The bed temperature measurement is crucial for CFB boiler as a result of desulphurization and denitration.
床温测量对于循环流化床(CFB)锅炉至关重要,直接影响炉内脱硫和脱硝。
The co concentration reduces with increase in the bed temperature.
CO排放浓度随床温升高而降低。
The drying rate increases with increasing bed temperature and decreasing product size.
干燥速率随流化床温度的提高和物料尺寸的减小而加快;
The process of dynamic modeling for bed temperature system of CFB boiler is displayed.
根据所提的建模方法对某电厂已投产的一台循环流化床锅炉实际建模。
The control of catalyst bed temperature in a fixed bed reactor during high exothermic reactions is of primary concern to designers.
在强放热反应的固定床催化反应器的设计中,床层温度的控制常成为设计的主要焦点。
The higher the bed temperature, longer the resident time, and stronger the vibration, the more intensive the fragmentation process is.
较高的温度、较长的停留时间、较大的振动强度可以强化碎裂。
The absorption process is a spontaneous endothermic reaction. Accordingly, adequate drop of bed temperature is helpful for the absorption.
吸附过程是自发进行的吸热反应,适当降低床层温度有利于吸附过程。
The effects of bed temperature, input concentration, apparent gas speed, and absorbent grain size on the absorption performance were studied.
考查了床层温度、进料浓度、表观气速和吸附剂粒径对吸附性能的影响。
Powder bed temperature of sintering process should be lower than agglomeration temperature of composite wax powder, which result in dimensional instability.
为了使蜡模获得稳定的尺寸,烧结过程中的粉床温度应尽量低于蜡粉材料的板结温度。
The main steam pressure control system, bed temperature measure system, bed temperature adjust system and action condition of main fuel trip (MFT) are analyzed.
对主蒸汽压力控制系统、床温测量系统、床温校正系统和主燃料跳闸的动作条件进行了详细的分析。
In this thesis, through the analysis on mass balance and energy balance in the dense phase and sparse phase, the bed temperature cybernetic model is established in this thesis.
本文通过对循环流化床锅炉密相区和稀相区的质量平衡与能量平衡的分析,建立了床温控制模型。
The effects of the feed rate of air, steam and coal on bed temperature, gas composition, calorific value, carbon conversion and gasification efficiency are predicted and analyzed with the model.
在此基础上,还就空气加入量、蒸汽加入量及加煤速率对床温、煤气组成、煤气热值、碳转化率和气化效率的影响做了预测和分析。
The results show that the temperature of the smaller char particle is close to the bed temperature, and there also exists a peak value for the burn-out time of char particles versus their diameters.
结果表明:粒径越小,其温度越接近于床内环境温度,而且燃尽时间随粒径变化的曲线将出现峰值。
The results show that the temperature of the smaller char particle is close to the bed temperature, and there also exists a peak value for the burn-out time of char particles versus their diameters.
结果表明:粒径越小,其温度越接近于床内环境温度,而且燃尽时间随粒径变化的曲线将出现峰值。
应用推荐