• A power index model is formed which describes the relation of drum brake average torque with speed and pressure.

    建立了某型号鼓制动器平均制动力矩速度压力指数模型

    youdao

  • We usually take the coefficient 1.25 times the average torque as the low frequency maximum torque to calculate the low frequency braking voltage.

    矿井提升绞车在计算低频制动电压时,通常采用低频最大力矩平均力矩1.25折算系数

    youdao

  • After analysis of measurement data, a power index model is formed which describes the relation of drum brake average torque with speed and pressure.

    利用测得数据,建立了某型号鼓制动器平均制动力矩速度压力指数模型

    youdao

  • A control strategy of average levitated force and average torque is designed based on principles of radial force generation and mathematical models.

    根据无轴承开关磁阻电机悬浮原理数学模型设计平均悬浮和平均转矩控制策略

    youdao

  • However some problems such as torque ripple increasing and average torque descending can be caused by phase commutation of the motor and may get even worse with the speed increasing.

    永磁无刷直流电机具有结构简单、转显著优点,然而电机过程引起转矩波动增大平均转矩下降许多问题,随着电机速度的增加,这些问题变得更为突出。

    youdao

  • To overcome the disadvantage of higher torque ripple in switched reluctance motor (SRM) based on average torque control technique, one method of instantaneous torque control is presented.

    针对平均控制开关磁阻电动机(SRM)转矩脉动大的问题,提出瞬时转矩控制的方案。

    youdao

  • To overcome the disadvantage of solving torque ripple of switched reluctance motor based on average torque control method, in this paper a new one called transient torque control is presented.

    针对平均控制开关磁阻电机转矩脉动存在不足提出了基于瞬时转矩控制的转矩脉动最小化方案。

    youdao

  • Walking in high heels increased the normal torque forces at the knee by an average of 23%, which imposed a greater stretching force through the lateral knee ligaments.

    穿高跟鞋膝关节承受的压力平均增加了23%,膝盖韧带外侧承受了大的压力

    youdao

  • The research results show that the average axial cutting force and torque of common drill-grinding are greater than that of ultrasonic drill-grinding.

    得出普通钻磨时平均切削平均扭矩均远大于超声钻磨加工时的轴向平均切削力和平均扭矩;

    youdao

  • The research results show that the average axial cutting force and torque of common drill-grinding are greater than that of ultrasonic drill-grinding.

    得出普通钻磨时平均切削平均扭矩均远大于超声钻磨加工时的轴向平均切削力和平均扭矩;

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定