• The result shows that selection of suitable contact reaction time, filter bed height, and filtering velocity may result in efficient removal of lead and mercury.

    结果表明,选择合理的接触反应时间、滤层高度和滤速能有效去除微污染原水中的铅和汞。

    youdao

  • The influence of pressure, static bed height and fluidized air on the minimum spouting velocity was studied.

    研究了压力、静止床高及流化风对最小喷动速度的影响。

    youdao

  • The experiment shows that the minimum spouting velocity was related to the particle sizes, bed height, and operational temperatures.

    实验表明,双喷嘴矩形喷动床的最小喷动速度与颗粒粒径、床层高度及操作温度有关。

    youdao

  • The effects of fluidization number, injection velocity, particle mean diameter and static bed height on jet fluctuation are discussed.

    研究了流化数、射流初始速度、颗粒平均粒径及静态床层高度对射流脉动特性的影响。

    youdao

  • In the KDF filter, effect of contact reaction time, filter bed height, and filtering velocity on lead and mercury removal was studied.

    以KDF为滤料,研究了接触反应时间、滤层高度和滤速对铅和汞去除效果的影响。

    youdao

  • Meanwhile, the change of the bed height does not affect the critical air velocity when the particle size of arenaceous quartz is fixed.

    而在粒度一定的情况下,床层高度的变化不影响临界流化速度值。

    youdao

  • Even so, the method presented in the paper is a new thought for the detection of CFB boilers' bed height, and has some research values.

    虽然如此,本文提出的方法为循环流化床床高的检测提出了一种新的思路,有一定的研究价值。

    youdao

  • Based on the experimental data, the correlated equation was obtained to estimate accurately the minimum fluidized velocity, solid holdup and bed height.

    试验获得了最小流化速度、固含率和床层高度的关联式,预测值与试验值吻合良好。

    youdao

  • The corresponding static bed height of the biggest spout fluid operating range and the relation between bed pressure drop and spout fluid velocity were determined.

    测定了不同物料最大操作区所对应的静床高及喷动流化气速与床层压降、床层空隙率分布的关系。

    youdao

  • The breakthrough curves in fixed-bed were also carried out on the conditions of the different bed height, different volume flux and different initial concentration.

    采用固定床测定了不同床层高度、不同流量及不同初始浓度下的动态透过曲线;

    youdao

  • All of them are controlled by following factors: discharge ratio, junction Angle, difference in bed height, width to depth ratio and Froude number downstream the confluences.

    影响汇流口的主要控制因素有:汇流比、汇流角、河床高差、宽深比、汇流口下游干流弗劳德数等。

    youdao

  • The probability of the final movement of grain can indicate its movement tendency, and the change of the sand-bed height can reflect the transformation status of grain movement.

    根据最终状态概率代表颗粒运动趋势的原理,砂床高度的变化应是床层表面颗粒运动状态转换的结果。

    youdao

  • Based on a comprehensive consideration of the bed height, and physical properties of air and solid particles, the experiential formula of Reynolds of the rectangular spouted be...

    并在综合考虑床层高度以及气体和固体颗粒的物性的基础上,得出了双喷嘴矩形喷动床最小喷动时雷诺数的经验关联式。

    youdao

  • The height computation model of fluidize-bed showed that the bed height is mainly influenced by catalyst filling amount, linear speed of reaction gas and particle size of catalyst.

    流化床高度计算模型表明,床层高度主要受催化剂装填量、反应气体线速和催化剂粒度的影响。

    youdao

  • The variation of gas holdup with gas velocity, column diameter, solid concentration, static bed height and gas distributor was studied in slurry bubble columns with three different diameters.

    用三种不同直径的浆态鼓泡塔研究气速、塔径、固相浓度、静止床层高度和气体分布器等对气含率的影响。

    youdao

  • With increase of bed height, air pressure and power consumption rise, expansion ratio of the bed decreases, but the density stability and critical fluidized velocity of the bed are hardly changed.

    随着床层高度的增加,所需风压及功率增大,膨胀率有所降低,而床层密度的稳定性和起始流化气速几乎不变。

    youdao

  • With increase of bed height, air pressure and power consumption rise, expansion ratio of the bed decreases, but the density stability and critical fluidized velocity of the bed are hardly changed.

    随着床层高度的增加,所需风压及功率增大,膨胀率有所降低,而床层密度的稳定性和起始流化气速几乎不变。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定