• These bearings are used to support combined radial and axial loads with the radial load prevailing.

    这种轴承主要用来承受以径向负荷为主的径向与轴向联合的负荷。

    youdao

  • Carrying axial loads in both directions.

    携带两个方向的轴向载荷。

    youdao

  • Therefore, these bearings are capable of transmitting high axial loads in both directions.

    因此,这些轴承都能够在两个方向上传输高的轴向载荷。

    youdao

  • The radial and axial loads affect the ball contact angles relating to the bearing failure.

    径向载荷和轴向载荷对接触角的变化影响较大,直接关系到滚珠轴承的失效情况;

    youdao

  • Common causes of bearing failure are shock, vibration, and excessive radial and axial loads.

    让轴承失效通常的因素有冲击、振动以及过度的径向和轴向的负载。

    youdao

  • This class will be mainly used for withstanding radial bearing load, can withstand certain axial loads.

    该类轴承主要用以承受径向负荷,也可承受一定的轴向负荷。

    youdao

  • Bearings shall be specifically selected to carry all radial and axial loads imposed by the pump and motor.

    这些轴承都是经过特别挑选,能够承担油泵和电机产生的径向和轴向负载。

    youdao

  • The full-range curve of reinforced concrete members with flexure and axial loads is obtained by finite element method.

    用有限元法对钢筋混凝土压弯构件进行了荷载一位移曲线的全过程分析。

    youdao

  • The design of these wall frames does not utilise the full strengthening effects of the plasterboard in carrying the axial loads.

    在这些墙架的设计中没有利用石膏板在承担轴向荷载方面的增强效应。

    youdao

  • The elastoplastic bending instability of the tapered compression members under axial loads about the weak axis is mainly studied.

    主要研究了楔形变截面压杆绕弱轴的弹塑性弯曲失稳。

    youdao

  • Tapered roller bearings for machine tools can be both radial and axial loads, double row tapered roller bearings can withstand two-way axial load.

    机床用圆锥滚子轴承可同时承受径向和轴向载荷,双列圆锥滚子轴承可承受双向轴向载荷。

    youdao

  • Due to their contact Angle, single-row angular contact ball bearings are better suited to sustaining high axial loads than deep-groove ball bearings.

    由于其接触角,单列角接触球轴承比深沟球轴承更适合维持高轴向负荷。

    youdao

  • The full-scale tests are carried out in this research for the wall-stud structures with C-type cross section stud which subject to centric axial loads.

    本文对无支撑、钢带支撑、槽钢支撑和十字交叉钢带支撑的C型截面柱的墙柱骨架进行了在轴心压力作用下的足尺试验。

    youdao

  • The thrust bearings are capable only to sustain the axial loads, with low limit speed. They have two stress modes, I. E. One-way thrust and two-way thrust.

    推力轴承只能承受轴向负荷,极限转速低。有单向推力和双向推力两种受力方式。

    youdao

  • ResultsIn case of various axial loads and mass ratios, various curves between dimensionless fluid flow velocity and dimensionless complex frequency are plotted.

    结果得出了不同轴向载荷和不同质量比下的无量纲流速与无量纲频率的关系曲线。

    youdao

  • The buckling of large vertical cylindrical shells with welds subjected to local thermal action and axial loads was studied with numerical method by using ANSYS code.

    对大型直立设备安装过程中的现场焊接热处理过程中在轴向载荷和局部热载荷共同作用下的屈曲问题进行数值研究。

    youdao

  • Combined needle roller bearings consist of a radial needle roller bearing combined with a thrust bearing and are consequently able to take up both radial and axial loads.

    组合式滚针轴承是由一个向心滚针轴承和一个推力轴承相结合,因此能够承受径向和轴向负荷。

    youdao

  • The stress distribution and the stress concentration factor in the welding region of tubular TT-joints subjected to axial loads are analyzed using finite element method in this study.

    本文首先通过有限元分析得到了轴力作用下的TT管节点在焊接区的应力分布以及应力集中系数。

    youdao

  • Most bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.

    大多数轴承都支承径向或轴向负荷的转轴。

    youdao

  • Most bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.

    大多数轴承都支承径向或轴向负荷的转轴。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定