波特 38400
Most computers are set to a default of 9600 baud, so this might not be an issue.
多数计算机默认设置为 9600波特,所以这可能不是个问题。
In the case of the UART, there's not a lot to configure apart from the baud rate and framing details.
对于UART来说,除了波特率和帧细节外没有太多属性要配置。
代码中单片机的波特率设置为4800。
The resulting transfer rate is 110 baud.
最终的传输速率是110波特。
This capacitance restricts the baud rate.
这电容限制波特率。
Print through the serial port baud rate 115200.
通过串口打印,波特率115200。
Defines baud rate used for ring communications.
定义环行通讯的比特率。
What baud rate, or range of baud rates, is supported.
是否支持波特率或波特率的范围?
You need to use computer software debugging port. 9600 baud rate.
需用电脑串口软件调试。波特率9600。
There are constraints on the CPU clock speed related to the baud rate.
波特率会对CPU时钟速度产生限制。
Class using the specified port name baud rate parity bit data bits and stop bit.
使用指定的端口名称、波特率、奇偶校验位、数据位和停止位初始化。
Send and receive news : you can set ports, baud rate , parity and other parameters.
通过设置发送并接收消息:可以设置端口,波特率,奇偶校验等参数。
The error of baud rate setting is a very important parameter in serial communication.
波特率设置的误差是串行通讯中一个非常重要的参数。
My first modem collected data at a brisk 300 baud, later upgraded to a sizzling 1,200.
我的第1只调制解调器接收数据的速度只有300波特,后来我把它升级到1200波特。
This was back when you interacted with computers using 300 baud modems, teletypes, and paper tape.
在那个时候,你通过300波特调制解调器、电传打字机和纸带机和计算机进行交互。
Baud: The rate at which data is received or transmitted in serial: one baud is one bit per second.
波特:连续接收和传输数据的速率;一波特定义为每秒一个比特。
In this method, the data style and baud rate are selected by software, and the application is quite easy.
在这种方法中,数据的格式、波特率的选择都是通过软件来实现的,应用十分方便。
This modulation rate of data transmission is expressed as 12,800 baud (Bd), representing 12,800 bits per second.
这种数据传输调制频率用12800波特(Bd)来表示,指的是每秒钟12800位。
One-fourth the rated speed of the associated equipment ; in transoceanic telegraph, one-fourth of full speed or 12.5 baud or 16 + wpm.
有关设备额定速度的四分之一;在越洋电报中,指四分之一全速或12.5波特或每分钟16字。
To get a desired baud rate, write the corresponding value to the Port $7024H and $7025H according to the following Baud Rate equation.
为了得到一个所要求的波特率,需要向$7024H和$7025H端口写入一个合适的值,这个值根据下面的波特率等式得出。
If the debug session is conducted remotely, the CDT initiates communication by sending a remotebaud command to GDB, followed by the baud rate.
如果远程执行调试会话,CDT通过向gdb发送remotebaud命令(后跟波特率)发起通信。
To register online, you need a modem with an operating speed of at least 2400 baud. Do you have a faster modem that you would like to install now?
要联机注册,需要一个运行速度至少2400波特的调制解调器。现在要安装速度更快的调制解调器吗?
Finally, the thesis proposes several newly adaptive technologies, like the estimation of baud rate and SNR. And corresponding improvements are also discussed.
最后,论文提出了一些新的自适应技术,如波特率估计、信噪比估计等,并给出了应用这些技术的自适应调制解调器的改进方案。
Standard 485 communication interface, built-in decoder board (pre-digital decoders optional) to support a variety of mainstream protocol, baud rate adjustable.
标准485通讯接口,内置解码板(预置位解码板选配)支持多种主流协议,波特率可调。
The communication of serial interface has been analysed simply, and the paper introduces how to realize special baud rate by using the PComm communication Library.
简单分析Windows下串口通信方式,详细介绍了使用串口通讯库pcomm实现特殊波特率的方法。
Firstly, the error source of baud rate and the allowable baud rate error are analyzed with the example of MCS-51. Then a method of baud rate autoregulation is presented.
首先以MCS - 51为例,分析了波特率的误差源和允许的波特率误差,然后介绍了一种自动调整波特率的方法。
Firstly, the error source of baud rate and the allowable baud rate error are analyzed with the example of MCS-51. Then a method of baud rate autoregulation is presented.
首先以MCS - 51为例,分析了波特率的误差源和允许的波特率误差,然后介绍了一种自动调整波特率的方法。
应用推荐