of bend.

    紫色红色之间绿这些颜色光线波长不同发生折射程度也不同。

    youdao

  • Shoulder and sleeve length -bend arm slightly at elbow, measure from center back of neck, over shoulder and down (with cuff) outside of arm to your wrist.

    (包括克夫)-手臂稍微弯曲点,通过肩点,沿着手臂外侧至腕部

    youdao

  • In this paper, for the first time, floor stiffness is denoted as shear stiffness, which reflects the influence of floor length to width ratio more effective than floor bend-shear stiffness.

    本文首次楼板刚度剪切刚度表示楼板的弯剪刚度能体现楼板长宽比对楼板刚性影响

    youdao

  • A tight curl, twist, or bend in a length of thin material, as one caused by the tensing of a looped section of wire.

    扭结:段长度材料产生绷紧卷曲曲折弯曲例如因拉紧线的有部分

    youdao

  • You look at pairs of chopsticks, first of all is that both sides equal, the length of agreement, if any one bend, or short, and certainly do not live clip vegetables, feel awkward in my hand.

    筷子首先双方平等长短一致如果一支弯了,或者是短了,肯定是不住,拿手中也觉得别扭

    youdao

  • A tight curl, twist, or bend in a length of thin material, as one caused by the tensing of a looped section of wire.

    扭结长度材料产生绷紧卷曲曲折弯曲例如因。

    youdao

  • In the process of bending, the excessive length of the straight flange of the bend mold and the workpiece with turnups cladding the lower mold support make a comparatively difficult unloading.

    工件折弯过程中,工件长度尺寸较大且工件上带有翻边时,工件包覆在下架上卸料比较困难

    youdao

  • Conclusion: We use L as arch length and H as chord length to bend syringe needle that is used to posterior superior alveolar nerve block anesthesia by intraoral injection. The success rate is 98%.

    结论槽孔至颧下嵴起始部的弧和弦标准注射针头采用口内注射法进行槽后神经阻滞麻醉成功率为98%。

    youdao

  • Based on construction examples, this paper introduces the calculating method of steel strands length and bend up Angle of skew box girder.

    文章结合施工实例介绍斜交箱梁绞线长度转角计算方法

    youdao

  • Further, a catheter may be configured to have a cross sectional profile or a predefined flexibility along its entire length that causes the catheter to bend, curve or move in a predefined direction.

    而且导管可以配置沿整个长度具有截面轮廓预定柔性从而导致导管预定方向上弯曲卷曲移动

    youdao

  • The cold-bend forming process was studied using energy method and a theoretical length expression of the transition zone of delormation was thus derived.

    采用能量法原理冷弯变形过程进行研究分析,建立了变形过渡区长度理论表达式

    youdao

  • When installing the drain, use an inner diameter of 10 mm above the pipe, the length can not exceed 5 meters, not to bend the pipe up. (Below)

    安装排水管要用内径10毫米以上管子长度不能超过5不要使管子向上弯。(如下图)

    youdao

  • Leather cap type pig has higher abrasion during pigging gas steel pipeline. Furthermore, various elbow bend and tee joint need different suitable length pig or else easy to cause pipeline clog.

    燃气钢质管道管过程中,清管器受到的磨损较大,而且管道中各类弯头三通要求管器长度合适否则容易造成卡堵

    youdao

  • The existing empirical correlation based on straight duct can not predict well the length of shock train in bend duct due to their distinct difference in shock train length.

    另外,鉴于弯曲管道管道内激波长度之间明显差异已有基于直管道的激波串长度经验公式不能很好地适用弯曲管道。

    youdao

  • I never tried to bend-I never did bend, I just suddenly found myself prostrated full length on the ground, with my head on Baba's feet.

    从未试图鞠躬——我没有鞠躬只是突然发现自己整个人趴在地上放在巴巴的脚上。

    youdao

  • The tubular member 12 has a longitudinally extending, cutaway portion 16 defining a bend-enhancing region formed at a predetermined location along a length of the tubular member 12.

    部件12具有纵向延伸缺口部分16,该缺口部分限定沿管状部件12长度预定位置形成的弯曲增强

    youdao

  • The tubular member 12 has a longitudinally extending, cutaway portion 16 defining a bend-enhancing region formed at a predetermined location along a length of the tubular member 12.

    部件12具有纵向延伸缺口部分16,该缺口部分限定沿管状部件12长度预定位置形成的弯曲增强

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定