At the same time bathing, avoid high temperature and the use of alkaline detergents containing soap and bath products.
同时沐浴时，避免水温过高以及使用含有碱性清洁剂的香皂和沐浴产品。
Store&shippmeng:store in cool place, avoid high temperature, taking away from fire and profibit to store with oxidant agent.
储运：宜存放阴凉处，避免高温，不可近火，勿与氧化剂共储运。
Therefore, it is suggested that the majority of consumers in the charging process must pay attention to avoid high temperature and excessive charging.
因此，建议广大消费者在充电过程中一定要注意避免高温和过度充电。
Hearing aid placed in a drying box night, don't put it in direct sunlight, should avoid high temperature, high humidity environment, try to avoid collision.
晚上把助听器放在装有干燥剂的盒子里，不要将其放在阳光直射的地方，应避开高温、高湿环境，尽量避免摔碰。
The effective factor experiments indicated that breviscapine dry suspension must avoid high temperature, high humidity during preparation, preservation and transportation.
影响因素试验表明，灯盏花素干混悬剂在制备、储存和运输过程中要避免高温、潮湿的环境。
Avoid operate or reserve in the room with high air pressure, humidity and temperature out of the required standard, airless, or the objects of flammable, explosive, corrosive materials.
避免在气压过大，湿度、温度超出规定标准，通风不良，或有易燃、易爆、强腐蚀性物品的场所使用、贮存。
Considering the high temperature of welder, never place any material on the welder so as to avoid fire.
鉴于机器温度很高，不要放置任何材料在机器上，以避免引发火灾。
It is impossible to avoid noise at high temperature, so different mathematic methods, such as Savitzky-Golay method, FFT and wavelet methods have been adopted for denoising.
由于高温噪声的不可避免，采用了移动平均方法，傅里叶变换滤波和小波分析的方法对其进行了数据降噪处理。
Storage: avoid storing the loader in high temperature, heavy wet and dusty place.
储存：机芯应避免储存在高温，潮湿，灰尘多的地方。
The use of cryogenic nitrogen gas jet to reduce the temperature of cutting zone and to avoid oxidation wear of tool in high speed milling titanium alloy was presented.
为降低切削区温度、防止刀具的氧化磨损，提出在低温氮气射流条件下进行钛合金的高速铣削加工。
Keep away from corrosive chemical, fire and high temperature, hard or sharp objects to avoid any damage.
避免接触有腐蚀性的化学物品，切勿近火或高温烘烤，避免接触硬、尖物，以免损坏；
Avoid putting it under damp or high temperature conditions.
避免放置于潮湿或高温条件下。
No light pollution, high illuminant efficiency, low temperature design, avoiding equipment aging avoid brightness reduce, life loss, mass maintenance task and other problems.
无光污染、无高温、发光效率高，从而避免由于高温而导致设备老化、亮度降低、寿命缩短、维护量大等问题。
The construction environment of the bottom coating is as follows: the construction temperature can not be too high, so as to avoid the organic solvent before the construction of volatile.
底涂料的施工环境如下：施工温度不能太高，以免有机溶剂在施工前就挥发完了。
To avoid direct sunlight and high temperature; placed in dry and ventilated place; transported as non-dangerous goods.
避阳光直晒及高温，放置于阴凉通风处；按非危险货物运输。
However, the preheating temperature should not be too high, so as to avoid matrix effects of surface oxidation and surface coating and the substrate bonding strength.
但预热温度不宜过高，以免引起基体表面氧化而影响涂层与基体表面的结合强度。
For your safety, never approach turning parts, such as fan, belt to avoid cutting, high temperature parts as exhaust pipe, turbo-charger, muffler and radiator to avoid burn when engine is running.
为了您的安全，柴油机在运转时禁止靠近风扇、皮带等旋转部位以免打伤，排气管、增压器、消声器、散热器等高温部位在靠近时防止烫伤。
Article 5: the daily use, don't will set temperature too low, in order to avoid air conditioner in high speed running state and long-term affect service life.
第五条：日常使用时，不要将温度设置得过低，以免空调器长期处于高速运行状态而影响使用寿命。
A layer of paraffin is covered on the high-temperature phosphating solution, so that the paraffin can effectively avoid the steam loss and has heat-preservation function for the phosphating solution.
在高温磷化液上覆盖一层石蜡，可以有效避免蒸汽损失，同时对磷化液还起到一定的保温作用。
Store away from direct sunlight and avoid the high temperature, after opening please refrigerate and finish using the product within three days.
保存方法：勿日光直射，避高温。开封后请冷藏，并请于三日内食用完毕。
Do not place a soldering iron near or on the body of the capacitor to avoid the sleeves of the capacitors deforming and cracking under high temperature.
使用电烙铁焊锡时，电烙铁请勿靠近或接触电容器本体，以免因高温而使电容器之塑胶套管变形或破裂。
The coal washing plant steam boiler with high and new technology can effectively avoid the back wall by high temperature gas scour damage, safe and reliable to use.
水洗厂燃煤蒸汽锅炉用了高新技术可以有效的避免后墙受高温烟气冲刷破损，使用起来安全可靠。
In the real bake-out process, it suggests that the air excess coefficient of burning should be controlled within 1 in order to avoid electrode being oxidized by high temperature fume;
在实际焙烧过程中，为了减少高温烟气对电极的氧化，建议燃烧的空气过剩系数控制在1以下；
3 shoes if wet, to maintain the appearance of the fortress newspaper shoes, shoes and let the natural air dry, avoid direct sunlight or high temperature baking.
鞋子若打湿，要塞报纸以维持鞋子之外观，且让鞋子自然风干，避免日光直射或高温烘烤。
3 shoes if wet, to maintain the appearance of the fortress newspaper shoes, shoes and let the natural air dry, avoid direct sunlight or high temperature baking.
鞋子若打湿，要塞报纸以维持鞋子之外观，且让鞋子自然风干，避免日光直射或高温烘烤。
应用推荐